# Draw the symbol, logic expression and truth table of NOR gate.

5 views
Draw the symbol, logic expression and truth table of NOR gate.

symbol, logic expression and truth table of NOR gate

## Related questions

Draw logic diagram of T flip-flop and give its truth table.

The sum of product expression for a Boolean function can be derived from its truth table by (a) AND operation of the product terms. (b) NOR operation of the product terms. (c) OR operation of the product terms. (d) NAND operation of the product terms.

Draw the symbol of LED & photodiode.

A NOR gate is equivalent to a bubbled AND gate. This statement is an outcome of: (1) De Morgan’s Law (2) Involution Law (3) Law of Absorption (4) Idempotent Law

What is photodiode? Draw the symbol and explain operation of photodiode.

Draw the symbol and state the applications of : 1) Push button switch 2) Selector switch 3) Solenoid valve 4) Limit switch

Draw the circuit diagram of bridge rectifier with π filter. Draw its input and output waveform.

Draw the block diagram of regulated DC power supply and explain the function of each block.

Explain Center-tapped full wave rectifier with the help of circuit diagram and draw input output waveforms.

The output of an exclusive–NOR gate is 1. Which input combination is correct? (1) A = 1, B = 0 (2) A = 0, B = 1 (3) A = 0, B = 0 (4) None of these

Draw symbol of LED and explain it’s working principle.

Define 'Ideal voltage source' and 'Practical voltage source'. Draw the symbol for each.

Draw output characteristics of common emitter [CE] configuration and explain active, saturation and cut-off regions in detail.

How many minimum number of NOR gates are required to realize a two-input X-OR gate?

Draw block diagram of IC 723. Write the functions of IC 723.

The output of logic gate is '1' when all its inputs are at logic '0' The gate is (A) NAND/EX-OR (B) NOR/EX-OR (C) AND/EX-NOR (D) NOR/EX-NOR

The basic logic gate whose output is the complement of the input is the: - a) OR gate b) AND gate c) inverter d) comparator

What is the propagation delay of a logic gate?

Draw the block diagram of Programmable Logic Array.

Read the following statements: i. Gate is a combinational logic. ii. JK Flip-flop in toggle mode is not combinational logic. iii. MSJK Flip-flop suffers from race-around. iv. Counters are sequential circuits. Which choice is correct? (A) i, ii (B) i, ii, iv (C) ii, iii, iv (D) i, ii, iii

A radio receiver is placed at one corner of a table and again placed at some other corner of the same table. Loudspeaker output is changed because  (a) image interference is reduced (b) adjacent channel interference is increased (c) of fading (d) line of sight propagation is not utilized

For the circuit shown in figure, the Boolean expression for the output y in terms of inputs P, Q, R and S is

When A = 0., B = 0, C = 1 then in two input logic gate we get gate  (A) XOR gate (B) AND gate (C) NAND gate (D) NOR gate

List the applications of RC oscillator and crystal oscillator.

Differentiate between positive and negative feedback on the basis of . (i) overall phase shift (ii) voltage gain (iii) stability (iv) applications

Write simple example of Boolean expression for SOP and POS.

Explain Faraday’s second law of electrolysis and give its expression.

In an unclocked R-S flip flop made of NOR gates, the forbidden input condition is:  (1) R=0, S=0 (2) R=1, S=0 (3) R=0, S=1 (4) R=1, S=1

Explain how a Programmable Logic Controller (PLC) is different from an ordinary personal computer. Also write the advantages and disadvantages of PLC.

The requirement of the gate drive circuits for power MOSFET and IGBT is (a) high source capability (b) high sink capability (c) both (a) and (b) (d) high voltage capability

A resistor connected across the gate and cathode of an SCR in a circuit increases its (A) dv/dt rating (B) Holding current (C) Noise Immunity (D) Turn-off time

The output of an AND gate with three inputs, A, B and C, is HIGH when __________. a) A=1,B=1,C=0 b) A= 0,B= 0,C= 0 ' c) A=1,B=1,C=1 d) A=1,B= 0,C= 1

Define quality factor for parallel resonance and write its mathematical expression.

If the number of conditions in a decision table is n, the maximum number of rules (columns) possible is  A) n B) 2n C) 2n D) log2n

Electrical quantities (symbol and basic unit)

Define photo resistor. State its symbol and its two applications.

The frequency (fr) of the rotor current in an induction motor is given by the expression (s = slip, f = supply frequency)

Which among the following is the dual of Boolean expression X+YZ=(X+Y) (X+Z)?  (A) X(Y+Z)=XY+YZ (B) X.(Y+Z)=X.Y+X.Z (C) X+(Y+Z) = X.Y+Z (D) X+(YZ) = X+Y+Z

Define rectifier and list its types.

Draw sinusoidal waveform of 3 phase emf and indicate the phase sequence.

Draw B-H curve for magnetic material and state its nature. State the significance of hysteresis loop. Also draw the hysteresis loop for hard steel and soft steel.

Draw and explain the measurement of torque using Torque Cell

Draw and explain the working of Schmitt trigger.