# Draw a circuit diagram of R.C. series circuit. Draw impedance triangle and power triangle for same circuit.

28 views
Draw a circuit diagram of R.C. series circuit. Draw impedance triangle and power triangle for same circuit.

Draw a circuit diagram of R.C. series circuit. Draw impedance triangle and power triangle for same circuit.

## Related questions

Draw impedance triangle and voltage triangle for RL series circuit

For a series R -C circuit, the power factor corresponding to maximum power is (a) 0-5 lag (b) 0.5 lead (c) 0.707 lag (d) 0-707 lead

Draw and explain the control and power diagram for D.C. injection Braking.

A series R-L-C Circuit has a resonant frequency of 1000 Hz. If the values of R, L and C are doubled, the new resonant frequency is

A series RLC circuit has a resonant frequency of 1 KHz and a quality factor Q = 100. If each of the R,L and C is doubled from its original value, the new Q of the circuit is:  (1) 25 (2) 50 (3) 100 (4) 200

Draw the power and control circuit diagram for forward — stop — Reverse type DOL starter for 3 phase induction motor.

Draw a neat labeled diagram of Automatic Weight Tensioning and Temperature Compensation and give any two advantages of the same.

An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when A) ZL = R B) ZL = jXS C) ZL = R-jXS D) ZL = R+jXS

For a resonant circuit with resonant frequency of 1 MHz a, 0 = 50 and R = 400, find the value of C (A) 250 pF (B) 1000 pF (C) 1.25 pF (D) 500 pF

Draw neat labeled diagram of single phase AC locomotive showing its various equipments of power circuit and give function of each equipment used in power circuit.

In an ac series RLC circuit, the voltage across R and L is 20 V; voltage across L and C is 9 V and voltage across RLC is 15 V. What is the voltage across C?

A series R-L circuit is suddenly connected to d.c. voltage source of V volts. The current in this series circuit, just after the switch is closed, is equal to (1) Zero (2) V/L (3) V/C (4) V.L/C

The time constant of a series R-C circuit is given by?

In a circuit containing R, L and C, power loss can take place in?

Draw the block diagram for PLC power supply and explain the function of each block.

A parallel combination of capacitance C and resistance R is connected in series with inductance L and small resistance r. Under what condition will the circuit be non-reactive?  (A) C=LR (B) C=LR2 (C) C=L/R2 (D) C=L/R

Draw the circuit diagram for AND and OR gates using diodes.

Draw the circuit diagram for Instrumentation amplifier using three OP-AMPs. State its advantages and applications.

In a series R-C circuit, with the increase in frequency, current (A) Reduces (B) Increases (C) Does not change (D) Becomes zero

At very low frequencies a series R-C circuit behaves as almost purely?

In R-L-C series resonant circuit magnitude of resonance frequency can be changed by changing the value of?

If resistance is 20 Q. and inductance is 27 in a R-L series circuit, then time constant of this circuit will be?

Draw power and control circuit for simple plugging of induction motor.

Describe with neat circuit diagram the method of measurement of power in a High voltage, high current a.c circuit.

Draw a neat labeled diagram to show protective system for AC traction and give the function of each relay used in it.

What is the RMS voltage in a series RL circuit, if the voltage across R and L is 256 V and 192 V respectively? A) 320 V B) 448 V C) 64 V D) None of these

Draw the circuit diagram of bridge rectifier with π filter. Draw its input and output waveform.

Explain Center-tapped full wave rectifier with the help of circuit diagram and draw input output waveforms.

State the need of cascade amplifier and draw circuit diagram of 2-stage direct coupled amplifier.

Draw the circuit diagram of crystal oscillator and explain its working.

Draw power and control circuit for definite time-limit starter for slip-ring induction motor. Explain its working.

Draw the power and control circuit for motors using autotransformer type starter.

Draw the block diagram of regulated DC power supply and explain the function of each block.

Draw and explain power flow diagram of induction motor.

When a resistor R is connected to a current source, it consumes a power of 18 W. When the same R is connected to a voltage source having the same magnitude as the current source, the power absorbed by R is 4.5 W. The magnitude of the current source and the value of R are  (A) √18A and 1Ω (B) 3A and 2Ω (C) 1A and 18Ω (D) 6A and 0.5Ω

A ramp voltage V(t)=100 V is applied to an RC differentiating circuit with R=5 kΩ and C=4 μF. The maximum output voltage is  (A) 0.2 V (B) 2 V (C) 10 V (D) 50 V

How range of A.C. ammeter & A.C. voltmeter is extended? Draw suitable diagram.

Define active power and reactive power for RLC series circuit.

For a series resonant circuit, at the half power points,which of the following is true?  (a) Current is half of the current at resonance. (b) Resistance is equal to the reactance. (c) The impedance is half the impedance at the resonance. (d) None of the above

In a series resonant circuit, the impedance of the circuit is?

Draw and explain Hartley Oscillator circuit diagram.

Sketch pin configuration of IC 723. State functions of each pin. Sketch circuit diagram for obtaining 6V output d.c. regulated voltage using IC 723.