5 views
in Instrumentation and control by
 Thermocouples are_____ transducer whereas thermistor are_____ transducer. a) passive, active b) active, passive c) active, active d) passive, passive

Your answer

Thanks for your contribution. Feel free to answer this question. Please avoid short answer. Your answer is most welcome. Be genuine.

Upload image or document:

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
Are you a robot ? (Y = Yes / N = No)
To avoid this verification in future, please log in or register.

1 Answer

0 votes
by

 Thermocouples are active transducer whereas thermistor are active transducer. 

Related questions

1 answer 11 views

A thermistor is generally a semiconductor material exhibits: a) Positive Temperature co -efficient b) Negative Temperature co -efficient c) Neither positive nor negative temperature co -efficient d) both (a) and (b)

asked Apr 14, 2018 in Instrumentation and control by Shimroz123
1 answer 14 views

The following should be considered while selection a transducer: -  a) Sensitivity b) Operating Range c) Frequency Response d) All the above

asked Apr 10, 2018 in Instrumentation and control by Shimroz123
1 answer 10 views

One of the following in an active transducer : -  a) Strain gauge b) LVDT c) Photo colt aoc cell d) Photo emissive cell

asked Apr 10, 2018 in Instrumentation and control by Shimroz123
1 answer 8 views

A transducer converts : -  a) mechanical energy into electrical energy b) mechanical displacement into electrical signal c) one form of energy into another form of energy d) electrical energy to mechanical energy

asked Apr 10, 2018 in Instrumentation and control by Shimroz123
1 answer 17 views

Variable resistors are_____. A. Wire wound resistors B. Thin film resistors C. Thick film resistors D. All of the above.

asked Apr 12, 2018 in Electrical Engineering by Shimroz123
2 answers 9 views

State Seeback effect and Peltier effect. Write material used in different thermocouples.

asked Sep 10, 2018 by Shimroz123
1 answer 12 views

True value has been 50 whereas measured value is 40 then the percentage error in the reading will be ______.  (A) 20% (B) 40% (C) 50% (D) 30%

asked May 8, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 40 views

Two waves have frequency of 500 Hz. One is set at its maximum value whereas the other at zero. The phase angle between them will be

asked Apr 26, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 34 views

Explain working of thermistor. State any two applications of thermistor.

asked Sep 14, 2018 by Shimroz123
1 answer 13 views

Describe the instrumentation system used for temperature measurement using thermistor.

asked Sep 13, 2018 by Shimroz123
1 answer 30 views

Compare NTC and PTC thermistor

asked Sep 13, 2018 by Shimroz123
2 answers 4 views

Compare RTD and Thermistor

asked Sep 13, 2018 by Shimroz123
1 answer 14 views

Compare RTD and thermistor on the basis of temperature coefficient , linearity, temperature range and cost.

asked Sep 9, 2018 by Shimroz123
1 answer 6 views

Compare thermo- couple and thermistor.

asked Sep 9, 2018 by Shimroz123
1 answer 12 views

A thermistor is a type of? A.switch B.resistor C.battery D.power supply

asked May 15, 2018 in Basic concepts by Shimroz123
1 answer 26 views

 A thermistor has?

asked Mar 25, 2018 in Basic concepts by Shimroz123
2 answers 40 views

Classify transducer. Write one sentence about each of them.

asked Sep 14, 2018 by Shimroz123
1 answer 10 views

Explain how AC current is measured using hall effect transducer. 

asked Sep 13, 2018 by Shimroz123
1 answer 7 views

Discuss any 4 points to be considered while selecting a transducer for its intended applications. 

asked Sep 13, 2018 by Shimroz123
1 answer 4 views

Define the term Transducer and sensor.

asked Sep 13, 2018 by Shimroz123
1 answer 9 views

Explain in brief AC Current , RMS Indication using Hall Effect Transducer.

asked Sep 13, 2018 by Shimroz123
1 answer 27 views

Draw and explain in brief speed measurement using non-contact type transducer. 

asked Sep 13, 2018 by Shimroz123
1 answer 16 views

Draw and explain the operation of pressure transducer having diaphragm as a primary sensor and four strain gauges as secondary sensors.

asked Sep 13, 2018 by Shimroz123
1 answer 11 views

List any six criteria for selecting a proper transducer for an application.

asked Sep 13, 2018 by Shimroz123
2 answers 8 views

State Hall effect. Explain in brief operation of hall effect transducer with its suitable applications.

asked Sep 13, 2018 by Shimroz123
1 answer 0 views

State two examples of active transducer.

asked Sep 12, 2018 by Shimroz123
1 answer 7 views

State two examples of passive transducer.

asked Sep 12, 2018 by Shimroz123
1 answer 9 views

Compare primary and secondary transducer (any two points).

asked Sep 12, 2018 by Shimroz123
1 answer 7 views

List non contact type transducer and compare them on the basis of any two factors.

asked Sep 12, 2018 by Shimroz123
1 answer 11 views

List two advantages and disadvantages of photoelectric pickup transducer.

asked Sep 12, 2018 by Shimroz123
1 answer 5 views

State selection criteria of transducer.

asked Sep 12, 2018 by Shimroz123
1 answer 5 views

Classify transducer in detail.

asked Sep 12, 2018 by Shimroz123
2 answers 5 views

Compare active and passive transducer.

asked Sep 9, 2018 by Shimroz123
1 answer 9 views

State the necessity of transducer.

asked Sep 8, 2018 by Shimroz123
1 answer 4 views

List four electric pressure transducer.

asked Sep 8, 2018 by Shimroz123
3 answers 10 views

Define transducer. Give two examples.

asked Sep 8, 2018 by Shimroz123
1 answer 19 views

 If the range of an analog transducer is 0 to 10 V, then for a resolution of 5 mV, the bits of ADC will be _____.

asked May 29, 2018 in Transducers and sensors by Shimroz123
1 answer 7 views

Following transducer is an active transducer: (1) Carbon Microphone (2) Piezoelectric Microphone (3) LVDT (4) Strain Gauge 

asked May 29, 2018 in Transducers and sensors by Shimroz123
1 answer 48 views

Which one of the following is not a transducer in the true sense?   (A) Thermocouple (B) Piezoelectric pick-up (C) Photo voltaic cell (D) LCD.

asked May 17, 2018 in Transducers and sensors by Shimroz123
1 answer 18 views

Piezoelectric Transducer is used to measure  (1) displacement (2) resistance (3) current (4) temperature

asked Apr 29, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 16 views

The transducer with negative temperature co-efficient of resistance is (A) Thermistor (B) Resistance Thermometer (C) Strain Gauge (D) Thermocouple

asked Apr 25, 2018 in Electrical Measurements and Instrumentation by Shimroz123
0 answers 8 views

Which transducer has very nonlinear and high temperature co-efficient characteristics ? (a) thermistor (c) pyrometer (b) thermocouple (d) thermometer

asked Apr 14, 2018 in Electrical Engineering by Shimroz123
0 answers 22 views

The dynamic characteristics of capacitive transducer are similar to those of   (a) Low-pass filter (b) High-pass filter (c) Notch filter (d) Band-stop filter 

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
0 answers 13 views

A strain gauge is a passive transducer and is employed for converting   (a) Pressure into change in resistance (b) Force into displacement (c) Mechanical displacement into a change of resistance (d) None of the above 

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
0 answers 13 views

An inverse transducer converts   (a) electrical energy to any other form of energy (b) electrical energy to light energy (c) mechanical displacement into electrical signal (d) electrical energy to mechanical form  

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
0 answers 13 views

Transducer is a device which  (a) converts one form of power in to the other (b) is similar to transformer (c) converts one form of energy in to other (d) helps in measuring electricity

asked Apr 9, 2018 in Electrical Engineering by Shimroz123
0 answers 23 views

In the selenium cell photovoltaic transducer, relative spectral sensitivity maximum occurs in the wavelength (in nm) of about  A) 300 B) 350 C) 460 D) 550 

asked Apr 7, 2018 in Electronics Engineering by Shimroz123
0 answers 405 views

What is the difference between a sensor and a transducer?

asked Mar 11, 2018 in Transducers and sensors by Quiz
0 answers 15 views

What is the role of a transducer?

asked Mar 11, 2018 in Transducers and sensors by Quiz

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units

8,530 questions

7,129 answers

135 comments

3,090 users

...