# The polarity of induced voltage while a field is collapsing is : -

12 views
The polarity of induced voltage while a field is collapsing is : - a) independent of the force creating the field b) opposite to the force creating c) the field identical to the force creating d) the field present only if the force is stationary

The polarity of induced voltage while a field is collapsing is : - opposite to the force creating

## Related questions

The induced voltage across a coil with 250 turns that is located in a magnetic field and is changing at a rate of 8 Wb/s is A. 1,000 V B. 2,000 V C.31.25 V D. 3,125 V

To determine the polarity of the voltage drop across a resistor, it is necessary to know?

Which of the following quantity maintains the same direction whether a D.C. machine runs as a generator or as a motor a. Induced e.m.f. b. Armature Current c. Field Current d. Supply Current

What is the direction of the induced electric field?

A dc chopper is fed from a constant voltage mains the duty ratio of chopper is progressively increased while the chopper feeds an RL load. The per unit current ripple would  (1) increase progressively  (2) decrease progressively  (3) decrease to a minimum value at α = 0.5 and then increase  (4) increase to a maximum value at α = 0.5 and then decrease

The following should be considered while selection a transducer: -  a) Sensitivity b) Operating Range c) Frequency Response d) All the above

The voltage induced across a certain coil is 200 mV. A 1200 resistor is connected to the coil terminals. The induced current will be: A. 1.7 mA B. 16 mA C. 12 mA D. 120 mA

The potential coil of a single phase dynamometer wattmeter has 4840 Ohm resistance. Voltage across the load is 220 V. With the potential coil connected on the load side, the meter indicates 100 W. Approximate percentage error due to wattmeter connection is (A) 11% (B) 9% (C) 1.1% (D) 3%

If a positively charged body is placed inside a spherical hollow conductor, what will be the polarity of charge inside and outside the hollow conductor ? (a) Inside positive, outside negative (b) Inside negative, outside positive (c) Both negative (d) Both positive

“In all cases of electromagnetic induction, an induced voltage will cause a current to flow in a closed circuit in such a direction that the magnetic field which is caused by that current will oppose the change that produces the current” is the original statement of

Tachometer works essentially as a generator with output voltage proportional to magnitude of the : - a) Angular Velocity of the shaft b) Torque of the shaft c) Temperature of the shaft d) Back Lash of the shaft

The input voltage to an OP AMP is a large voltage step. The output is an exponential waveform that changes to 0.25 V in 0.1µs (microsecond). The slew rate of the OP AMP is : -  a) 5V/µs b) 2.5 V/ µs c) 3V/µs d) 4.5V/ µs

The voltage regulation of an alternator having 0.75 leading p.f. load, no-load induced e.m.f. of 2400V and rated terminal voltage of 3000V is —————————————  A) 20% B) —20% C) 150 D) -26.7

How can we protect circuit from reverse voltage polarity?

If stator field is rotating in clockwise direction rotor rotates in (A) any direction (B) cannot predict (C) anticlockwise (D) clockwise

The speed of a 4-pole induction motor is controlled by varying the supply frequency while maintaining the ratio of supply voltage to supply frequency (V/f ) constant. At rated frequency of 50 Hz and rated voltage of 400 V its speed is 1440 rpm. Find the speed at 30 Hz, if the load torque is constant  (A) 882 rpm (B) 864 rpm (C) 840 rpm (D) 828 rpm

While selecting motor for an A.C which of the following characteristics is of great importance (1) Type of bearings (2) Type of enclosure (3) Noise (4) Arrangement for power transmission

What is the need of polarity marking in polyphase AC circuits?

In MOSFET, the polarity of the inversion layers is the same as that of?

An amplifier has a voltage gain of 50; this gain in dB will be (A) 34 dB (B) 68 dB (C) 41 dB (D) 14 dB

A Voltage Controlled Oscillator (VCO) is an instrument : - a) whose frequency is dependent upon the amplitude of input signal b) whose frequency is independent upon the amplitude of input signal c) whose frequency is dependent upon the frequency of input signal d) none of the above

These self inductance of a circuit is defined as twice the work done against the induced e.m.f. on establishing unit current in the coil. If the current to be established in the coil is doubled, the work done against the induced e.m.f. will be  1. Doubled  2. Halved  3. four times  4. Quarter times

The induced e.m.f. in the armature conductors of a d.c. motor is?

The e.m.f. induced in the armature of a shunt generator is 600 V. The armature resistance is 0.1 ohm. If the armature current is 200 A, the terminal voltage will be?

A 0-10 A ammeter has a guaranteed accuracy of 1% of full scale deflection, the limiting error while reading 2.5 A will be (a) 1% (b) 2% (c) 4% (d) None of these

While measuring power in a three phase load by two wattmeter method, the reading of two wattmeter are equal and opposite, when (a) load is balanced (b) power factor is unity (c) phase angle is between 60° to 90° (d) the load is purely inductive

A 240 V, dc shunt motor draws 15 A while supplying the rated load at a speed of 80 rad/s. The armature resistance is 0.5 W and the field winding resistance is 80 W. The net Voltage across armature resistance at the time of plugging will be

To prevent mal-operation of differentially connected relay while energizing a transformer, the relay restraining coil is based with  (1) second harmonic current  (2) third harmonic current  (3) fifth harmonic current  (4) seventh harmonic current

While forming a Routh array, the situation of a row of zeros indicates that the system (a) has symmetrically located roots (b) is stable (c) is insensitive to variations in gain (d) has asymmetrically located roots

With the help of neat diagram, explain the method to obtain unidirectional polarity in train lighting.

With a 12 V supply, a silicon diode, and a 370 - ohm resistor in series, what voltage will be dropped across the diode? a) 0.3V b) 0.7V c) 0.9V d) 1.4V

Self induced voltage across an inductance

The induced emf in the armature of a wave wound 4-pole d.c. machine having 100 armature conductors rotating at 600 r.p.m. and with a flux of 1 Wb per pole is (a) 1000 V (b) 2000 V (c) 200 V (d) 100 V

The induced emf in the armature of a lap -wound four -pole dc machine having 100 armature conductors rotating at 600 rpm and with 1 Wb flux per pole is  (1) 1000V (2) 100V (3) 600V (4) 10,000V

The e.m.f. induced in the primary of a transformer:  (A) is in phase with the flux (B) lags behind the flux by 90 degree (C) leads the flux by 90 degree (D) is in phase opposition to that of flux