# A piezo-electric type pressure sensor has a sensitivity of 1 mV/kPa and a bandwidth of 300 Hz to 300 kHz.

36 views
A piezo-electric type pressure sensor has a sensitivity of 1 mV/kPa and a bandwidth of 300 Hz to 300 kHz. For a constant (dc) pressure of 100 kPa, the steady state output of the sensor in millivolt is

(A) 0 (B) 2 (C) 4 (D) 6

A piezo-electric type pressure sensor has a sensitivity of 1 mV/kPa and a bandwidth of 300 Hz to 300 kHz. For a constant (dc) pressure of 100 kPa, the steady state output of the sensor in millivolt is 0

by
bro formula????

## Related questions

The pressure and velocity at the throat of a Venturi tube, measuring the flow of a liquid, are related to the upstream pressure and velocity, respectively, as follows: (A) Pressure is lower but velocity is higher (B) Pressure is higher but velocity is lower (C) Both pressure and velocity are lower (D) Pressure and velocity are identical

What is the difference between a sensor and a transducer?

List four electric pressure transducer.

Electric pressure is also called?

What is the temperature sensor?

Draw a neat sketch of 1-ph induction type energy meter and write operating principle of it.

A suspension type insulator has 2 units with self capacitance C and ground capacitance of 0.2 C. Each unit can withstand for a maximum voltage of 11 kV. Its string efficiency is  (A) 78% (B) 82% (C) 80% (D) 84%

If a suspended body is struck at the center of percussion, then the pressure on die axis passing through the point of suspension will be?

Rise time of an amplifier is found to be 1.0µS, its bandwidth (in kHz) is around  A) 2200 B) 1000 C) 350 D) 220

A dominant pole compensated op-amp has openloop gain of 100 dB and -3 dB bandwidth of 50 Hz. If it is connected as inverting amplifier for a gain of 20 dB the -3 dB bandwidth is about  A) 500 kHz B) 50 kHz C) 5 kHz D) 500 Hz

With a neat diagram, explain back pressure steam turbine co-generation system.

With a neat sketch explain working of 1 phase dynamometer type power factor meter.

List the four different units of pressure.

What is the working principle of pressure transmitter?

A series RLC circuit has a resonant frequency of 1 KHz and a quality factor Q = 100. If each of the R,L and C is doubled from its original value, the new Q of the circuit is:  (1) 25 (2) 50 (3) 100 (4) 200

Transformer coupling introduces which type of distortion?

Cylindrical type transformer has:  (A) Single magnetic circuit (B) Double magnetic circuit (C) All of the above (D) None of the above

Draw the diagram and explain the working of ferrodynamic type frequency meter.

State the function and shape of following parts used in induction type energy meter: i) Series magnet ii) Shunt magnet iii) Al disc iv) Brake magnet

State the effects of errors in dynamometer type wattmeter due to i) pc- inductance ii) pc- capacitance iii) mutual inductance iv) Connection.

Which type of starter is used to start the DC motor?

Which type of heater is cheapest to run?

What type of meter is used to measure current?

A tuned circuit has a Q of 100 at its resonant frequency of 500 kHz. Its bandwidth is _____kHz. (A) 50000 (B) 0.2 (C) 600 (D) 5

Draw and explain the operation of pressure transducer having diaphragm as a primary sensor and four strain gauges as secondary sensors.

The number of insulator discs (each rated 11 kV) required in a suspension type insulator string of 220 kV line is

The operation of a ramp type Digital Voltmeter is based on the principle of (A) Voltage-to-current conversion. (B) Voltage-to-time conversion. (C) Current-to-time conversion. (D) Current-to-frequency conversion.

The number of comparators required in a 4 bit comparator type ADC is (A) 16 (B) 15 (C) 17 (D) 12

An induction type energy meter is found to run fast. Correction for this error can be made by  (A) Over-load compensation. (B) Voltage compensation. (C) Moving the brake magnet away from the centre of the disc. (D) Moving the brake magnet towards the centre of the disc.

A J -K flip-flop with J= 1 and K= 1 has a 20 kHz clock input. The Q output is : (A) Constant and low (B) Constant and high (C) A square wave with 20 kHz frequency (D) A square wave with 10 kHz frequency

An amplifier which has almost same gain and input resistance of a CE amplifier but of higher bandwidth is  A) Cascode amplifier B) Cascade amplifier C) Darligton amplfier D) CC amplifier

A thyrite type lightening arrester :

In the induction type directional over current relay, when a short-circuit occurs in the circuit (A) power flows in reverse direction (B) power flows in normal direction (C) directional power element does not operate (D) over current element is not energized

Bandwidth of an RC coupled amplifier is 100 kHz. Two such amplifiers are connected in cascade.Resultant bandwidth(in kHz) is around  A) 200 B) 100 C) 60 D) 30

With diagram explain bottoming cycle type of co-generation.

Describe principle of operation of Doppler type ultrasonic flow meter with diagram.

With neat sketch explain working of Weston type synchroscope.

With neat diagram explain constructional details of dynamometer type wattmeter.

Explain construction & working of attraction type M.I. instrument with neat diagram.

Explain working of Weston type frequency meter.

Explain construction & working of electrodynamometer type wattmeter.

Write any two advantages of MI type instrument.