# While keeping the excitation constant, if the steam supply of an alternator running in parallel with another

23 views
While keeping the excitation constant, if the steam supply of an alternator running in parallel with another identical alternator is increased, then

(A) It would over-run the other alternator

(B) Its rotor will fall back in phase with respect to the other machine

(C) Its portion of share in load will increase

(D) Its power factor would be decreased.

## 1 Answer

0 votes

While keeping the excitation constant, if the steam supply of an alternator running in parallel with another identical alternator is increased, then Its portion of share in load will increase

## Related questions

1 answer 152 views

The effect of increasing load on a synchronous motor running with normal excitation is (A) Increase both its Ia and power factor. (B) Decrease Ia, but increase power factor. (C) Increase Ia, but decrease power factor (D) Decrease both Ia and power factor.

1 answer 23 views
1 answer 28 views
1 answer 80 views

Consider a circuit with three parallel branches connected across a DC supply. What is the ratio of the branch currents I1 : I2 : I3 if the branch resistances are in the ratio of 2 : 3 : 4 respectively? A) 2 : 3 : 4 B) 6 : 4 : 3 C) 4 : 3 : 2 D) None of these

1 answer 27 views

In a synchronous generator if the excitation increased from a low value to normal value, with a fixed load  (A) The armature current increases and the power factor decreases  (B) The armature current decreases and the power factor also decreases  (C) The armature current decreases and the power factor increases but is lagging  (D) The armature current decreases and the power factor increases and is leading

1 answer 28 views

The maximum constant load torque under which a synchronous motor will pull into synchronism at rated rotor supply voltage and frequency is known as?

1 answer 13 views

If the excitation of an alternator operating in parallel with other alternators decreased, its: (1) Power factor becomes more leading (2) Output Kw will change (3) Power factor becomes more lagging (4) Power factor becomes unity

1 answer 13 views
1 answer 17 views

The fractional-pitch used for eliminating 7th harmonic from the emf wave of an alternator is (A) 2/3 (B) 5/6 (C) 7/8 (D) 6/7

1 answer 20 views

A change of 4% in the supply voltage to an induction motor will produce a change of approximately

1 answer 34 views
1 answer 39 views

A dc chopper is fed from a constant voltage mains the duty ratio of chopper is progressively increased while the chopper feeds an RL load. The per unit current ripple would  (1) increase progressively  (2) decrease progressively  (3) decrease to a minimum value at α = 0.5 and then increase  (4) increase to a maximum value at α = 0.5 and then decrease

1 answer 24 views

If we change the excitation of synchronous machine will it affect on power factor?

1 answer 18 views

If we change the excitation of synchronous machine will it affect on motor speed?

1 answer 63 views

The magnitude of various voltage drops that occur in an alternator depends on?

1 answer 27 views
1 answer 25 views
2 answers 76 views

With three resistances connected in parallel, if each dissipates 20 W the total power supplied by the voltage source equals?

1 answer 30 views

The running winding of a single phase motor on testing with meggar is found to be ground. Most probable location of the ground will be?

1 answer 22 views

We connected a 35V dc supply to a resistance of 600 Ohm in series with an unknown resistance R.A. voltmeter having a resistance of 1.2 kOhm is connected across 600 Ohm resistance and read 5v. The value of resistance R will be

1 answer 36 views

A 200 V dc shunt motor is running at 1000 rpm and drawing a current of 10 A. Its armature winding resistance is 2 Ohm. It. is braked by plugging. The resistance to be connected in series with armature to restrict armature current to 10 A, is

1 answer 44 views

In an alternator at lagging power factor the generated voltage per phase as compared to that at unity power factor?

1 answer 145 views

what will happen when excitation of an unloaded salient pole synchronous motor suddenly gets disconnected?

1 answer 34 views

What is the frequency of an alternator which has 2 poles and makes 3600 revolutions per minute? A) 3600 HZ B) 60 Hz C) 120 Hz D) None of these

1 answer 24 views

The power factor of an alternator depends on?

1 answer 40 views

With neat diagram explain the following terms: (i) Steam turbine co-generation system (ii) Gas turbine co-generation system

1 answer 16 views
0 answers 18 views

Why the speed of synchronous motor is constant?

1 answer 4 views

Write the functions of re-heater in steam plant.

1 answer 18 views
0 answers 29 views

When two alternators A and B are operating in parallel, the increase in steam supply to alternator A will cause the active power output of (1) Alternator A to be decreased and alternator B to be increased (2) Alternators A and B is not affected (3) Alternators A and B is increased (4) Alternator A to be increased and alternator B to be decreased

1 answer 19 views
1 answer 23 views

With a neat diagram, explain back pressure steam turbine co-generation system.

1 answer 18 views
1 answer 16 views
1 answer 14 views
1 answer 33 views
1 answer 25 views
1 answer 21 views

Three 60 W bulbs are in parallel across the 60 V power line. If one bulb burns open?

1 answer 23 views

If a parallel circuit is opened in the main line, the current?

1 answer 23 views

Why does a transformer only work with an AC supply?

1 answer 23 views
2 answers 32 views
1 answer 31 views

In alternator where the voltage drop occurs?

1 answer 13 views

The rankine cycle efficiency of steam power plant is  (1) 60-80% (3) 30-45% (2) 45-80% (4) 20-30%

1 answer 19 views
1 answer 15 views
1 answer 13 views

What will happen if the primary of a transformer is connected to D.C. supply?  (A) Transformer will operate with low efficiency (B) Transformer will operate with high efficiency (C) No effect (D) Transformer may start to smoke and burn

1 answer 49 views

An A.C. voltage is impressed across a pure resistance of 3.5 ohms in parallel with a pure inductance of impedance of 3.5 ohms?

1 answer 9 views

Distinguish between fire tube and water tube boilers in steam power plant.