In an adjustable speed ac drive which quantity gets reduced above rated speed ?

20 views
In an adjustable speed ac drive which quantity gets reduced above rated speed ?

(A) developed torque (B) stator frequency

(C) reduced starting torque (D) stator current

In an adjustable speed ac drive which quantity gets reduced above rated speed ?

(A) developed torque (B) stator frequency

(C) reduced starting torque (D) stator current

Related questions

What is the difference between AC and DC drive?

Scherbius Drive System

Kramer Drive System

The direction of rotation of an inverter fed 3-phase ac motor is reversed by (A) a mechanical reversing switch (B) reversing the input dc link voltage (C) operating the inverter as a rectifier (D) changing the sequence of switching

An electric motor in which both stator field and rotor rotates with same speed is called?

The no-load speed of a single-phase SCR bridge converter fed separately excited dc motor operating at a firing delay angle, α and flux, Φ (A) directly proportional to α and Φ (B) inversely proportional to α and Φ (C) directly proportional to α and inversely proportional to Φ (D) directly proportional to Φ and inversely proportional to α

The synchronous motor which works on leading power factor and does not drive any mechanical load is called?

What is an electric motor drive?

What does an electric drive do?

For speed control of ac drive, the preferred method using thyristors is  A) Phase control B) Integral cycle control C) Single pulse PWM control D) Sinusoidal PWM control

‘PMMC instrument is not suitable to measure AC quantity’. State the reason.

A 240 V, dc shunt motor draws 15 A while supplying the rated load at a speed of 80 rad/s. The armature resistance is 0.5 W and the field winding resistance is 80 W. The net Voltage across armature resistance at the time of plugging will be

What is a drive in electrical controls?

The number of cycles in which a high speed circuit breaker can complete its operation is  (A) 3 to 8 (B) 10 to 18 (C) 20 to 30 (D) 40 to 50

Which rotor is use for high speed in turbo alternators?

What is the speed of an electromagnetic wave in water?

What is the need for electrically isolated drive circuits?

Explain transformer isolated drive circuits providing both signal and power.

What are the fundamental requirements of gate drive ICs?

Can a power surge erase a hard drive?

Explain MOSFET gate drive circuit and totem pole configuration.

Explain open emitter BJT drive circuit.

Explain DC coupled drive circuit with unipolar output.

Explain thyristor gate drive circuit.

basic gate drive circuit of GTO

Advantages of Variable Frequency Drive (VFD)

Is the power line voltage available in our homes a dc or an ac voltage?

An unshielded moving iron voltmeter is used to measure the voltage in an AC circuit. The stray DC magnetic field having a component along the axis will be  (1) unaffected (2) decreased (3) increased (4) either decreased or increased depending on the direction of the DC field

In an AC. circuit, a low value of kVAR compared with kW indicates?

Can you apply Thevenin's theorem in an AC circuit?

Can we apply Norton's theorem in an AC circuit?

What is the purpose of a capacitor in an AC circuit?

Salient pole rotor is use for which speed?

Synchronous motor always runs at which speed?

Which motor has the best speed regulation?

The synchronous speed of an 8 pole induction motor supplied power from a 50 Hz source will be ?

Which of the following motors can run on both AC and DC? A) Universal motor B) Dual wattage motor C) Flexible motor D) All the above

An AC supply of 230 V is applied to a half-wave rectifier circuit through a transformer having primary to secondary turn’s ratio 12:1. The peak inverse voltage is A) 8.62 V B) 12 V C) 19.17 V D) 27.11 V

An ac voltmeter using full -wave rectification and having a sinusoidal input has an ac sensitivity equal to  (1) 1.414 times dc sensitivity (2) dc sensitivity (3) 0.9 times dc sensitivity (4) 0.707 times dc sensitivity

A large AC generator, supplying power to an infinite bus, has a sudden short-circuit occurring at its terminals. Assuming the prime mover input and the voltage behind the transient reactance to remain constant immediately after the fault, acceleration of the generator rotor is

What is the difference between an AC and DC generator?