# Which of the following is true with a series circuit having resistors of different values?

17 views
Which of the following is true with a series circuit having resistors of different values?

A) The total resistance of the circuit is the sum of the individual resistances

B) The current across each resistor is the same

C) The voltage drop across each resistor depends on the value of the resistor

D) All the above

Which of the following is true with a series circuit having resistors of different values?

A) The total resistance of the circuit is the sum of the individual resistances

B) The current across each resistor is the same

C) The voltage drop across each resistor depends on the value of the resistor

D) All the above

## Related questions

A series R-L-C Circuit has a resonant frequency of 1000 Hz. If the values of R, L and C are doubled, the new resonant frequency is

In a series R-C circuit, with the increase in frequency, current (A) Reduces (B) Increases (C) Does not change (D) Becomes zero

The time constant of a series R-C circuit is given by?

In a series resonant circuit, the impedance of the circuit is?

If resistance is 20 Q. and inductance is 27 in a R-L series circuit, then time constant of this circuit will be?

What is the RMS voltage in a series RL circuit, if the voltage across R and L is 256 V and 192 V respectively? A) 320 V B) 448 V C) 64 V D) None of these

In a series circuit with unequal resistances?

Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero

In a series L-C circuit at the resonant frequency the?

In R-L-C series resonant circuit magnitude of resonance frequency can be changed by changing the value of?

A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the

At very low frequencies a series R-C circuit behaves as almost purely?

The series and parallel resonance on L-C circuit differs in that?

In a series RLC high Q circuit, the current peaks at a frequency  (1) equal to the resonant frequency (2) greater than the resonant frequency (3) less than the resonant frequency (4) equal to half the resonant frequency

In an ac series RLC circuit, the voltage across R and L is 20 V; voltage across L and C is 9 V and voltage across RLC is 15 V. What is the voltage across C?

In series resonant circuit, increasing inductance to its twice value and reducing capacitance to its half value?

Series circuit rules

What is the total resistance if 5 resistors of 20 Ω each are connected in series? A) 100 Ω B) 4 Ω C) 20 Ω D) None of these

Consider a circuit with four 10 Ω resistors connected in parallel and the current flowing through the circuit is 5 A. What will be the current if the above 4 resistors are connected in parallel? A) 5 A B) 50 A C) 500 A D) None of these

For a series resonant circuit, at the half power points,which of the following is true?  (a) Current is half of the current at resonance. (b) Resistance is equal to the reactance. (c) The impedance is half the impedance at the resonance. (d) None of the above

Which of the following is used in a circuit breaker as the medium in which the arc forms? A) Insulating gas B) Insulating oil C) Vacuum D) All the above

The input of an A.C. circuit having power factor of 0.8 lagging is 40 kVA The power drawn by the circuit is?

We connected a 35V dc supply to a resistance of 600 Ohm in series with an unknown resistance R.A. voltmeter having a resistance of 1.2 kOhm is connected across 600 Ohm resistance and read 5v. The value of resistance R will be

An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when A) ZL = R B) ZL = jXS C) ZL = R-jXS D) ZL = R+jXS

Which of the following is true with respect to a breeder reactor? A) Its conversion ratio is greater than 1  B) It is capable of generating more fissile material than it consumes C) Both A and B  D) None of these

Which of the following series combinations of resistors dissipates the most power when connected across a 120 V source? A. One, 220Ω resistor B. Two, 220Ω resistors C. Three, 220Ω resistors D. Four, 220Ω resistors

Two resistors are said to be connected in series when?

Which of the following are known as the short circuit parameters of a 2- port network? (A) Z- parameters. (B) H- parameters. (C) Y- parameters. (D) A,B,C,D, parameters.

Explain the series and parallel operation of MOSFET. Which is suitable and why?

A 40 W bulb is connected in series with a room heater. If now 40 W bulb is replaced by 100 W bulb, the heater output will?

Consider a circuit with three parallel branches connected across a DC supply. What is the ratio of the branch currents I1 : I2 : I3 if the branch resistances are in the ratio of 2 : 3 : 4 respectively? A) 2 : 3 : 4 B) 6 : 4 : 3 C) 4 : 3 : 2 D) None of these

Which of the following is true with an auto transformer? A) It has only one winding  B) It has two separate windings namely primary winding and secondary winding C) It has two primary windings and one single secondary winding D) None of these

Which of the following is true with respect to Wien Bridge? A) It does not require equal values of R or C  B) It requires that R and C values of all components must be equal C) It requires that all resistors should have equal values D) None of these

An AC supply of 230 V is applied to a half-wave rectifier circuit through a transformer having primary to secondary turn’s ratio 12:1. The peak inverse voltage is A) 8.62 V B) 12 V C) 19.17 V D) 27.11 V

Which of the following circuit breakers has high reliability & minimum maintenance?  (A) Bulk oil type CB (B) Air blast CB (C) Vacuum CB (D) Sulphur hexafluoride CB

An inductor is connected in series with SCR to protect it from A) Excessive high voltage B) Excessive high dv/dt C) Excessive high di/dt D) Excessive large forward current

Two 100W, 200V lamps are connected in series across a 200V supply. The total power consumed by each lamp will be in Watts

The time constant of the capacitance circuit is defined as the time during which voltage?

What are the advantages of DC series motor?