Can you help by answering this question?

Short-circuit kVA is obtained by multiplying the base kVA by

27 views
in Electrical Engineering by
For a round wire, the approximate value of fusing current is given by

1 Answer

0 votes
by

For a round wire, the approximate value of fusing current is given by  K√d3

Related questions

2 answers 238 views

The equation of 50 Hz current sine wave having r.m.s. value of 60 A is?

asked Mar 25, 2018 in Electrical Engineering by Shimroz123
1 answer 20 views

The r.m.s. value of a sinusoidal A.C. current is equal to its value at an angle of______degrees.

asked Mar 24, 2018 in Electrical Engineering by Shimroz123
2 answers 17 views

What happens when a current flows through a wire?

asked Mar 14, 2018 in Electrical Engineering by Quiz
1 answer 22 views

In the case of an unsymmetrical alternating current the average value must always be taken over?

asked Mar 25, 2018 in Electrical Engineering by Shimroz123
1 answer 30 views

Aluminium is not used as winding wire for the armature of a dc machine because  (1) aluminium has low resistivity (2) a large winding space is taken by aluminium conductors and creates jointing problems (3) the thermal conductivity of aluminium is low (4) aluminium has low conductivity as compared to copper

asked Apr 29, 2018 in Electrical Machine by Shimroz123
0 answers 209 views

For a fuse wire of diameter ‘d’, fusing current is proportional to   (a) √d (b) d1.2 (c) d1.5 (d) None of these 

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
1 answer 38 views

Increasing the number of turns of wire on the secondary of a transformer will  (A) Decrease the secondary current (B) Increase the primary current (C) Have no effect on the secondary current (D) Increase the secondary current

asked May 8, 2018 in Electrical Engineering by Shimroz123
1 answer 21 views

Wire-wound resistors are unsuitable for use at high frequencies because they?

asked Mar 25, 2018 in Electrical Engineering by Shimroz123
1 answer 27 views

The resistance of a few meters of wire conductor in closed electrical circuit is?

asked Mar 25, 2018 in Basic concepts by Shimroz123
1 answer 18 views

lf the wire which is vertical to this page has electron flow downwards the conductor will have

asked Apr 26, 2018 in Electrical Engineering by Shimroz123
1 answer 37 views

If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes?

asked Mar 25, 2018 in Basic concepts by Shimroz123
1 answer 328 views

A trolley wire weighs 1.2 kg per meter length. The ends of the wire are attached to two poles 20 meters apart. If the horizontal tension is 1500 kg find the dip in the middle of the span?

asked Mar 22, 2018 in Engineering Mechanics by Shimroz123
1 answer 14 views

A charge of 0.1 C moves past a given point every 0.01 s. How much is the current?

asked Jul 1 by Shimroz123
2 answers 49 views

The r.m.s. value of pure cosine function is?

asked Mar 25, 2018 in Electrical Engineering by Shimroz123
1 answer 15 views

The r.m.s. value and mean value is the same in the case of?

asked Mar 24, 2018 in Electrical Engineering by Shimroz123
1 answer 25 views

What is the value of Beta in power BJT?

asked Sep 20, 2017 in Electrical Engineering by Quiz
1 answer 54 views

The function of steel wire in ACSR conductors is (A) To take care of surges. (B) To reduce corona. (C) To reduce inductance. (D) To provide additional mechanical strength

asked May 8, 2018 in Electric Power Transmission by Shimroz123
1 answer 24 views

An A.C current is given by i=100sin100. It will achieve a value of 50 A after (1) 1/600 sec (2) 1/300 sec (3) 1/1800 sec (4) 1/900 sec 

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
1 answer 49 views

In an AC. circuit, a low value of kVAR compared with kW indicates?

asked Mar 25, 2018 in Electrical Engineering by Shimroz123
3 answers 43 views

How is electricity passed through a wire?

asked Mar 10, 2018 in Advanced electrical power system by Quiz
1 answer 23 views

Which of the following connection of transformers will give highest value of secondary voltage ? (A) Delta primary delta secondary (B) Delta primary star secondary (C) Star primary star secondary (D) Star primary delta secondary

asked May 8, 2018 in Electrical Engineering by Shimroz123
1 answer 26 views

Nichrome wire is an alloy of?

asked Mar 25, 2018 in Basic concepts by Shimroz123
0 answers 10 views

For the given voltage and current, the value of voltage regulation of a line for lagging loads with decrease in power factor (a) decreases (b) increases (c) remains same (d) either (a) or (c) 

asked May 25, 2018 in Electrical Engineering by Shimroz123
1 answer 13 views

In a 5 bit weighted resistor D/A converters, the resistor value corresponding to LSB is 40 kΩ, and the resistor value corresponding to MSB will be (A) 0.4 kΩ (B) 3 kΩ (C) 2.8 kΩ (D) 2.5 kΩ

asked Apr 28, 2018 in Digital Electronics by Shimroz123
1 answer 35 views

A fuse wire should have :  (A) Low specific resistance and high melting point (B) Low specific resistance and low melting point (C) High specific resistance and high melting point (D) High specific resistance and low melting point

asked May 8, 2018 in Switchgear And Protection by Shimroz123
1 answer 14 views

What is the maximum value of power factor?

asked Mar 19, 2018 in Electric Power Generation by Shimroz123
2 answers 150 views

What is the meaning of RMS value?

asked Dec 9, 2017 in Power Electronics by Quiz
1 answer 32 views

State functions of ; i) Cable box ii) Guard wire iii) Shackle insulator iv) Stay wire used in service connection

asked Sep 20, 2018 in Industry Electrical Systems-I by Shimroz123
1 answer 37 views

What is ACCC wire?

asked Mar 10, 2018 in Electric Power Distribution by Quiz
3 answers 113 views

Which color wire is neutral?

asked Dec 22, 2017 in Fundamentals of electrical power systems by Quiz
1 answer 19 views

Which of the following is the least expensive protection for over current in low voltage system?  (A) Rewireable fuse (B) Isolator (C) Oil Circuit breaker (D) Air break circuit breaker

asked May 8, 2018 in Electrical Engineering by Zeeshan
1 answer 16 views

Instantaneous value of a sine wave voltage

asked Jun 11 by Shimroz123
1 answer 27 views

In a synchronous generator if the excitation increased from a low value to normal value, with a fixed load  (A) The armature current increases and the power factor decreases  (B) The armature current decreases and the power factor also decreases  (C) The armature current decreases and the power factor increases but is lagging  (D) The armature current decreases and the power factor increases and is leading

asked Apr 29, 2018 in Electrical Machine by Shimroz123
1 answer 11 views

True value has been 50 whereas measured value is 40 then the percentage error in the reading will be ______.  (A) 20% (B) 40% (C) 50% (D) 30%

asked May 8, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 86 views

How do magnets and copper wire make electricity?

asked Mar 10, 2018 in Electric Power Generation by Quiz
1 answer 8 views

The advantage of a semiconductor strain gauge cover the wire round strain gauge is that

asked May 17, 2018 in Semiconductor by Shimroz123
1 answer 13 views

The leakage current of PN junction is caused by?

asked Mar 19, 2018 in Electronics Engineering by Shimroz123
0 answers 33 views

What is the approximate value of average resistance of a human body ?   (a) 1 kΩ (b) 5 kΩ (c) 10 kΩ (d) 15 kΩ

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
1 answer 25 views

A sine wave voltage is applied across an inductor. When the frequency of the voltage is decreased, the current decreases.

asked Nov 23, 2017 in Electrical Engineering by James

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units
...