# The velocity of travelling wave through a cable of relative permittivity 36 is

37 views
in Physics
The velocity of travelling wave through a cable of relative permittivity 36 is

The velocity of travelling wave through a cable of relative permittivity 36 is 0.5 x 108 m/sec

## Related questions

The bridge most suited for accurate measurement of relative permittivity of dielectric materials is (A) Carey Foster Bridge (B) Anderson’s bridge (C) Heaviside Bridge modified by Campbell. (D) Schering Bridge.

A single core lead sheathed cable with two dielectrics of permittivity 4 and 3, respectively, are subjected to same maximum stress. If the conductor diameter is 1.5 cm, the outer diameter of the first dielectric is (A) 1.125 cm (B) 1.5 cm (C ) 2 cm (D) 8 cm

Current velocity through a copper conductor is

A cable has an insulation of relative permittivity 2. If the insulation is replaced by one of relative permittivity 4, then capacitance of the cable (a) is doubled (b) is halved (c) remains unchanged (d) is reduced

The relative permeability of a ferromagnetic material is?

The pressure and velocity at the throat of a Venturi tube, measuring the flow of a liquid, are related to the upstream pressure and velocity, respectively, as follows: (A) Pressure is lower but velocity is higher (B) Pressure is higher but velocity is lower (C) Both pressure and velocity are lower (D) Pressure and velocity are identical

The coefficient of reflection for current wave is

If the insulation resistance of a cable of length 10 km is 1 mega ohm, its insulation resistance for 50 km length will be

A single core cable is designed to work for a single phase system with a peak voltage of 220 kV. The maximum permissible stress in the dielectric is not to exceed 20 kV/mm. For economical size, the overall core diameter of the cable is (A) 28.2 mm (B) 26.4 mm (C) 24.4 mm (D) 22.0 mm

Relative permeability of vacuum is?

What is the lowest acceptable insulation resistance for a cable?

what is the use of bedding on underground cable?

Drift velocity depends on ________ A) Electron mobility B) Electric field C) Both A and B D) None of these

How rating of main switch and cable is selected for Industrial Installation.

A material has conductivity of 10–2 mho/m and relative permittivity of 4. The frequency at which the conduction current in the medium is equal to the displacement current, is (a) 450 MHz (b) 900 MHz (c) 45 MHz (d) 90 MHz

A parallel polarized wave is incident from air into paraffin having relative permittivity 3, the value of its Brewster angle is: (1) 0° (2) 30° (3) 45° (4) 60°

State functions of ; i) Cable box ii) Guard wire iii) Shackle insulator iv) Stay wire used in service connection

The equation of 50 Hz current sine wave having r.m.s. value of 60 A is?

Three materials X, Y and Z having relative permittivity 2.5, 3.0 and 4.0 respectively are used in a single core cable. The materials on inner most and outer most layer respectively should be (a) X and Y (b) Y and Z (c) X and Z (d) Z and X

For a sine wave with peak value Imax the r.m.s. value is?

The fractional-pitch used for eliminating 7th harmonic from the emf wave of an alternator is (A) 2/3 (B) 5/6 (C) 7/8 (D) 6/7

What is the speed of an electromagnetic wave in water?

Instantaneous value of a sine wave voltage

Draw a labeled block diagram of sine wave generator and state function of each block.

Form factor for a sine wave is?

Explain full wave bridged rectifier with the help of circuit diagram and input output waveform.

Velocity of an electron (in km/S) starting at rest and travelling to a point 100 V above the starting potential is around  A) 3600 B) 4000 C) 5100 D) 6000

How fast is an electromagnetic wave?

what is mean by sine wave?

Explain three phase half wave controller or three phase unidirectional controller.

Explain three phase full wave controller.

Which countries are using wave energy?

A travelling wave of surge resistance, Ro on a transmission line is terminated by a load resistance, RL. If RL > Ro then there is (A) no reflected wave (B) partial reflection of reversal of current only (C) partial reflection of reversal of voltage only (D) reflection of reversal of both current and voltage

The phase velocity of wave propagating in a hollow metal wave guide is:  (1) Greater than the velocity of the light in free space (2) Less than the velocity of the light in free space (3) Equal to the velocity of the light in free space (4) Equal to the group velocity

In a Traveling-wave Tube, the velocity of electron beam with respect to the axial velocity of RF field is kept...  A) Lower B) Higher C) Equal D) Any of these

The impedance Z offered by transmission line for a travelling wave which damps out the low frequency oscillation rapidly is also called

lf a travelling-wave travelling along a loss-less overhead line does not result in any reflection after it has reached the far end, then the far end of the line is

An AC supply of 230 V is applied to a half-wave rectifier circuit through a transformer having primary to secondary turn’s ratio 12:1. The peak inverse voltage is A) 8.62 V B) 12 V C) 19.17 V D) 27.11 V