# A differential amplifier has a differential gain of 20,000, CMRR : 80 dB. The common mode gain is given by

93 views
A differential amplifier has a differential gain of 20,000, CMRR : 80 dB. The common mode gain is given by

## 1 Answer

0 votes

A differential amplifier has a differential gain of 20,000, CMRR : 80 dB. The common mode gain is given by 2

## Related questions

1 answer 58 views

A differential amplifier has a differential gain of 28000 and CMRR is 60 dB. What will be the value of common mode gain? A) Ac = 0.125 B) Ac = 0.33 C) Ac = 3 D) Ac = 28

1 answer 70 views

The voltage gain of a common -source JFET amplifier depends up on its  (1) Input impedance (2) Amplification factor (3) Dynamic drain resistance (4) Drain load resistance

1 answer 34 views

An amplifier has a voltage gain of 120. To reduce distortion, 10% negative feedback is employed. The gain of the amplifier with feedback is  (1) 141 (2) 92.3 (3) 9.23 (4) 1.41

0 answers 22 views

What is the advantage of differential amplifier?

0 answers 14 views

What is the use of differential amplifier?

1 answer 13 views

The effect of a finite gain of an operational amplifier used in an integrator is that (A) it would not integrate (B) the slope of the output will vary with time (C) the final value of the output voltage will reduce (D) there will be instability in the circuit

1 answer 64 views

An amplifier has input power of 2 microwatts. The power gain of the amplifier is 60 dB. The output power will be

1 answer 26 views

The unity gain bandwidth of an inverting amplifier is 10 MHz What would be the bandwidth if the gain is increased to 10 V/V? A) 100 MHz B) 1 MHz C) 10 MHz D) 1 kHz

1 answer 24 views

The gain of an ideal amplifier must be

1 answer 8 views

Define gain and bandwidth of an amplifier.

1 answer 46 views

In a differential amplifier the differential voltage gain is 500 and the common mode voltage gain is 0.5. The CMRR in dB is (a) 80 (b) 60 (c) 30 (d) 20

1 answer 78 views

If the base current of a BJT is 250 µA and emitter current is 15 mA, then the common base current gain will be A) 0.98 B) 0.41 C) 59 D) 55

1 answer 27 views

The voltage gains of the amplifier with and without feedback are 20 and 100 respectively. The percentage of negative feedback would be

1 answer 41 views

The purpose of the restraining coil in a biased differential relay is  (A) To reduce CT saturation during fault.  (B) To increase the sensitivity of the relay.  (C) To match the transformation ratio.  (D) To limit the spill current through the relay during heavy external fault.

1 answer 22 views

Which one of the following is another name for common-collector amplifier?  A) Source follower B) Collector follower C) Base follower D) Emitter follower

1 answer 32 views
1 answer 25 views

A transfer function has a second order denominator and constant gain in the numerator

1 answer 13 views

A certain common-emitter amplifier has a voltage gain of 100. If the emitter bypass capacitor is removed.  a. The circuit will become unstable b. The voltage gain will decrease  c. The voltage gain will increase d. The circuit will become stable

1 answer 21 views

Which configuration has the lowest current gain ?

1 answer 12 views

An amplifier has a voltage gain of 50; this gain in dB will be (A) 34 dB (B) 68 dB (C) 41 dB (D) 14 dB

1 answer 40 views
1 answer 11 views

An operational amplifier has an open loop gain of 200,000. Its output exhibits saturation at 10V. The threshold differential voltage of the amplifier is  A) 25 micro-volt B) 50 micro-volt C) 5 Volts D) 10 volts

1 answer 36 views

What will happen to the gain margin if the gain of the open loop system is doubled? A) Doubled B) Becomes half C) Is not affected D) Becomes one-fourth

1 answer 43 views

If the gain of the open loop system is doubled, the gain margin  (1) Is not affected (2) Gets doubled (3) Becomes half (4) Becomes one -forth

0 answers 15 views

What is the gain of an op amp?

1 answer 26 views

A unity negative feedback control system is found to have a gain margin of 20 dB. The Nyquist plot of the system (A) crosses the real axis at +0.1 (B) crosses the real axis at -0.1. (C) crosses the imaginary axis at -0.1 (D) crosses the imaginary axis at +0.1

0 answers 26 views

What do you mean by frequency response of an amplifier?

0 answers 21 views

The RF amplifier A is having 3 dB NF & 5 dB of gain, amplifier B is having 3.5 dB NF & 15 dB . For overall noise figure of the cascaded system, the correct statement is :  a. A as first stage & B as second stage offers minimum over all NF b. B as first stage & A as second stage minimum over all NF c. Both the combination will offer same overall NF d. Over all NF will be less than 3 dB.

1 answer 18 views
1 answer 22 views

What is the current gain?

1 answer 11 views

In op-amp operation, Common Mode Rejection Ratio (CMRR)

1 answer 18 views

What is the efficiency of Class-B amplifier?  A) 68.50% B) 78.50% C) 88.50% D) 98.50%

0 answers 16 views

What is the meaning of operational amplifier?

1 answer 42 views

What is Mason's gain formula?

1 answer 18 views

Draw diagram of class A push-pull amplifier and explain its operation.

0 answers 31 views

What is a BJT amplifier?

1 answer 29 views

An OP amp has an open loop gain of 1,00,000. If the feedback fraction is 0.02, the approximate closed loop gain is (a) 1 (b) 1,00,000 (c) 50 (d) 0.02

1 answer 23 views

The voltage gain of a common base amplifier depends on  1. Load resistor RL 2. input resistance of transistor 3. Ac alpha 4. All the above

0 answers 19 views

What type of biasing is used in CE amplifier?

1 answer 22 views

State the need of multistage amplifier. Draw frequency response of R-C coupled amplifier.

1 answer 23 views

State the need of cascade amplifier and draw circuit diagram of 2-stage direct coupled amplifier.

1 answer 6 views

List the advantages of RC coupled amplifier.

1 answer 4 views

State the need of cascade amplifier.

0 answers 13 views

What is the power amplifier?

0 answers 39 views

For a symmetrical emitter coupled differential amplifier using transistors of current gain 100, constant current source of 2 mA and with Vcc=10 V, differential input resistance in kOhm is about  A) 2.5 B) 5 C) 10 D) 50

0 answers 17 views

What is stability in an amplifier?

1 answer 49 views

Draw the single stage RC coupled amplifier circuit and explain its’s operation.

0 answers 52 views

A dominant pole compensated op-amp has openloop gain of 100 dB and -3 dB bandwidth of 50 Hz. If it is connected as inverting amplifier for a gain of 20 dB the -3 dB bandwidth is about  A) 500 kHz B) 50 kHz C) 5 kHz D) 500 Hz

1 answer 28 views

An amplifier without feedback has a gain of 1000. The gain with a negative feedback of 0.009 is  A) 10 B) 100 C) 125 D) 900

1 answer 16 views