# For a 66 kV line having span of 200 meters between towers the approximate sag will be 2 m. If the span is

185 views
For a 66 kV line having span of 200 meters between towers the approximate sag will be 2 m. If the span is double the sag will be:

(A) 1 m (B) 2 m (C) 4m (D) 8m

For a 66 kV line having span of 200 meters between towers the approximate sag will be 2 m. If the span is double the sag will be: 8m

## Related questions

The sag of a transmission line is least affected by (A) Self weight of the conductor. (B) Temperature of the surrounding air. (C) Current through the conductor. (D) Ice deposited on the conductor.

What is vertical sag?

What is sag in power system?

What is the sag for a span of 400m, if the ultimate tensile strength of conductor is 6000 kgf, and the weight of conductor is 550 kgf/km? Factor of safety is 2.

If the inertia constant H of a machine of 200 MVA is 2 p.u., its value corresponding to 400 MVA will be   (a) 4 p.u. (b) 2 p.u. (c) 1.0 p.u. (d) 0.5 p.u.

For 11 kV line the capacitance per km per phase will be of the order of:  (A) 1 Farad (B) 0.1 Farad (C) 0.01 Farad (D) 0.01 microF

An overhead transmission line has a span of 260 m. The weight of the conductor is 0.68 kg/m. The maximum allowable tension in the line is 1550 kg. Maximum sag of the line should be (a) 5.8 m (b) 4.6 m (c) 2.7 m (d) 3.7 m

A 200 MW generator is having a plant capacity factor of 30% and a plant load factor of 50%. What will be the reserve capacity of the plant ? (A) 40 MW (B) 50 MW (C) 60 MW (D) 80 MW

In a 2 kW, 200 V, 1000 rpm. DC series motor the torque at full load was found to be 0.3 N -m. The torque at half full load in N -m is :

A transistor has a typical value of β = 200 , If the collector current is 15 mA, then base current will be

A series RLC circuit resonate at 200 Hz. If the capacitance is increased to four times, the circuit will be in resonance at   (a) 100 Hz (b) 200 Hz (c) 400 Hz (d) 800 Hz

If 5000 kW power is transmitted at 220 kV in place of 11 kV, reduction in the value of electric current will be (a) 90% (b) 95% (c) 5% (d) 10%

The r.m.s. value of a half-wave rectified alternating current is 10 A. Its value for full-wave rectification will be

For a frequency of 200 Hz, the time period will be?

An overhead transmission line has a span of 240m between level supports. What is the maximum sag if the conductor weight 727 kg/km and has a breaking strength of 6880 kg? Allow the factor of safety of 2. Neglecting wind and ice loading.

The maximum torque of an induction motor is 200 kg-m at a slip of 12%. The torque at 6% slip would be (a) 100 kg-m (b) 160 kg-m (c) 50 kg-m (d) 40 kg-m

A 800 kV transmission line is having per phase line inductance of 1.1 mH/km and per phase line capacitance of 11.68 nF/km. Ignoring the length of the line, its ideal power transfer capability in MW is (A) 1204 MW (B) 1504 MW (C) 2085 MW (D) 2606 MW

If Voltage Standing Wave Ratio, (VSWR) of a wave is 2, its reflection coefficient will be _____.

For a short transmission line with r/x ratio of is 1.0, the regulation will be zero when the load power factor is

In CRO, Lissajous pattern will be a straight line, if the two signals are of same frequency with a phase difference of (a) 0° (b) 180° (c) 360° (d) All of these

A 200 V dc motor takes a field current of 2 A to generate a back emf of 180 V. If the field winding resistance is 80 Ω, the resistance of the shunt field regulator is (A) 10 Ω (B) 20 Ω (C) 100 Ω (D) 180 Ω

If three amplifiers having the same bandwidth are cascaded, the bandwidth of the resulting amplifier will be (a) Better than that of each stage (b) Worse than that of each stage (c) Same as that of each stage (d) None of the above

what will be the capacitance if three capacitors connected in parallel each having value of 0.5 micro Farad ?

What type of insulator will be used if the direction of the transmission line is to be changed?

If the transmission line is loaded with leading reactive volt amperes, there will be rise of voltage at the receiving end and this (a) increases (b) decreases (c) remains same with the increase in the length of line (d) none of these

An 800 kV transmission line has a maximum power transfer capacity of P. If it is operated at 400 kV with the series reactance unchanged, the new maximum power transfer capacity is approximately (A) P (B) 2P (C) P / 2 (D) P / 4

A transmission line of 200 km has a certain A, B, C and D parameters. If the length is reduced to 60 km

If voltage at the two ends of a transmission line is 132 kV and its reactance is 40 Ohms, the capacity of the line will be: (A) 435.6 MW (B) 217.8 MW(C) 251.5 MW (D) 500 MW

A 100 km long transmission line is loaded at 110 kV.if the loss of line is 5 MW and the load is 150 MVA, the resistance of the line is?

In a certain three -wire Y -connected generator, the phase voltages are 2 kV. The magnitudes of the line voltages will be: A. 2,000 V B. 6,000 V C. 666 V D. 3,464 V

If the range of an analog transducer is 0 to 10 V, then for a resolution of 5 mV, the bits of ADC will be _____.

A d.c. motor develops a torque of 200 N-m at 25 rps. At 20 rps it will develop a torque of .......... N-m.

What is the pitch factor of a 4 pole alternator having 36 slots and a coil span of 1 to 8?  (A) 140° (B) 80° (C) 20° (D) 40°

A shunt generator running at 1000 r.p.m. has generated e.m.f. as 200 V. If the speed increases to 1200 r.p.m., the generated e.m.f. will be nearly?

A Transmission line conductor has been suspended freely from two towers and has taken the form of a catenary that has c = 487.68m. The span between the two towers is 152 m, and the weight of the conductor is 1160 kg/km. Calculate the length of the conductor.  (A) 487.68 m (B) 152.614 m (C) 5.934 m (D) 11.9 m

Calculate the approximate locked rotor current of a 3 phase induction motor having a rating of 500 Hp, 2300 V.  (A) 130 A (B) 39 A (C) 390 A (D) 780 A

In a radio transmitter, the frequency of the crystal oscillator will be stable for a long time if the quality factor of the crystal resonator is  (a) > 100 (b) > 500 (c) > 1000 (d) > 20000

For a two port symmetric bilateral network, if A= 3Ω and B = 1Ω, the value of parameter C will be  (A) 4s (B) 6s (C) 8s (D) 16s

For a feedback amplifier, if the loop gain is much greater than unity, the closed loop gain will be equal to

A transmission line is operating with a Phase shift of 80° between two ends. If the load is suddenly increased A) The phase displacement will increase B) The phase displacement will decrease C) The phase displacement will not change D) The surge impedance will increase

A transmission line has 1 P.0 impedance on a base of 11 KV, 100 MVA. On a base of 55 KV. it will have a P.0 impedance of

In a transmission line if booster transformers are to be used, preferred location will be  (A) At the receiving end (B) At the sending end (C) At the intermediate point (D) Anywhere in the line