21 views
in Electrical Engineering by

1 Answer

0 votes
by
The capacity of capacitor is added and it becomes multiple of no of capacitors capacity

Related questions

2 answers 26 views

How will the total capacitance change, when two capacitors are connected in parallel?

asked May 29, 2018 in Capacitor by Shimroz123
3 answers 52 views

what will be the capacitance if three capacitors connected in parallel each having value of 0.5 micro Farad ?

asked Dec 11, 2017 in Electrical Engineering by Quiz
1 answer 11 views

Three capacitors 15µf, 18µf and 12µf are connected in a circuit. Find equivalent capacitance when they are connected in – 1) Series 2) Parallel

asked Sep 2, 2018 by Shimroz123
1 answer 16 views

If a cell connection is reversed in parallel group, what will happen? A. Open circuit B. All cells will be equally charged C. short circuit D. Nothing will happen 

asked Apr 12, 2018 in Electrical Engineering by Shimroz123
1 answer 13 views

What will happen if the primary of a transformer is connected to D.C. supply?  (A) Transformer will operate with low efficiency (B) Transformer will operate with high efficiency (C) No effect (D) Transformer may start to smoke and burn 

asked May 8, 2018 in Electrical Engineering by Shimroz123
0 answers 32 views

What will happen if a voltmeter is connected like an ammeter in series of the load ? (a) The meter will burn out. (b) The measurement will be too high. (c) The same current will flow as would have been with ammeter in circuit. (d) There will be almost no current in the circuit. 

asked May 26, 2018 in Electrical Measurements and Instrumentation by Shimroz123
2 answers 26 views

Three lamps are connected in parallel across a 120 Volt source. If one lamp burns out, the remaining two will be: A. Glow dimmer B. Glow brighter C. Not light D. Glow with the same brightness as before

asked Apr 12, 2018 in Electrical Engineering by Shimroz123
1 answer 10 views

When two 100 kΩ resistors are connected in parallel, net resistance is

asked May 15, 2018 in Electrical Engineering by Shimroz123
1 answer 22 views

When four resistances of 2W 1W; 5W 2W; 10W 5W and 15W 10 W are connected in parallel, the greatest power is absorbed by • 2 W, 1 W • 5 W, 2 W • 10 W, 5W • 15 W, 10 W

asked May 13, 2018 in Electrical Engineering by Shimroz123
1 answer 18 views

When three resistors with unequal values are connected in parallel, _______ A) The current across the resistors is the same  B) The voltage drop across the resistors is the same C) The voltage drops across the resistors is proportional to the resistance of each resistor D) None of these

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
0 answers 20 views

When ‘n’ resistances each of value ‘r’ are connected in parallel, then the resultant resistance is ‘x’. When these ‘n’ resistances are connected in series, total resistance is  (A) n2X (B) X/n (C) n2/X (D) nX2

asked Apr 5, 2018 in Electrical Engineering by Shimroz123
1 answer 23 views

When n resistances each of value r are connected in parallel, then resultant resistance is x. When these n resistances are connected in series, total resistance is

asked Mar 31, 2018 in Electrical Engineering by Shimroz123
1 answer 9 views

Which of the following will happen if a voltmeter is connected like an ammeter in series to the load ? (A) There will be almost no current in the circuit. (B) The meter will burn. (C) The measurement will be trio high. (D)  A very high current will flow.

asked May 12, 2018 in Electrical Engineering by Shimroz123
1 answer 9 views

What will happen when a DC shunt motor is started with a load?

asked Jul 5 in DC motor by Shimroz123
1 answer 145 views

what will happen when excitation of an unloaded salient pole synchronous motor suddenly gets disconnected?

asked Mar 18, 2018 in Synchronous machine by Shimroz123
1 answer 9 views

Equivalent capacitance ‘C’ of a system of capacitors C1,C2,C3 connected in parallel is

asked May 15, 2018 in Capacitor by Shimroz123
0 answers 42 views

When two synchronous machines are connected in parallel the synchronizing power tends to (A) accelerate the faster machine (B) retard the faster machine (C) retards the slower machine (D) pull the faster machine out of step

asked Jun 4, 2018 in Synchronous machine by Shimroz123
1 answer 16 views

When two transformer of different kVA rating are connected in parallel they share the load in proportion to their respective kVA rating only when their:

asked May 22, 2018 in Transformer by Shimroz123
1 answer 73 views

What would happen if a power transformer designed for operation on 50 Hz (frequency) were connected to a 500 Hz (frequency) source of the same voltage:  (A) Eddy Current and Hysteresis losses will be excessive  (B) Current will be too much high  (C) Transformer may start to smoke and burn  (D) No effect

asked May 8, 2018 in Electrical Engineering by Shimroz123
1 answer 47 views

What will happen if you increase the current in the motor?

asked Mar 15, 2018 in Electrical Machine by Quiz
0 answers 67 views

If one of the control springs of PMMC ammeter is broken when it is connected in a circuit, the meter will read  A) Half the correct value of current B) Twice the correct value of current C) An indefinite figure D) Zero

asked Apr 9, 2018 in Electrical Engineering by Shimroz123
0 answers 121 views

Two heater wires of equal length are connected first in series and then in parallel. The ratio of heat generated from series to parallel connection will be (a) 4 : 1 (b) 2 : 1 (c) 1 : 2 (d) 1 : 4

asked May 25, 2018 in Electrical Engineering by Shimroz123
3 answers 134 views

Three resistors of 4 Ω, 6 Ω and 9 Ω are connected in parallel. Which resistor consumes the maximum power?  (A) 4 Ω (B) 6 Ω (C) 9 Ω (D) 17 Ω

asked Apr 5, 2018 in Electrical Engineering by Shimroz123
1 answer 22 views

Four identical resistors are first connected in parallel and then in series. The resultant resistance of the first combination to the second will be

asked Mar 31, 2018 in Electrical Engineering by Shimroz123
2 answers 201 views

why the electrical appliances are connected in parallel ?

asked Aug 14, 2017 in Electrical Engineering by Zeeshan
1 answer 18 views

A battery of 40 V and three capacitors of 1000 μF, 500 μF and 100 μF are all connected in (I) parallel and (II) series. The ratio of total charge stored in case I to that in case II is approximately  (a) 3 : 64 (b) 64 : 3 (c) 160 : 3 (d) 104 : 5

asked May 15, 2018 in Battery by Shimroz123
0 answers 17 views

What is the equivalent resistance of a network having 5 resistors of each 10ohm connected in parallel?  (A) 10 Ohms (B) 50 Ohms (C) 500 Ohms (D) 2 Ohms 

asked Apr 5, 2018 in Electrical Engineering by Shimroz123
7 answers 139 views

Do capacitors in parallel have the same voltage?

asked Dec 11, 2017 in Electrical Engineering by Quiz
1 answer 11 views

When two alternators are operating in parallel, the cause for circulating current is (A) increase in the excitation of one machine (B) increase in the driving torque of one machine (C) reduction in angular velocity of one machine (D) identical speed/load characteristics of both machines

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
0 answers 29 views

When two alternators A and B are operating in parallel, the increase in steam supply to alternator A will cause the active power output of (1) Alternator A to be decreased and alternator B to be increased (2) Alternators A and B is not affected (3) Alternators A and B is increased (4) Alternator A to be increased and alternator B to be decreased

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
1 answer 22 views

What is the charge on each capacitor when a 150 V is applied across two capacitors with values 5 μF and 10 μF, connected in series? A) 500 μC B) 0.5 μC C) 0.5 C D) None of these

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 19 views

When an additional resistor is connected across an existing parallel circuit, the total resistance: A. remains the same B. decreases by the value of the added resistor C. increases by the value of the added resistor D. decreases

asked Apr 12, 2018 in Electrical Engineering by Shimroz123
1 answer 18 views

What amount of current will flow through resistance of 10 ohms when it is connected across a potential difference of 20 volts? A.30 amperes B.5 amperes C.10 amperes D.2 amperes

asked May 15, 2018 in Basic concepts by Shimroz123
1 answer 36 views

What will happen to the gain margin if the gain of the open loop system is doubled? A) Doubled B) Becomes half C) Is not affected D) Becomes one-fourth 

asked Jun 18, 2018 in Control System by Shimroz123
1 answer 56 views
0 answers 16 views

A dc series motor when connected across an AC supply will (1) Develop torque in same direction (2) Not develop any torque (3) Draw dangerously high current (4) Develop a pulsating torque 

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
0 answers 22 views

If two 3-phase transformers with unequal voltage ratios are connected in parallel, the result is (A) circulating current on no-load (B) no circulating current on no-load (C) dead short-circuit (D) equal no-load secondary emfs 

asked Jun 4, 2018 in Electrical Machine by Shimroz123
1 answer 22 views

Four inductors each of inductance 1mH are connected in parallel and this combination is connected in series with two inductors each of inductance 1mH. Calculate the equivalent inductance?

asked May 15, 2018 in Inductor by Shimroz123
1 answer 87 views

There resistors of 3Ω, 10Ω, and 15Ω are connected in parallel to a 30 V circuit the current that will flow through the 3Ω resistor is 

asked Mar 29, 2018 in Electronics Engineering by Shimroz123
1 answer 26 views

Three identical resistors are first connected in parallel and then in series. The resultant resistance of the first combination to the second will be?

asked Mar 25, 2018 in Basic concepts by Shimroz123
1 answer 80 views

Consider a circuit with three parallel branches connected across a DC supply. What is the ratio of the branch currents I1 : I2 : I3 if the branch resistances are in the ratio of 2 : 3 : 4 respectively? A) 2 : 3 : 4 B) 6 : 4 : 3 C) 4 : 3 : 2 D) None of these

asked Apr 29, 2018 in Electrical Engineering by Shimroz123

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units

8,450 questions

7,047 answers

132 comments

3,085 users

...