28 views
in Switchgear And Protection by
The RRRV depends upon

1 Answer

0 votes
by

The RRRV depends upon the inductance and capacitance of the system

Related questions

1 answer 16 views

The degree of protection by ground wire depends upon the a. Arcing angle b. Shielding angle c. Power factor d. All of above

asked Sep 1, 2018 by Shimroz123
0 answers 15 views

The sensitivity of a closed loop system to gain changes and load disturbances depends upon (a) forward gain (b) loop gain (c) frequency (d) all the above 

asked May 25, 2018 in Control System by Shimroz123
0 answers 16 views

The rate of rise of transient recovery voltage (TRV) depends upon the circuit (a) power factor (c) frequency (b) voltage (d) breaking current

asked Apr 14, 2018 in Electrical Engineering by Shimroz123
0 answers 16 views

the division of active power amongst alternators running in parallel depends upon (1) speed-load characteristics of prime mover (2) V-I characteristics of alternator (3) Excitation voltages of alternators (4) Both (b) and (c) 

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
0 answers 54 views

The speed of a synchronous motor depends upon  (1) supply voltage (2) supply frequency (3) number of poles (4) both supply frequency and number of poles

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
1 answer 16 views

In a superconductor the value of critical density depends upon?

asked Mar 28, 2018 in Electrical engineering materials by Shimroz123
1 answer 9 views

Voltage required to operate a neon-sign tube depends upon

asked May 15, 2018 in Electrical Engineering by Shimroz123
1 answer 112 views

Frequency of oscillation of an AMV depends upon  1. RC values of the circuit 2. Collector load resistors 3. Transistor 4. Width of input pulse 

asked May 13, 2018 in Electrical Engineering by Shimroz123
1 answer 10 views

 Hysteresis loss in a transformer depends upon: -  a) both voltage and frequency b) voltage alone c) frequency alone d) none of these

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
1 answer 11 views

Making capacity of the circuit breaker depends on (A) operating voltage (B) short circuit MVA (C) fault current (D) All of the above

asked May 13, 2018 in Switchgear And Protection by Shimroz123
1 answer 54 views

The reactive power transfer over a line mainly depends on

asked Apr 27, 2018 in Switchgear And Protection by Shimroz123
1 answer 25 views

Two transformers operating in parallel will share the load depending upon their

asked May 12, 2018 in Transformer by Shimroz123
0 answers 44 views

A router:  (1) forwards a packet to all outgoing links, except the link upon which the packet originated. (2) forwards a packet to the next free outgoing link. (3) determines on which outgoing link a packet is to be forwarded. (4) forwards a packet to all outgoing links.

asked Apr 10, 2018 in Computer Engineering by Shimroz123
1 answer 19 views

The closed loop gain of an OPAMP is dependent upon, whether the OP AMP is used : -  a) in inverting mode b) in non -inverting mode c) is independent of the fact whether the input is connected to inverting or non -inverting terminal d) is depending upon the fact whether the input is connected to inverting or non -inverting terminal

asked Apr 10, 2018 in Instrumentation and control by Shimroz123
1 answer 9 views

The Kirchoff's law for a.c. is applicable upon consideration of -  a) Phasor sum b) Algebraic sum c) Progression sum d) Linear sum

asked Apr 10, 2018 in Instrumentation and control by Shimroz123
1 answer 8 views

Upon increasing the transmission voltage, volume of the conductor will:  (A) increase (B) not change (C) decrease (D) increase for some time and then decrease

asked Apr 9, 2018 in Electrical Engineering by Shimroz123
0 answers 63 views

When Aluminium is deposited directly upon N type semiconductor, the diode formed has the characteristic  A) Forward current due to minority carriers B) Small delay time from on to off C) Large storage time D) Higher break down voltage

asked Apr 5, 2018 in Electronics Engineering by Shimroz123
1 answer 20 views

A d.c. motor can be looked upon as d.c. generator with the power flow?

asked Mar 26, 2018 in DC motor by Shimroz123
1 answer 150 views

A single force and a couple acting in the same plane upon a rigid body?

asked Mar 22, 2018 in Engineering Mechanics by Shimroz123
1 answer 297 views

According to principle of transmissibility of forces, the effect of a force upon a body is?

asked Mar 22, 2018 in Engineering Mechanics by Shimroz123
1 answer 9 views

Write the factors on which capacity of parallel plate condenser depends.  

asked Sep 4, 2018 by Shimroz123
0 answers 18 views

The power loss in a transmission line depends on (a) current in the line. (b) resistance of the line. (c) length of the line. (d) All of the above 

asked May 26, 2018 in Electric Power Transmission by Shimroz123
1 answer 9 views

The thermal noise depends on  (A) direct current through device (B) resistive component of resistance (C) reactive component of impedance (D) load to connected.

asked May 17, 2018 in Electrical Engineering by Shimroz123
1 answer 7 views

The degree of coupling depends  (A) size of hole (B) location of holes (C) size and location of holes (D) not depend on size or location of hole

asked May 17, 2018 in Physics by Shimroz123
1 answer 18 views

A system is causal if the output of any time depends only on   (A) Values of input in the past and in the future (B) Values of input at that time and in the past (C) Values of input at that time and in the future (D) none

asked May 17, 2018 in Digital Signal Processing by Shimroz123
1 answer 31 views

The coefficient of coupling between two air core coils depends on   (A) mutual inductance between two coils only (B) self inductances of the two coils only (C) mutual inductance and self inductances of the two coils (D) none

asked May 16, 2018 in Electrical Engineering by Shimroz123
1 answer 83 views

The diameter of conductor used in LT 660 V grade power cables depends on

asked May 15, 2018 in Electrical Engineering by Shimroz123
1 answer 48 views

In a Synchronous motor, the magnitude of stator back e.m.f (Eb) depends on

asked May 15, 2018 in Electrical Machine by Shimroz123
1 answer 23 views

The voltage gain of a common base amplifier depends on  1. Load resistor RL 2. input resistance of transistor 3. Ac alpha 4. All the above 

asked May 13, 2018 in Amplifier by Shimroz123
1 answer 11 views

In the ideal closed loop operational amplifier, the gain depends on (A) value of the series component (B) value of the feedback component (C) on the operational amplifier itself (D) both A and B

asked May 12, 2018 in Electronics communication by Shimroz123
1 answer 15 views

The electric breakdown strength of insulating materials depends on  (A) Nature of applied voltage (B) lmperfection of dielectric material (C) Pressure, temperature and humidity (D) All or these

asked May 8, 2018 in Electric Power Transmission by Shimroz123
1 answer 72 views

The voltage gain of a common -source JFET amplifier depends up on its  (1) Input impedance (2) Amplification factor (3) Dynamic drain resistance (4) Drain load resistance

asked Apr 30, 2018 in Power Electronics by Shimroz123
1 answer 19 views

The capital cost of a power plant depends on  (1) Total installed capacity only. (2) Total number of units only. (3) Total installed capacity and number of units as well. (4) Neither the installed capacity nor number of units

asked Apr 30, 2018 in Power system by Shimroz123
1 answer 11 views

The total magnetic moment  1. is called saturation magnetization.  2. depends on the number of magnetic dipoles per unit volume, the instant electric current and the area of the current loop.  Which of the above statements is/are correct ?

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
0 answers 8 views

The dielectric strength of ferromagnetic materials depends to a large extent on (a) Intensity of electric field (b) Presence of magnetic materials in vicinity (c) Area of hysterisis loop for materials (d) Frequency of applied voltage

asked Apr 14, 2018 in Electrical Engineering by Shimroz123
0 answers 7 views

The deflecting torque of a moving coil instrument depends on (a) supply frequency (c) flux in the coil (b) inverse of area of coil (d) square of the voltage

asked Apr 14, 2018 in Electrical Engineering by Shimroz123
1 answer 26 views

The speed of the Microprocessor depends on: - a) clock b) data bus width c) address bus width d) size of the register

asked Apr 14, 2018 in Instrumentation and control by Shimroz123

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units

8,450 questions

7,047 answers

132 comments

3,084 users

...