# If the distance of screen from a CRT to center of deflection plates is 15 cm, the length of

19 views
If the distance of screen from a CRT to center of deflection plates is 15 cm, the length of deflection plates is 2 cm, the distance between the plates is 1 cm and accelerating voltage is 500 V, deflection sensitivity is

(a) 33.2 V/cm (b) 0.03 cm/V (c) 66.4 V/cm (d) 0.015 cm/V

If the distance of screen from a CRT to center of deflection plates is 15 cm, the length of deflection plates is 2 cm, the distance between the plates is 1 cm and accelerating voltage is 500 V, deflection sensitivity is 0.03 cm/V

## Related questions

The vertical deflection of an electron beam on the screen of a CRO is measured to be 8 mm. Now, the potential difference between the Y-plates is doubled, and simultaneously the pre-accelerating anode voltage is reduced to half of its previous value. Then, the vertical deflection of the beam on the screen would become (A) 64 mm (B) 32 mm (C) 8 mm (D) 1 mm

Deflection of electron beam in a CRT is  A) Inversly proportional to length of deflecting plates B) Directly proportional to distance between plates C) Inversly proportional to deflecting potential D) Inversly proportional to accelerating potential

The Lissajous pattern observed on screen of CRO is a straight line inclined at 45° to x axis. If X–plate input is 2 sin ωt, the Y–plate input is (1) 2 sin ωt (2) 2 sin (ωt + 45°) (3) 2 sin (ωt – 45°) (4) 22 sin ωt + 45°)

What happens to the capacitance if mica is inserted between the plates of an air capacitor? A) The capacitance increases B) The capacitance decreases C) The capacitance remains the same D) The capacitance becomes zero

If 3000 kW power is to be transmitted over a distance of 30 km, the desirable transmission voltage will be.  (A) 11 kV (B) 33 kV (C) 66 kV (D) 132 kV

Horizontal deflection plates of CRO are placed generally   (a) Horizontal (b) Vertical (c) Diagonal (d) (a) or (b)

A transmission line of 200 km has a certain A, B, C and D parameters. If the length is reduced to 60 km

The center of percussion of the homogeneous rod of length L suspended at the top will be?

The capacitance of 0-1000V electrostatic voltmeter increases from 36-42 pF from zero to full scale deflection. It is required to extend the range of voltmeter to 10000 V by using an external series capacitor. What should be the value of series capacitor?  (A) 0.8 pF (B) 1.00 pF (C) 6.644 pF (D) 4.667 pF

If a suspended body is struck at the center of percussion, then the pressure on die axis passing through the point of suspension will be?

A commutator with a diameter of 50 cm rotates at 1000 r.p.m. If brush width is 1.5 cm, the time of commutation will be (a) 0.168 m sec (b) 0.374 m sec (c) 0.481 m sec (d) 0.573 m sec

Which of the following factors limit the deflection of the pointer of a PMMC instrument of about 90o?  1. Its damping mechanism  2. Linearity of magnetic field in which the coil moves  3. Control spring arrangement  4. Shape of pole shoe for the horse shoe magnet   Select the correct answer using the code given below:   (a) Only 1 and 3 (b) Only 2 and 4 (c) Only 2 and 3 (d) Only 1 and 4

If the distance between the light source and the surface is reduced to half, the illumination on the surface will   (a) reduce to half of the original. (b) reduce to one fourth of the original. (c) increase to double of the original. (d) increase to four times of the original.

A oscilloscope 4cmX4cm screen has its own sweep out, fed back to its input if x&y Sensitivities are same, the oscilloscope will display  A) triangular wave B) diagonal line C) sine wave D) Circle

If the base current of a BJT is 250 µA and emitter current is 15 mA, then the common base current gain will be A) 0.98 B) 0.41 C) 59 D) 55

A transistor has a typical value of β = 200 , If the collector current is 15 mA, then base current will be

if the rated voltage from the power lines is applied to the primary of a single-phase transformer which is operated on no-load, then

If the energy is supplied from a source, whose resistance is 1 ohm, to a load of 100 ohms the source will be?

The international standard of Length is defined in terms of : - a) Length of earth's meridian passing through Paris b) The distance between two lines engraved on a Platinum -iridium Bar c,) Wavelength in vacuum, of radiation of Krypton -86 atom cP None of the above

A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is: (1) 4000 Ω (2) 400 Ω (3) 40 Ω (4) 4 Ω

If the insulation resistance of a cable of length 10 km is 1 mega ohm, its insulation resistance for 50 km length will be

What is a safe distance from power lines?

An optical fiber cable laid underground has developed a discontinuity at a distance d from the source end. The fault can be located using the instrument  (a) Optical spectrum Analyzer (OSA) (b) Optical Time Domain Reflectometer (OTDR) (c) Optical Power Meter (OPM) (d) Laser Diffractometer (LD)

Minimum distance of underground cable from the foundation of building should be   (a) 100 cm (b) 50 cm (c) 10 cm (d) 5 cm

If the rms voltage drop across a 15 kilt resistor is 16 V, the peak current through the resistor is : -  a) 15 mA b) 1.5 mA c) 10 mA d) 1 mA

To read or write a complete word from / to the memory in 8086 microprocessor and if it is located at an even address, the number of Read or Write cycles required is

Neglecting saturation, if current taken by a series motor is increased from 10 A to 12 A, the percentage increase in its torque is ........ percent

If transformer frequency is changed from 60 Hz, to 60 Hz the ratio of eddy current loss 60 Hz to 50 Hz, at constant voltage will be?

If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes?

A circuit is said to be free from phase distortion if its phase response shows: (1) Quadrature variation with frequency (2) Independent of frequency (3) Linear variation with frequency (4) Proportional to frequency

If a variable can take only integer values from 0 to n, where n is a constant integer, then variable can be represented as a bit-field whose width is the integral part of (assume base 2)  (1) log(n) +1 (2) log(n + 1) + 1 (3) log(n – 1) + 1 (4) none of these

In a synchronous generator if the excitation increased from a low value to normal value, with a fixed load  (A) The armature current increases and the power factor decreases  (B) The armature current decreases and the power factor also decreases  (C) The armature current decreases and the power factor increases but is lagging  (D) The armature current decreases and the power factor increases and is leading

The per unit impedance ofa circuit element is 0.15. If the base kV and base MVA are halved, then the new value of the per unit impedance of the circuit element will be?

Under no load condition, if the applied voltage to an induction motor is reduced from the rated voltage to half the rated value,  (A) the speed decreases and the stator current increases (B) both the speed and the stator current decreases (C) the speed and the stator current remain practically constant (D) there is negligible change in the speed but the stator current decreases

The ratio of maximum displacement of the forced vibration to the deflection due to static force is known as : (A) Damping Factor (B) Damping Coefficient (C) Logarithmic Decrement (D) Magnification Factor

The Lissajous pattern on the screen of a CRO is an ellipse with major axis in quadrant 2 and quadrant 4. Then the phase difference between two signals Can be :  (A) 270° (B) 210° (C) 180° (D) 300°

The trace on an oscilloscope continually moves to the right of the screen when  (a) the sweep is triggered. (b) the sweep period is larger than the signal period. (c) the sweep period is smaller than the signal period. (d) there is no weep.

If both the number of turns and core length of an inductive coil are doubled, then its self inductance will be (a) halved (b) doubled (c) quadrupled (d) unaffected

The type of phospher used in CRT used for television is  A) P11 B) P4 C) P2 D) P1

What happens to the resistance of a wire when its length as well as the cross-sectional area are doubled? A) It doubles B) It becomes 4 times C) It becomes 2π times D) It remains the same