14 views
in Utilization of electrical energy by
Change in the frequency of supply does not affect the 

 (a) Dielectric heating (b) Electrical resistance heating (c) Induction heating (d) Microwave heating 

Your answer

Thanks for your contribution. Feel free to answer this question. Please avoid short answer. Your answer is most welcome. Be genuine.

Upload image or document:

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
Are you a robot ? (Y = Yes / N = No)
To avoid this verification in future, please log in or register.

1 Answer

0 votes
by

Change in the frequency of supply does not affect the Electrical resistance heating 

Related questions

0 answers 12 views

In a series RLC circuit, which one does not change with change in input frequency ? (A) Bandwidth (B) Quality factor (C) Resonant frequency (D) All of them

asked Apr 14, 2018 in Electrical Engineering by Shimroz123
0 answers 20 views

If the signal does not change at all, its frequency will be  (1) ∞ Hz (2) 0 Hz (3) 1 Hz (4) None of these

asked Apr 10, 2018 in Computer Engineering by Shimroz123
1 answer 10 views

Which flag does not change by the execution of the instruction DCR B in 8085 microprocessor ?  (a) Parity (b) Carry (c) Zero (d) Sign

asked May 15, 2018 in Microprocessors and Microcontrollers by Shimroz123
1 answer 18 views

Which of the following does not change in a transformer?  (A) Current (B) Voltage (C) Frequency (D) All of the above

asked May 8, 2018 in Electrical Engineering by Shimroz123
1 answer 4 views

Change in the circuit voltage will affect   (a) Resonant frequency (b) Q factor (c) Current (d) Bandwidth  

asked May 13, 2018 in Electrical Engineering by Shimroz123
1 answer 24 views

If we change the excitation of synchronous machine will it affect on power factor?

asked Mar 18, 2018 in Synchronous machine by Shimroz123
1 answer 18 views

If we change the excitation of synchronous machine will it affect on motor speed?

asked Mar 18, 2018 in Synchronous machine by Shimroz123
0 answers 16 views

Which of the following methods of heating is not dependent on the frequency of supply (1) Induction heating (2) Dielectric heating (3) Electric resistance heating (4) All of the above

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
1 answer 20 views

A change of 4% in the supply voltage to an induction motor will produce a change of approximately

asked May 8, 2018 in Electrical Machine by Shimroz123
0 answers 45 views

Reduction in supply voltage by 10% will change the torque of an induction motor by   (a) 38% (b) 19% (c) 9.5% (d) No change 

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
1 answer 25 views

In a step-down transformer, there is a change of 15 A in the load current. This results in change of supply current of?

asked Mar 19, 2018 in Transformer by Shimroz123
1 answer 20 views

When current flows through heater coil it glows but supply wiring does not glow because?

asked Mar 25, 2018 in Basic concepts by Shimroz123
0 answers 14 views

A change of 5% in supply voltage to an induction motor will produce a change of approximately (a) 5% in the rotor torque (b) 7.5% in the rotor torque (c) 10% in the rotor torque (d) 25% in the rotor torque

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
1 answer 28 views

What happens to the voltage in the secondary when the frequency of the supply in the primary is decreased? A) It increases B) It decreases C) It remains the same D) Cannot say unless the actual percentage increase in the frequency is known

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 23 views

Two synchronous generators operating in parallel supply a common load of 2.5 MW. The frequency-power characteristics have a common slope of 1 MW/Hz and the no-load frequencies of the generators are 51.5 Hz and 51.0 Hz, respectively. Then the system frequency is (A) 50 Hz (B) 51 Hz (C) 51.25 Hz (D) 51.5 Hz

asked Apr 28, 2018 in Electrical Machine by Shimroz123
1 answer 236 views

The time period of third harmonic of power supply frequency, in milliseconds, is (A) 20 (B) 3.33 (C) 6.66 (D) 60

asked Apr 28, 2018 in Network Analysis by Shimroz123
1 answer 26 views

what do not change in transformer?

asked Mar 19, 2018 in Transformer by Shimroz123
1 answer 44 views

The meter which does not have any component in it to provide control torque is (A) Electrodynamometer for current measurement (B) Electrodynamometer for voltage measurement (C) Electrodynamometer for power measurement. (D) Electrodynamometer for power factor measurement.

asked Apr 28, 2018 in Electrical Measurements and Instrumentation by Shimroz123
0 answers 17 views

How hot does it get in a microwave?

asked Mar 11, 2018 in Utilization of electrical energy by Quiz
1 answer 135 views

In a pure capacitive circuit if the supply frequency is reduced to 1/2, the current will?

asked Mar 25, 2018 in Electrical Engineering by Shimroz123
1 answer 47 views

In a pure inductive circuit if the supply frequency is reduced to 1/2, the current will?

asked Mar 25, 2018 in Electrical Engineering by Shimroz123
1 answer 15 views

The slip of an induction motor normally does not depend on  (A) rotor speed (B) synchronous speed (C) shaft torque (D) core-loss component

asked May 17, 2018 in Induction Machine by Shimroz123
1 answer 19 views

When inspection doors on the walls of boilers are opened, flame does not leap out because  (1) These holes are small (2) Pressure inside is negative (3) Flame travels always in the direction of flow (4) These holes are located beyond the furnace

asked Apr 29, 2018 in Power system by Shimroz123
1 answer 21 views

Which of the following does not have a commutator? A) Dynamo B) Induction motor C) Universal motor D) None of these

asked Apr 29, 2018 in Electrical Machine by Shimroz123
1 answer 18 views

Which of the following does not show non-linear V-I characteristics? (A) Schottky diode (B) Tunnel diode (C) Thermistor, at a fixed temperature (D) p-n Junction diode.

asked Apr 26, 2018 in Electronics Engineering by Shimroz123
1 answer 25 views

 Which one of the following does not have an effect on corona ?  (a) Spacing between conductors (b) Conductor size (c) Line voltage (d) Length of conductor

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
0 answers 10 views

Stack does not have one of the following methods  (1) Pop (2) push (3) Top (4) replace 

asked Apr 10, 2018 in Computer Engineering by Shimroz123
1 answer 13 views

A shaded pole induction motor does not have the advantage of   (a) Rugged construction (b) Low initial as well as maintenance cost (c) High starting torque (d) Comparatively small starting current 

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
1 answer 10 views

Which of the following microphone does not require polarizing current?  (1) Crystal microphone (2) Condenser microphone (3) Carbon microphone (4) All of the above 

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
1 answer 11 views

The leakage current must not be more than ____________ of maximum supply current

asked May 29, 2018 in Electrical Engineering by Shimroz123
1 answer 25 views

lf a travelling-wave travelling along a loss-less overhead line does not result in any reflection after it has reached the far end, then the far end of the line is

asked Apr 26, 2018 in Switchgear And Protection by Shimroz123
1 answer 15 views

Negative feedback in a closed-loop control system DOES NOT (A) reduce the overall gain (B) reduce bandwidth (C) improve disturbance rejection (D) reduce sensitivity to parameter variation

asked Apr 26, 2018 in Control System by Shimroz123
1 answer 19 views

How does AC current change direction?

asked Mar 14, 2018 in Electrical Engineering by Quiz
1 answer 11 views
0 answers 94 views

The SCR would be turned OFF by voltage reversal of applied anode-cathode ac supply frequency of A) 10 kHz B) 10 Hz C) 5 kHz D) 5 Hz 

asked Jun 18, 2018 in Power Electronics by Shimroz123
1 answer 18 views

The speed of a 4-pole induction motor is controlled by varying the supply frequency while maintaining the ratio of supply voltage to supply frequency (V/f ) constant. At rated frequency of 50 Hz and rated voltage of 400 V its speed is 1440 rpm. Find the speed at 30 Hz, if the load torque is constant  (A) 882 rpm (B) 864 rpm (C) 840 rpm (D) 828 rpm

asked May 17, 2018 in Induction Machine by Shimroz123
0 answers 21 views

If the supply frequency of a 3-phase induction motor is ‘f’, then frequency of rotor emf at motor slip ‘s’ will be   (a) sf (b) (1 – s)f (c) f/s (d) None of these 

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
1 answer 26 views

lf slip of an induction machine is 0.02 and the stator supply frequency is 50 Hz, what will be the frequency of the rotor induced e.m.f.? (A) 10 Hz (B) 50 Hz (C) 1 Hz (D) 2500 Hz

asked Apr 9, 2018 in Electrical Engineering by Shimroz123
1 answer 24 views

Which of the following heating methods is independent of supply frequency?  (A) electric are beating (C) electric resistance heating (B) induction heating (D) dielectric heating

asked Apr 9, 2018 in Electrical Engineering by Shimroz123
1 answer 29 views

The effective resistance of an iron-cored choke working on ordinary supply frequency is more than its true resistance because of?

asked Mar 25, 2018 in Electrical Engineering by Shimroz123
1 answer 10 views

The supply for arc welding is : 

asked Apr 29, 2018 in Utilization of electrical energy by Shimroz123
1 answer 12 views

The ideal operational amplifier does not have: (1) Infinite input resistance (2) Infinite output resistance (3) Infinite voltage gain (4) Infinite bandwidth 

asked May 29, 2018 in Amplifier by Shimroz123
1 answer 20 views

Identify the instrument that does not exist (A) Dynamo-meter type ammeter (B) Dynamo-meter type wattmeter (C) Moving-iron voltmeter (D) Moving-iron wattmeter

asked Apr 26, 2018 in Electrical Measurements and Instrumentation by Shimroz123
0 answers 18 views

The EM wave which does not propagate through a rectangular waveguide with a=30 mm & b=15 mm is : a. EM wave of frequency 4.5 GHz b. EM wave of frequency 5.5 GHz c. EM wave of frequency 50 GHz d. EM wave of frequency 300 GHz

asked Apr 12, 2018 in Electronics Engineering by Shimroz123
1 answer 29 views

The synchronous motor which works on leading power factor and does not drive any mechanical load is called?

asked Mar 18, 2018 in Synchronous machine by Shimroz123
1 answer 99 views

How does electric locomotive work?

asked Mar 11, 2018 in Utilization of electrical energy by Quiz
0 answers 51 views

Frequency of Indian Electric supply is  A) 230Hz B) 50 Hz C) 440 Hz D) 60 Hz

asked Apr 9, 2018 in Electrical Engineering by Shimroz123

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units

8,483 questions

7,081 answers

134 comments

3,088 users

...