# If the number of branches in a network is 'B', the number of nodes is 'N' and the number of

19 views
If the number of branches in a network is 'B', the number of nodes is 'N' and the number of dependent loops is 'L', then the number of independent node equations will be

(a) N+L–1 (b) B–1 (c) B–N (d) N–1

If the number of branches in a network is 'B', the number of nodes is 'N' and the number of dependent loops is 'L', then the number of independent node equations will be N–1

## Related questions

The number of independent loops for a network with n nodes and b branches is

With n nodes and b branches a network will have   (A) (b+n) links (B) b - n +1 links (C) b -n-1 links (D) b + n + 1 links

A network has 10 nodes and 17 branches. The number of independent mesh equations required to solve the network is   (a) 7 (b) 8 (c) 10 (d) 45

In a network, if the number of holes is n and number of elements is e, then the number of independent mesh equations required to solve the network is (a) e – n + 1 (b) e + n + 1 (c) e + n – 1 (d) e – n – 1

Which among the following is the equation for the number of independent loops for a network with n nodes and b branches?  (A) n-1 (B) b+n-1 (C) b-n+1 (D) b-n

When the graph of a network has six branches with three tree branches then the minimum number of equations required for the solution of the network is   (A) 2 (B) 3 (C) 4 (D) 5

A connected graph has ‘5’ number of branches and ‘4’ number of nodes. It's rank is A) 1 B) 2 C) 3 D) 4

A binary tree T has n leaf nodes. The number of nodes of degree 2 in T is  A) log2n B) n-1 C) n D) 2n

Consider the star network shown in figure. The resistance between terminals A and B with C open is 6 ohms, between terminals B and C withAopen is 11 ohms and between terminals C andAwith B open is 9 ohms. Then RA, RB, RC respectively is

In an n-bus power system, considering n-nodes network, the size of ybus is   (a) (n – 1) × (n – 1) (b) (n + 1) × (n + 1) (c) n × n (d) 2n × 2n

A closed path made by several branches of the network is known as?

If the number of conditions in a decision table is n, the maximum number of rules (columns) possible is  A) n B) 2n C) 2n D) log2n

For a two port symmetric bilateral network, if A= 3Ω and B = 1Ω, the value of parameter C will be  (A) 4s (B) 6s (C) 8s (D) 16s

As a network contains only independent current sources and resistors then if the values of all resistors are doubled then the values of the node voltages are   (A) will become half (B) will remain unchanged (C) will become double (D) cannot be determined unless the circuit configuration and the values of the resistors are known.

A network contains linear resistors and ideal voltage sources. If values of all the resistors are doubled then the voltage across each resistor will

The number of independent equations to solve a network is equal to?

In a graph, the number of independent loops is 6 and the number of independent cut sets is 5, The total number of branches in the graph is A) 9 B) 12 C) 10 D) 11

The three non -inductive loads of 5 kW, 3 kW and 2 kW are connected in a star network between R, Y and B phases and neutral. The line voltage is 400 V. The current in the neutral wire is nearly (a) 11 A (b) 14 A (c) 17 A (d) 21 A

One of the necessary and sufficient condition for a network function N(s)=p(s)/q(s) to be a transfer function is that  A) The coefficients of the polynomial p(s) and q(s) must be real and those for q(s) must be positive B) Coefficients of p(s) and q(s) must be real and positive C) Coefficients of p(s) must be positive and real but coefficients of q(s) can be negative also D) Degree of p(s) and q(s) may differ by either zero or one only

When The dc converter in figure shown has a resistance load of R = 10 Ω and the input voltage is Vs 220 V the converter switch remains on, its voltage drop is Vo -2 V. The chopping frequency is fI K sW Vs If the duty cycle is 50%, determine: (a) the average output voltage V (b) the RMS output voltage Vo (c) the converter efficiency (d) the effective input resistance of the converter

To find current in a resistance connected in a network, Thevenin's theorem is used VTH = 20 V and RTH = 5 Ω. The current through the resistance: (1) is 4 A (2) is 4 A or less (3) is less than 4 A (4) May be 4 A or less or more than 4 A

A network is said to be under resonance when the voltage and the current at the network input terminals are (A) in phase (B) out of phase (C) in phase quadrature (D) in phase, and have equal magnitudes

If the no load voltage of a certain generator is 220V and the rated load voltage is 200V, then the voltage regulation is: a. 1% b. 10% c. 20V d. 9%

A transmission line of 200 km has a certain A, B, C and D parameters. If the length is reduced to 60 km

A passive two port network is in a steady state. Compared to its input, the steady state output can never offer  A) Higher voltage B) Lower impedance C) Greater power D) Better regulation

A passive 2-port network is in a steady state, compared to its input, the steady state output can never offer   (a) Higher voltage (b) Lower impedance (c) Greater power (d) Better regulation

The number of p-n junctions in a thyristor are  A)1 B) 2 C) 3 D) 4

The number of distinct simple graphs with upto three nodes is  A) 15 B) 10 C) 7 D) 9

For a two -port reciprocal network, the three transmission parameters are A = 4, B = 7 and C = 5. What is the value of D ?  (a) 9.5 (b) 9.0 (c) 8.5 (d) 8.0

"In any network containing more than one sources of e.m.f. the current in any branch is the algebraic sum of a number of individual fictitious currents (the number being equal to the number of sources of e.m.f.), each of which is due to separate action of each source of e.m.f., taken in order ... sources of e.m.f. are replaced by conductors, the resistances of which are equal to the internal resistances of the respective sources". The above statement is associated with?

An electrical circuit with 10 branches and 7 junctions will have

A terminal where three on more branches meet is known as?

"Any number of current sources in parallel may be replaced by a single current source whose current is the algebraic sum of individual source currents and source resistance is the parallel combination of individual source resistances". The above statement is associated with?

When cathode is positive with respect to anode in an SCR, the number of blocked p-n junctions is   (a) 1 (b) 2 (c) 3 (d) 4

A network contains linear resistors and ideal voltage sources. If values of all the resistors are doubled, then voltage across each resistor is  A) Halved B) Doubled C) Increases by 4 times D) Remains the same

A coil of wire is placed in a changing magnetic field. If the number of turns in the coil is decreased, the voltage induced across the coil will: A. increase B. decrease C. remain constant D. be excessive

Two port networks are connected in cascade. The parameters of the network are obtained by multiplying in individual

State the number of sub-shells in K,L,M,N shells.

What is active and passive network?

A network which contains one or more than one source of e.m.f. is known as?

Which of the following are known as the short circuit parameters of a 2- port network? (A) Z- parameters. (B) H- parameters. (C) Y- parameters. (D) A,B,C,D, parameters.

"Maximum power output is obtained from a network when the load resistance is equal to the output resistance of the network as seen from the terminals of the load". The above statement is associated with?

The number of chords in the graph of the given circuit will be