# The current carried by a given type of ion expressed as a fraction of total current conducted

13 views
The current carried by a given type of ion expressed as a fraction of total current conducted though the electrolyte is called

The current carried by a given type of ion expressed as a fraction of total current conducted though the electrolyte is called Transport number

## Related questions

For a round wire, the approximate value of fusing current is given by

An A.C current is given by i=100sin100. It will achieve a value of 50 A after (1) 1/600 sec (2) 1/300 sec (3) 1/1800 sec (4) 1/900 sec

The current i(t), through a 10 Ω resistor in series with an inductance, is given by I(t) = 3 + 4sin (100t + 450 ) + 4 sin(300t +600) amperes. The RMS values of the current and power dissipation in the circuit are:  (A) √41 A, 410 W respectively (B) √35 A, 350 W respectively (C) 5 A, 250 W respectively (D) 11 A, 1210 W respectively

What type of excitation is given to the rotor winding of a synchronous motor?  (A) DC supply at 100 -250 V (B) AC supply at 400 V (C) Revolving field (D) Induction from stator currents

Comparing the total copper cross sections in terms of current-carrying capacity for a single-phase and a three-phase 120 V system with effective load resistance of 15Ω, will yield: A. single-phase 32 A; three-phase 16 A B. single-phase 16 A; three-phase 8 A C. single-phase 8 A; three-phase 4 A D. single-phase 16 A; three-phase 0 A

Plugging of dc motors is carried by (1) Reversing only the field and armature polarity (2) Reversing only the field polarity (3) Reversing only the armature polarity (4) Disconnecting the armature from supply and connecting across a resistance

The frequency (fr) of the rotor current in an induction motor is given by the expression (s = slip, f = supply frequency)

A charge of 0.1 coulomb moves through a given point in every 0.05 seconds. The current flowing through the point is (a) 2 mA (b) 5 mA (c) 2 A (d) 5 A

For the given voltage and current, the value of voltage regulation of a line for lagging loads with decrease in power factor (a) decreases (b) increases (c) remains same (d) either (a) or (c)

The time constant of a series R-C circuit is given by?

In which type of the faults given below, all of the three components Ia0, Ia1 and Ia2 are equal?  (A) Single line to ground fault (B) Double line to ground fault (C) Line to line fault (D) 3 phase faults

Identify type of BJT configuration having following features : (i) BJT configuration having the least current gain. (ii) KIT configuration called as voltage follower. (iii) BJT configuration having current gain less than one. (iv) BJT configuration suitable for impedance matching. (v) BIT configuration suitable for voltage amplification. (vi) BJT configuration having the least output impedance.

The phase voltages across a certain load are given as Va = (176 - j132) V, Vb = (-128-j96) V and Vc = (- 160 +j100) V. Compute positive sequence component of voltage.  (A) 0 (B) 163.24-j35.1 V (C) 50.1-j53.9 V (D) 25.1-j53.9 V

An OP amp has an open loop gain of 1,00,000. If the feedback fraction is 0.02, the approximate closed loop gain is (a) 1 (b) 1,00,000 (c) 50 (d) 0.02

The hysteresis loop of magnetic material has an area of 5 cm2 with the scales given as 1 cm=2AT and 1 cm=50 mWb, at 50 Hz, the total hysteresis loss is  (A) 15 W (B) 20 W (C) 25 W (D) 50 W

In case of open circuited transmission lines the reflection coefficient is given by (A) 1 (B) -1 (C) 0.5 (D) 0

The rated voltage of a 3-phase power system is given as  A) rms phase voltage B) Peak phase voltage C) rms line to line voltage D) Peak line to line voltage

Total instantaneous power supplied by a 3-phase ac supply to a balanced R-L load is

For a waveform to be expressed in Fourier series, which of the following conditions must be satisfied? I. Maxwell’s conditions, II. Drichlet conditions, III. Sampling Theorem A) I only B) II only C) II and III only D) I, II and III

The Power rating of a distribution power transformer is expressed in  A) kW B) kVAR C) kVA D) Ampere

Transient stability studies of a power system are usually carried out over a time period of (A) two or more seconds (B) several time swings (C) time interval of first swing (D) sustained oscillations

Which type of earthing is also called as 'fire earthing'? A. Plate earthing B. Rod earthing C. Strip earthing

A type of conductor known as expanded ACSR has a filler separating inner steel strands from outer aluminium strands and this filler is (a) mica sheet (c) paper tape (b) cotton tape (d) aluminium foil

Write the procedure of converting a given current source into voltage source.

A charge of 0.1 C moves past a given point every 0.01 s. How much is the current?

A charge of 6 C moves past a given point every 0.3 s. How much is the current?

A charge of 0.05 C moves past a given point every 0.1 s. How much is the current?

A charge of 1 C moves past a given point every 0.1 s. How much is the current?

A charge of 2 C moves past a given point every 0.5 s. How much is the current?

A current of 4 amperes flowing for 45 minutes deposits 1.062 gm of metal at cathode. Calculate the equivalent weight of the metal. (Given 1 Faraday = 96500 C)

A differential amplifier has a differential gain of 20,000, CMRR : 80 dB. The common mode gain is given by

Whether a given point in the S-plane lies on the Root Locus of a system can be determined by (A) Magnitude criterion (B) Angle Criterion (C) Both Magnitude and Angle Criteria (D) Break-in and Break-away Criteria

The impedance of a circuit is given by z=3+j4. Its conductance will be?

Which of the following test is carried out to ensure the sufficient strength of insulation between two or more conductors to avoid leakage between them ?   (a) Testing of insulation resistance between wiring and earth (b) Testing of insulation resistance between conductors (c) Testing of polarity of single phase switch (d) Testing of earth continuity path

An emf of 120 V causes a current of 3A to flow in a circuit how much energy is supplied by the source in 12 seconds. A. 4130 J B. 4310 J C. 4320 J D. None of these

The amount of current in a resistor needs to be changed from 120 mA to 160 mA by changing the 24 V source, the new voltage will be: A. 8 V B. 320 V C. 3.2 V D. 32 V

The reactance offered by a capacitor to alternating current of frequency 50 Hz is 20 Q. If frequency is increased to 100 Hz, reactance becomes_____ohms.

Laplace transform of unit impulse function is given by : (A) 1 (B) s (C) 1/s (0) 1/s2

The current through a flashlight bulb is 40 mA and the total battery voltage is 4.5 V. The resistance of the bulb is approximately? A.112 ohms B.11.2 ohms C.1.2 ohms D.18 ohms

In induction type directional over current relay the driving torque is due to interaction of magnetic fields derived from (A) current in the potential coil (B) both voltage and current in the relay windings (C) directional element and non-directional element (D) non-directional element and the trip circuit