Ask a Question
what is the value of Beta in power BJT?
What is the value of Beta in power BJT?
Sep 20, 2017
to add a comment.
← Prev Question
Next Question →
to answer this question.
The beta value in power BJT is 5 to 10.
Sep 20, 2017
to add a comment.
What is the difference between beta and forced beta for BJT?
bjt what is beta ?
What is the maximum value of power factor?
Explain the formation of parasitic BJT and parasitic diode in Power MOSFET.
For high value of diversity factor, a power station of given installed capacity will be in a position to supply?
The value of starting capacitor of a fractional horse power motor will be?
why IGBT is preferred as a power switch over both power BJT and MOSFET?
Operating frequency of power MOSFET is higher than that of power BJT. Justify the statement.
Explain the on state losses in power BJT.
The r.m.s. value and mean value is the same in the case of?
What is the meaning of RMS value?
What is the difference between BJT and FET?
what are the three operating regions of BJT?
In the case of an unsymmetrical alternating current the average value must always be taken over?
If the 12 Ohm resistor draws a current of 1 A as shown in the figure, the value of resistance R is
What is the value of capacitance required to improve power factor from 0.7 to 0.9.
What is a BJT amplifier?
What is a BJT?
what is bjt biasing?
For a round wire, the approximate value of fusing current is given by
The equation of 50 Hz current sine wave having r.m.s. value of 60 A is?
The r.m.s. value of pure cosine function is?
The r.m.s. value of a sinusoidal A.C. current is equal to its value at an angle of______degrees.
The peak value of a sine wave is 200 V. Its average value is?
In an AC. circuit, a low value of kVAR compared with kW indicates?
True value has been 50 whereas measured value is 40 then the percentage error in the reading
In a 5 bit weighted resistor D/A converters, the resistor value corresponding to LSB is 40 kΩ, and the resistor
In a two value capacitor motor, the capacitor used for running purposes is?
State the need of biasing of BJT.
Compare between BJT and FET on the basis of (i) Biolar/Unipolar (ii) Tharmal Runaway (iii) Noise (iv) Applications
Which phenomenon is present in thyristors but absent in BJT, MOSFET and IGBT ?
when bjt is in cutoff ?
If the base current of a BJT is 250 µA and emitter current is 15 mA, then the common base current gain will be
Is the input impedance of MOSFET more than BJT and FET?
what does bjt stand for?
what are bjt amplifiers used for?
what are bjt transistors?
in which BJT operating region both the junctions are reverse biased?
Which of the following connection of transformers will give highest value of secondary voltage ?
The determinant of a 2 x 2 matrix is 50. If one eigen value of the matrix is 10, the other eigen value is ________.
The normal value of adhesion friction is?
Draw circuit diagram of voltage divider biasing list two advantages of voltage divider biasing of BJT.
In a synchronous generator if the excitation increased from a low value to normal value, with a fixed load
why igbt is used instead of bjt and mosfet?
in which region BJT act as a switch?
in which region BJT act as amplifier?
Define : i) Maximum Value ii) RMS Value of ac supply
Define : i) Average value ii) RMS value of an AC Wave.
Instantaneous value of a sine wave voltage
Compare BJT with FET