# The degree of coupling depends

8 views
in Physics
The degree of coupling depends

(A) size of hole (B) location of holes (C) size and location of holes (D) not depend on size or location of hole

The degree of coupling depends location of holes

## Related questions

The degree of protection by ground wire depends upon the a. Arcing angle b. Shielding angle c. Power factor d. All of above

The degree of mechanical vibrations produced by the laminations of a transformer depends on?

The coefficient of coupling between two air core coils depends on   (A) mutual inductance between two coils only (B) self inductances of the two coils only (C) mutual inductance and self inductances of the two coils (D) none

Define degree of Ionisation. Explain the factors affecting degree of Ionisation.

Define degree of ionization. Explain the effect of concentration and temperature on degree of ionization.

State the factors affecting degree of ionization.

A binary tree T has n leaf nodes. The number of nodes of degree 2 in T is  A) log2n B) n-1 C) n D) 2n

A 200 V, 50 Hz inductive circuit takes a current of 10 A at 30 degree lagging pf, what is the inductive reactance of the circuit?  (A) 17.8 Ω (B) 100 Ω (C) 178 Ω (D) 10 Ω

Which of the following device is used for coupling microwave energy?  A) Resonator B) Waveguide C) Loop D) Antenna

The purpose of a coupling capacitor in an amplifier is to:  (1) Control the output (2) Provide impedance matching (3) Provide DC isolation between amplifier and load (4) W Increase the bandwidth

The coefficient of coupling between two coils is 0.45. The first coil has an inductance of 75 mH and the second coil has an inductance of 105 mH. What is the mutual inductance between the coils?  (1) 3.54 mH (2) 7.88 mH (3) 39.9 mH (4) 189.3 mH

The differential coupling of two coils in series connection has self-inductance of 2 mH & 4 mH & a mutual inductance of 0.15 mH. The equivalent inductance of the combination is:  (A) 5.7 mH (B) 5.85 mH (C) 6 mH (D) 6.15 mH

A single phase fully controlled thyristor bridge ac -dc converter is operating at a firing angle of 25 degree and an overlap angle 10 degree with constant dc output current of 20A. The fundamental power factor (displacement factor) at input ac mains is : (A) 0.78 (B) 0.827 (C) 0.866 (0) 0.9

Maximum junction temperature and maximum ambient temperature of a power transistor (in degree Centigrade) are 150 and 52. The set level power dissipation is 32 watts, transistor thermal factor is 0.7 and of mica washer is 0.5.Thermal resistivity of heat sink (in degree C/W) is  A) 1.8 B) 3.2 C) 6.4 D) 9.8

For any fixed degree of inductive shunt compensation, additional series capacitive compensation?

Explain the three phase 120 degree mode VSI.

What is coefficient of coupling? Explain in brief.

One advantage of transformer coupling in transistor amplifier is that:  (1) it provides excellent frequency response (2) It is simple and less expensive than others (3) Low power supply may be used (4) High efficiency and high power output is obtained.

Maximum power developed in a synchronous motor occurs at a coupling angle of:  (A) 120° (B) 60° (C) 90° (D) 0°

Transformer coupling introduces which type of distortion?

The correct order of electromagnetic spectrum with decreasing frequency is: (1) Microwaves, Radiowaves, Infrared rays, Ultraviolet rays, X–rays (2) Radiowaves, Infrared rays, Ultraviolet rays, Microwaves, X–rays (3) X–rays, Infrared rays, Microwaves, Radiowaves, Ultraviolet rays (4) X–rays, Ultraviolet rays, Infrared rays, Microwaves, Radiowaves

Moving coil instruments have which one of the following scales ? (a) Logarithmic scale (b) Uniform scale (c) Non-uniform scale (d) Squared scale

A silicon p-n junction at a temperature of 20 °C has a reverse saturation current of 10 pA. The reverse saturation current at 40 °C will approximately be (a) 30 pA (b) 40 pA (c) 50 pA (d) 60 pA

A material has conductivity of 10–2 mho/m and relative permittivity of 4. The frequency at which the conduction current in the medium is equal to the displacement current, is (a) 450 MHz (b) 900 MHz (c) 45 MHz (d) 90 MHz

Both donor and acceptor impurities are present in the combination of (a) Phosphorous - Arsenic (b) Aluminium - Antimony (c) Boron - Gallium (d) Arsenic - Antimony

A cable has an insulation of relative permittivity 2. If the insulation is replaced by one of relative permittivity 4, then capacitance of the cable (a) is doubled (b) is halved (c) remains unchanged (d) is reduced

If temperature of a radiating body is 1500 °C, the wavelength at which maximum radiant energy occurs is (a) 2.87 µm (b) 1.63 µm (c) 1.01 µm (d) 20.85 µm

In any atom the potential energy of an orbiting electron is   (A) always positive (B) always negative (C) sometime positive, sometime negative (D) numerically less then its kinetic energy.

In order to generate electron-hole pairs, the maximum wavelength of radiation for Silicon (Band gap = 1.1 eV) is  (a) 1.88 μm (b) 1.68 μm (c) 1.13 μm (d) 1.54 μm

Which of the following is true regarding the band-gap energy of a semiconductor ? (A) Minimum energy required to break a covalent bond (B) On breaking of the bond, electron is generated (C) On breaking of the bond, electron-hole pair is generated (D) A & C both are true

The coefficient of reflection for current wave is

The velocity of travelling wave through a cable of relative permittivity 36 is

The average life of neutrons after they decay is

Which of the following statements is not characteristic of a static magnetic field? (A) It is solenoidal. (B) It is conservative. (C) It has no sinks or sources. (D) Flux lines are always closed.

Angles project true size only when the plane containing the angle and plane of projection are  (a) Aligned (b) Adjacent (c) Perpendicular (d) Parallel

X-rays are used for the study of crystal structure because  (a) X-rays are completely absorbed by the crystal (b) the wavelength of X-ray is of the same order of magnitude in the inter-atomic spacing in crystals (c) the wavelength of X-rays is very small in comparison with the inter-atomic spacing in crystals (d) the crystals are completely transparent to X-rays

What are the basic laws of physics?

What are the basics of physics?

What is the charge and mass of an electron?

State the factors on which severity of electric shock depends.

Write the factors on which capacity of parallel plate condenser depends.

The sensitivity of a closed loop system to gain changes and load disturbances depends upon (a) forward gain (b) loop gain (c) frequency (d) all the above

A system is causal if the output of any time depends only on   (A) Values of input in the past and in the future (B) Values of input at that time and in the past (C) Values of input at that time and in the future (D) none