# Assume that D1 and D2 in figure are ideal diodes. The value of current I is

26 views
in Diode

Assume that D1 and D2 in figure are ideal diodes. The value of current I is

A)0mA B) 0.25mA C) 0.5 mA D)1.0mA

Assume that D1 and D2 in figure are ideal diodes. The value of current I is 0mA

## Related questions

Assume that the n-channel MOSFET shown in figure is ideal and that its threshold voltage is +1 .0 V. The voltage Vab between nodes a and b is A)5V B)2V C)1V D)0V

A voltage signal 10 Sinwt is applied to the circuit with ideal diodes, as shown in figure. The maximum and minimum values of the output waveform vout of the circuit are respectively

The output voltage V0 ofthe Schmitt trigger shown in figure swings between +15V and —1 5V. Assume that the operational amplifier is ideal. The output will change from +1 5 V to -1 5V when the instantaneous value of the input sine wave is  A) 5 V in the positive slope only B) 5 V in the negative slope only C) Vin the positive and negative slopes D) 3 V in the positive and negative slopes

As shown in the figure, 1 ohm resistance is connected across a source that has a load line v + i = 100. The current through the resistance is A) 25 A B) 50 A C) 100 A D) 200A

In a P-N diode, assume that P-side is lightly doped and N-side is heavily doped. Based on this information, which of the following statement is true ? (A) Depletion region is more extended in P-side than N-side (B) Depletion region is more extended in N-side than P-side (C) Depletion region would be equal on both sides (D) Not enough information provided to give answer

When current dramatically increases, the voltage point on the diode forward V-I characteristic curve is called the  A) Breakdown voltage B) Knee voltage C) Barrier voltage D) Both B) and C) are true

The internal resistances of an ideal current source, and an ideal voltage source are, respectively, (A) 0, ∞ (B) ∞, ∞ (C) ∞, 0 (D) 0,0

The light emitted diodes consist of: (1) Si (2) GaAs (3) Ge (4) Diamond

Is it true or false that electron flow and conventional current are in opposite directions?

In a three-phase system, when the loads are perfectly balanced, the value of neutral current is equal to: A. Zero B. One-third of the maximum value C. Two -third of the maximum value D. The maximum value

What is the value of Inductance of a coil that induces 20 V when the current through the coil changes from 12 to 20 A in 2 seconds? A. 2 H B. 3 H C. 4 H D. 5 H

An A.C current is given by i=100sin100. It will achieve a value of 50 A after (1) 1/600 sec (2) 1/300 sec (3) 1/1800 sec (4) 1/900 sec

A zener voltage regulator has load requirements of 12 V and 2 A. The zener diode minimum current requirement is 0.2 A. The minimum voltage at input is 24 V. What is the required value of series resistance with source? A) 5.45 Ω B) 6 Ω C) 7.2 Ω D) 6.38 Ω

When The dc converter in figure shown has a resistance load of R = 10 Ω and the input voltage is Vs 220 V the converter switch remains on, its voltage drop is Vo -2 V. The chopping frequency is fI K sW Vs If the duty cycle is 50%, determine: (a) the average output voltage V (b) the RMS output voltage Vo (c) the converter efficiency (d) the effective input resistance of the converter

For the circuit shown in figure, the Boolean expression for the output y in terms of inputs P, Q, R and S is

You are measuring the current in a circuit that is operated on an 18 V battery. The ammeter reads 40 mA. Later you notice the current has dropped to 20 mA. How much has the voltage changed? A.9 V B.900 mV C.0 V D.18 V

For the given voltage and current, the value of voltage regulation of a line for lagging loads with decrease in power factor (a) decreases (b) increases (c) remains same (d) either (a) or (c)

The rms value of the current in a wire which carries a d.c. current of 10 A and a sinusoidal alternating current of peak value 20 A is  (A) 10 A (B) 14.14 A (C) 15 A (D) 17.32 A

Twelve volts are applied across a resistor. A current of 3 mA is measured. What is the value of the resistor? A.4 ohms B.400 ohms C.4 kohms D.4.4 ohms

Two parallel conductors are separated by a distance, d carrying a current, I in the same direction. The magnetic field along a line running parallel to the conductors and midway between them is (A) zero (B) proportional to I (C) proportional to d (D) proportional to the permeability of the medium.

Consider the star network shown in figure. The resistance between terminals A and B with C open is 6 ohms, between terminals B and C withAopen is 11 ohms and between terminals C andAwith B open is 9 ohms. Then RA, RB, RC respectively is

A network contains linear resistors and ideal voltage sources. If values of all the resistors are doubled then the voltage across each resistor will

A network contains linear resistors and ideal voltage sources. If values of all the resistors are doubled, then voltage across each resistor is  A) Halved B) Doubled C) Increases by 4 times D) Remains the same

Consider the following statements : Any element connected in  1. Series with an ideal current source is redundant. 2. Parallel with an ideal current source is redundant. 3. Series with an ideal voltage source is redundant. . 4. Parallel with an ideal voltage source is redundant.  Which of the above statements is/are correct ?

The formula to find I when the values of V and R are known is? A.I = VR B.I = R/V C.V = IR D.I = V/R

If 5000 kW power is transmitted at 220 kV in place of 11 kV, reduction in the value of electric current will be (a) 90% (b) 95% (c) 5% (d) 10%

If eight -tenths coulomb passes a point in 4 s, the value of current is equal to: A. 1.6 A B. 16 A C. 2 A D. 0.2 A

In a 3-phase voltage source inverter used for speed control of induction motor, anti-parallel diodes are used across each switching device. The main purpose of diodes is to:

Why is it that protons are not considered a source of moving charges for current flow?

In IC, transistors are utilised as diodes.To get highest breakdown voltage for such diode, it is adjusted to have  A) Ie=0 B) Ic=0 C) Vcb=0 D) Vce=0

A sine wave voltage is applied across an inductor. When the frequency of the voltage is decreased, the current decreases.

Register and counters are similar in the sense that they both   (A) count pulses (B) store binary operation (C) shift operation (D) made from an array of flip flops and gates integrated on a single chip

At a particular temperature and current density, the critical magnetic field for a Type I superconductor is Bc and that for a type II superconductor ranges from Bc1 to Bc2 keeping other parameters unloaded. both superconductors are now subjected to a magnetic field B that satisfies the conditions B>Bc and Bc1 < ... will maintain a vortex state  (d) Type I superconductor will switch to the normal conducting state, while Type II superconductor will maintain a vortex sate

When ‘n’ resistances each of value ‘r’ are connected in parallel, then the resultant resistance is ‘x’. When these ‘n’ resistances are connected in series, total resistance is  (A) n2X (B) X/n (C) n2/X (D) nX2

Three resistances of 3 Ω each are connected in delta. The value of the resistances in the equivalent star is : (A) 27 (B) 9 (C) 1.5 (D) 1 Ω

A signal other than the reference input that tends to affect the value of controlled variable is known as ?

The region consisting of holes and electrons near the p-n junction of a diode is (A) diffusion region (B) neutral zone (C) recombination region (D) depletion region

Which of the following is the name given to resistance of thin films that are uniform in thickness? A) Area resistance B) Sheet resistance C) Filmy resistance D) None of these

The frequency of the clock signal applied to the rising edge triggered D flip-flop shown in figure is 10 KHZ. The frequency of the signal at Q is A) 10 KHz B) 2.5 KHz C) 20 KHz D) 5 KHz

When both the inductance and resistance of a coil are doubled the value of?

The base kV and base MVA are halved and the per unit impedance new value is 0.5. The per unit impedance of the original circuit element is (A) 0.25 (B) 0.5 (C) 0.625 (D) 1.0

Which of the following diodes is limited to the reverse-bias region in its region of operation?  (1) Schottky (2) Tunnel (3) Photodiode (4) Rectifier

In an amplitude modulated wave. the value of V is max 10V and Vmin is 5V, then % modulation is : (A) 25% (B) 33.3% (C) 50% (D) 100%