# Is BJT current controlled or voltage controlled?

69 views

BJT is a current controlled device.
Current controlled
Current control
by

BJT is current controlled device.

## Related questions

A current controlled voltage source is equivalent to :  (A) series voltage feed -back amplifier (B) shunt current feed -back amplifier (C) shunt voltage feed -back amplifier (D) series current feed -back amplifier

A 3 -phase, fully controlled, converter is feeding power into a DC load at a constant current of 150 A, the rms value of the current flowing through each thyristor of the converter is

The speed of a three-phase induction motor is controlled by variable voltage variable frequency control (i.e. keeping V/f constant). As the frequency is reduced, the slip at maximum torque  (1) Decreases (2) Increases (3) Remains constant (4) None of the above

In voltage source converter based HVDC transmission system the active power is controlled by changing (A) phase angle of the converter ac input voltage (B) supply frequency of the converter ac input voltage (C) magnitude of the converter ac input voltage (D) DC voltage at the inverter terminals

For a 15-bus power system with 3 voltage controlled buses, the size of Jacobian matrix is

When the firing angle a of a single-phase, fully controlled rectifier feeding constant direct current into a load is 30°, the displacement power factor of the rectifier is

If the base current of a BJT is 250 µA and emitter current is 15 mA, then the common base current gain will be A) 0.98 B) 0.41 C) 59 D) 55

An FET is a better chopper than a BJT because it has (A) lower offset voltage (B) higher series ON resistance (C) lower input current (D) higher input impedance

What is a BJT?

Draw circuit diagram of voltage divider biasing list two advantages of voltage divider biasing of BJT.

How are nuclear reactors controlled? Explain two different methods in brief.

A 230 V, 50 Hz phase controlled single-phase full-controlled SCR bridge converter draws 15 A constant dc current. If the source inductance is 3 mH, the drop in dc output voltage is (A) 4.5 V (B) 6.75 V (C) 9 V (D) 13.5 V

How many servos can be controlled by Arduino?

Chopper controlled DC motor

Which phenomenon is present in thyristors but absent in BJT, MOSFET and IGBT ? (A) forward conduction (B) latching (C) forward blocking (D) reverse breakdown

What is the difference between BJT and FET?

What is a BJT amplifier?

Is the input impedance of MOSFET more than BJT and FET?

What is the difference between beta and forced beta for BJT?

Operating frequency of power MOSFET is higher than that of power BJT. Justify the statement.

What is the value of Beta in power BJT?

List configurations of BJT.