# A compact microstrip antenna may be obtained by

9 views
in Physics
A compact microstrip antenna may be obtained by

A compact microstrip antenna may be obtained by cutting slot on the patch

## Related questions

1 answer 25 views
0 answers 14 views

By which of the following connections, one-bit binary counter can be obtained from a JK flip-flop?  A) J = K = 0 B) J = K = 1 C) J = K’ D) None of these

1 answer 23 views
1 answer 12 views

Leakage fluxes in a transformer may be minimized by : (A) Avoiding overloads (B) Keeping magnetizing current minimum (C) Reducing the reluctance of the iron core to minimum (D) Sectionalizing and interleaving the primary and secondary windings

1 answer 71 views
1 answer 14 views

"Any number of current sources in parallel may be replaced by a single current source whose current is the algebraic sum of individual source currents and source resistance is the parallel combination of individual source resistances". The above statement is associated with?

0 answers 20 views

If the antenna diameter in a radar system is increased by a factor of 4, the maximum range will be increased by a factor of  (a) 2 (b) 4 (c) 8 (d) 16

1 answer 19 views

The instantaneous power in ac circuits can be obtained by taking product of the instantaneous values of

1 answer 10 views

The state equations in the phase variable canonical form can be obtained from the transfer function by (a) Cascade decomposition (b) Direct decomposition (c) Inverse decomposition (d) Parallel decomposition

0 answers 21 views

Which parameter or quantity may be measured by use of Maxwell's Bridge ? (A) Resistance (B) Capacitance (C) Inductance (D) Frequency

0 answers 21 views

In a static over-current relay, inverse time characteristics are obtained by   (a) A differentiating circuit (b) An integrating circuit (c) A transistor amplifier (d) A transistor switch

1 answer 13 views

The external characteristic of a shunt generator can be obtained directly from its – characteristic   1. internal 2. open-circuit 3. load-saturation 4. Performance

0 answers 17 views

Which of the following permutation can be obtained in the output (in the same order) using a stack assuming that the input is the sequence 1, 2, 3, 4, 5 in that order?  (1) 3, 4, 5, 1, 2 (2) 3, 4, 5, 2, 1 (3) 1, 5, 2, 3, 4 (4) 5, 4, 3, 1, 2

1 answer 58 views

Starting torque can be obtained in the case of a single phase induction motor with identical main and auxiliary windings by connecting:  (1) A capacitor across the mains (2) A capacitor in series with the machine (3) A capacitor is series with the auxiliary winding (4) Equal value capacitors in series with the main and the auxiliary windings

1 answer 125 views
0 answers 16 views

To increase gain of a parabolic reflector antenna by 6dBi, the correct statement is : ( Assuming efficiency 70%) a. Diameter is to be increased to 6 folds b. Diameter is to be increased to 4 folds c. Diameter is to be increased to 2 folds d. None of above

0 answers 14 views

In an axial mode operation of a helical antenna, maximum field radiated by the antenna is :  A) along the axis of the helical B) in a plane normal to the helix antenna axis C) in both axial and normal planes D) None of the above

0 answers 16 views

A pair of synchronous machines on the same shaft may be used to generate power at 60 Hz from given source of power at 50 Hz. Using minimum number of poles for both the machines, the synchronous speed will be (a) 500 r.p.m. (b) 600 r.p.m. (c) 1000 r.p.m. (d) 1200 r.p.m.

2 answers 48 views

An Auto-transformer (which has only one winding) may be used as a ______ .  (A) Both Step-Up and Step-Down transformer (B) Step-Down Transformer (C) Step-Up Transformer (D) None of these

0 answers 12 views

During 3-phase short circuit on a unloaded alternator, the dc component may be zero in (1) One phase only (2) Any two phases (3) All three phases (4) None of the above

0 answers 7 views

In a d.c. compound generator, ‘flat-compound’ characteristic, required for certain applications, may be obtained by connecting a variable resistance  A) Across the series field B) In series with the series field C) In parallel with the shunt field D) In series with the shunt field

1 answer 12 views
1 answer 13 views
1 answer 21 views

A heavy ladder resting on floor and against a vertical wall may not be in equilibrium, if?

1 answer 17 views
0 answers 30 views

A cable has an insulation of relative permittivity 2. If the insulation is replaced by one of relative permittivity 4, then capacitance of the cable (a) is doubled (b) is halved (c) remains unchanged (d) is reduced

1 answer 55 views
1 answer 19 views

Two port networks are connected in cascade. The parameters of the network are obtained by multiplying in individual

0 answers 14 views

Short-circuit kVA is obtained by multiplying the base kVA by (1) 10% X (2) 20% X (3) 50% X (4) 100% X

1 answer 8 views
0 answers 17 views

Gauge factor of about 5 can be obtained using strain gauge made of  A) Constantan B) Ferry C) Nichrome V D) Platinum

1 answer 12 views

Earth coverage dish antenna is used in satellite system. It is characterized by the fact that  (a) It is a narrow beam antenna (b) It is Parabolic antenna (c) it is sharply focused within a small area of the surface of the earth (d) it is a wide angle antenna which covers a large area of the surface of the earth

0 answers 50 views
1 answer 17 views

Full load current of an Induction motor is 20 Ampere. The no-load current may be expected to be: A) 25 Ampere to 28 Ampere B) 15 Ampere to 18 Ampere C) 11 Ampere to 14 Ampere D) 6 Ampere to 10 Ampere

1 answer 13 views

The polar bonds existing in III-V compound semiconductor, may be considered as equivalent to  (a) 1 ionic bond and 3 covalent bonds (b) 1 ionic bond and 4 covalent bonds (c) 2 ionic bonds and 2 covalent bonds (d) 2 ionic bonds and 4 covalent bonds

1 answer 13 views

The rating of transformer may be expressed in ____________.  (A) kVAR (B) kW (C) kVA (D) Horse power

1 answer 7 views
1 answer 5 views
1 answer 12 views

For an antenna to be frequency-independent, it should expand or contract in proportion to the  (a) gain (b) directivity (c) wavelength (d) impedance

0 answers 6 views

Which technology is used in Compact disks?  A) Mechanical B) Electrical C) Electro Magnetic D) Laser

0 answers 8 views

Super conducting materials can be used for (a) ore refining. (b) magnetic levitation in high speed trains. (c) medical resonance imaging. (d) All of the above

1 answer 23 views

A reading of 120 is obtained when a standard inductor was connected in the circuit of a Q-meter and the variable capacitor is adjusted to a value of 300 pF. A lossless capacitor of unknown value Cx is then connected in parallel with the variable capacitor and the same reading was obtained when the variable capacitor is readjusted to a value of 200 pF. The value of Cx in pF is  A) 100 B) 200 C) 300 D) 500

1 answer 24 views

A single-phase transformer has no-load loss of 64 W, as obtained from an open circuit test. When a short-circuit test is performed on it with 90% of the rated currents flowing in its both LV and HV windings, he measured loss is 81 W. The transformer has maximum efficiency when operated at  (A) 50.0% of the rated current (B) 64.0% of the rated current (C) 80.0% of the rated current (D) 88.8% of the rated current

0 answers 25 views

Lissajous pattern obtained on a CRO screen is a circle. Frequency of two signals are   (a) Equal (b) Unequal (c) Zero (d) Infinity

0 answers 7 views

A circular radiation pattern is obtained using  A) Travelling wave antenna (TWA) B) Rhombic antenna C) Yagi antenna D) Turnstile antenna

1 answer 7 views
1 answer 21 views

"Maximum power output is obtained from a network when the load resistance is equal to the output resistance of the network as seen from the terminals of the load". The above statement is associated with?

0 answers 18 views

In a stable control system saturation may cause : (A) Conditional Stability (B) High Level Oscillations (C) Overdamping (D) Low Level Oscillations

1 answer 11 views

If a line is 100 % series compensated it may result into series resonance at power frequency of?

1 answer 23 views

A force acting on a body may?