19 views
in Switchgear And Protection by
A loss of excitation protection scheme for large generating unit employs

A) under frequency relays

B) offset Mho relay

C) reactance relay

D) percentage differential relay

1 Answer

0 votes
by

A loss of excitation protection scheme for large generating unit employs offset Mho relay

Related questions

1 answer 20 views

The type of backup protection scheme widely used in the field is (A) Relay backup (B) Breaker backup (C) Remote backup (D) Auxiliary backup

asked May 12, 2018 in Switchgear And Protection by Shimroz123
1 answer 42 views

For complete protection of a three-phase line: A) three Phase relays and three Earth fault relays are required B) three Phase relays and two Earth fault relays are required C) two Phase relays and two Earth fault relays are required D) two Phase relays and one Earth fault relay are required

asked Jun 17, 2018 in Switchgear And Protection by Shimroz123
1 answer 53 views

A relay used for protection of motors against overload is :  (A) Impedance relay (B) Electromagnetic attraction type (C) Thermal relay (D) Buchholz's relay

asked May 8, 2018 in Switchgear And Protection by Shimroz123
1 answer 366 views

A negative sequence relay is used for protection of  (1) Generator (3) Motor (2) Transformer (4) Long Transmission lines

asked May 1, 2018 in Switchgear And Protection by Shimroz123
1 answer 16 views

A series resistance is added to the over-current relay in a bus bar differential protection scheme which: a. Helps to develop some voltage across it which otherwise should appear across the relay and is dangerous b. Helps to dissipate some power which is needed by the relay to function properly c. Helps to counter the effects of CT saturation and lowers the pickup value of the relay d. All of the above 

asked Sep 1, 2018 by Shimroz123
1 answer 22 views

If the area of hysteresis loop of a material is large, the hysteresis loss in this material will be?

asked Mar 25, 2018 in Electrical Engineering by Shimroz123
1 answer 29 views

 For the protection of parallel feeders fed from one end, the relays used are: A) non-directional relays at the source-end and directional relays at the load-end B) non-directional relays at both the ends C) directional relays at the source-end and non-directional at the load-end D) directional relays at both the ends

asked Jun 4, 2018 in Switchgear And Protection by Shimroz123
1 answer 66 views

For protection of rotating machines against lightning surges _______ is used.  (1) lightning arrester (2) capacitor (3) combination of lightning arrester and capacitor (4) lightning conductor and arrester

asked Apr 30, 2018 in Switchgear And Protection by Shimroz123
1 answer 20 views

For complete protection ofa 3— phase line: (1) Three phase and three—earth fault relays are required (2) Three phase and two—earth fault relays are required (3) Two phase and two—earth fault relays are required (4) Two phase and one-earth fault relays are required

asked May 22, 2018 in Switchgear And Protection by Shimroz123
1 answer 25 views

Reactance relay is normally preferred for protection against

asked Apr 29, 2018 in Switchgear And Protection by Shimroz123
1 answer 47 views

Surge absorbers are used for protection against

asked Apr 26, 2018 in Switchgear And Protection by Shimroz123
1 answer 165 views

Which type of protection is provided on a generator to protect against stator insulation failure? A) Differential protection B) Overcurrent relay C) Thermocouple actuated alarm D) Reverse power relay

asked Jun 4, 2018 in Switchgear And Protection by Shimroz123
1 answer 21 views

Blind spot is a point in the zones of protection where

asked May 8, 2018 in Switchgear And Protection by Shimroz123
1 answer 32 views

The eddy current loss in a dc generator is 400 W at 40 Hz frequency of reversal and constant flux density. When frequency is increased to 50 Hz., eddy current loss is :  (A) 256 W (B) 320 W (C) 500 W (D) 625 W

asked Apr 30, 2018 in Switchgear And Protection by Shimroz123
0 answers 55 views

Protection of transformer from all types of faults is by using (A) over current relay (B) differential relay (C) distance relay (D) Buchholz relay

asked Jun 4, 2018 in Switchgear And Protection by Shimroz123
0 answers 11 views

Which modulation scheme would you suggest for high speed data transmission over a fading channel?  A) MSK B) BPSK C) FSK D) OFDM

asked Apr 9, 2018 in Electronics communication by Shimroz123
1 answer 25 views

lf a travelling-wave travelling along a loss-less overhead line does not result in any reflection after it has reached the far end, then the far end of the line is

asked Apr 26, 2018 in Switchgear And Protection by Shimroz123
1 answer 11 views

A Hartley Oscillator is used for generating (A) very low frequency Oscillation (B) radio-frequency Oscillation (C) microwave Oscillation (D) audio-frequency Oscillation

asked Apr 26, 2018 in Electronics Engineering by Shimroz123
0 answers 17 views

Minimum wind speed required for generating electricity in a wind mill is  (a) 15 m/hour (b) 1 km/hour (c) 15 km/hour (d) None of the above 

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
1 answer 308 views

In order to regulate steady state error to zero, in a negative feedback control system, one employs

asked May 1, 2018 in Control System by Shimroz123
1 answer 35 views

For a 500 Hz frequency excitation, a 50 km long power line will be modeled as

asked Apr 29, 2018 in Power system by Shimroz123
2 answers 73 views

The maximum power in a synchronous motor (for a given excitation) is produced when the power angle is equal to: (A) 0° (B) 45° (C) 60° (D) 90°

asked Apr 11, 2018 in Computer Engineering by Shimroz123
0 answers 30 views

A system function has a pole at s=0 and a zero at s= -1. The constant multiplier is unity. For an excitation cos(t), What is the steady-state response?  (A) √2sin(t+450) (B) √2sin(t-450) (C) sin(t-450) (D) Sin(t) 

asked Apr 5, 2018 in Electrical Engineering by Shimroz123
1 answer 131 views

Primary and Backup Protection

asked Aug 9, 2017 in Switchgear And Protection by Zeeshan
1 answer 10 views

For an earth station transmitter, with an antenna output power of 40dBW 10,000W, a back-off loss of 3dB, a total branching and feeder loss of 3dB, a total branching and feeder loss of 3dB and transmit antenna gain of 4dB, the effective isotropic radiated power (EIRP will be  a) 38dBW b) 40 dBW c 36 dBW d) 47 dBW

asked Jun 15, 2018 in Electronics Engineering by Shimroz123
1 answer 54 views

Slip-Energy Recovery (SER) scheme for three phase Induction Motor

asked Aug 25, 2017 in Power Electronic Controlled Drives by Zeeshan
1 answer 9 views

What should be the value of earthing resistance for large power stations?

asked May 29, 2018 in Electrical Engineering by Shimroz123
1 answer 10 views

A series inductor is normally added in a thyrister circuit for achieving protection against:

asked May 22, 2018 in Power Electronics by Shimroz123
0 answers 62 views
asked Nov 24, 2018 by anonymous
1 answer 18 views

State the nature of protection provided for following types of faults; 1) Over voltage 2) Under voltage 3) High air pressure in air circuit 4) Low air pressure in air circuit

asked Sep 2, 2018 by Shimroz123
1 answer 10 views

State use of any four relays for the protection of traction transformer. 

asked Sep 2, 2018 by Shimroz123
1 answer 19 views

Which of the following is the least expensive protection for over current in low voltage system?  (A) Rewireable fuse (B) Isolator (C) Oil Circuit breaker (D) Air break circuit breaker

asked May 8, 2018 in Electrical Engineering by Zeeshan

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units
...