12 views
in Electrical Measurements and Instrumentation by
Two voltmeters of same range, one moving iron type and other permanent magnet moving coil type, are connected in parallel for measuring a.c. supply voltage. If the reading of MI type is 300V, the reading of PMMC type will be (a) zero (b) higher-than M.I. type (c) lower than M.I. type (d) same

Related questions

1 answer 21 views

A permanent magnet moving coil ammeter has a coil resistance of 99 ohm and Full Scale Deflection (FSD) current of 0.1mA. Shunt resistance is 1 ohm. Current through the meter at 0.5 F.S.D is:

asked May 22, 2018 in Electrical Measurements and Instrumentation by Shimroz123
2 answers 13 views
1 answer 14 views

 The main sources of Errors in Permanent Magnet moving Coil (PMMC) are due to : - a) weaking of the permanent magnet due to aging at temperature effects b) weaking of spring due to aging and temperature effects c) change of resistance of the moving coil with temperature d) all the above

asked Apr 14, 2018 in Instrumentation and control by Shimroz123
1 answer 17 views

Two voltmeters have the same range 0-400V. The internal impedance are 30,000 Ohms and 20,000 Ohms. If they are connected in series and 600V be applied across them, the readings are

asked Mar 28, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 18 views

Two non -inverting amplifiers, one having a unity gain and the other having again of twenty are made using identical operational amplifiers. As compared to the unity gain amplifier, the amplifier with gain twenty has

asked Apr 29, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 11 views

Name the material used for :- (i) Moving coil (ii) Permanent magnet in PMMC instrument.

asked Sep 6, 2018 by Shimroz123
1 answer 33 views

Two 220 volt lamps, one of 60 watt and the other of 75 watt are connected in series across a 440 volt supply. The potential difference across 60 watt lamp will be: A) 195 volt B) 220 volt C) 245 volt D) 440 volt

asked Jun 4, 2018 in Electrical Engineering by Shimroz123
1 answer 9 views

A radio receiver is placed at one corner of a table and again placed at some other corner of the same table. Loudspeaker output is changed because  (a) image interference is reduced (b) adjacent channel interference is increased (c) of fading (d) line of sight propagation is not utilized

asked May 15, 2018 in Electronics communication by Shimroz123
1 answer 40 views

Two waves have frequency of 500 Hz. One is set at its maximum value whereas the other at zero. The phase angle between them will be

asked Apr 26, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 4 views

Write one application of each: i) Permanent Magnet ii) Electromagnet 

asked Sep 4, 2018 by Shimroz123
0 answers 11 views

Series resistance required to read 0-250 V with a moving coil instrument of internal resistance 2 ohm and full scale deflection of 50 mA is (a) 49998 Ω (b) 4998 Ω (c) 498 Ω (d) 49.8 Ω

asked May 26, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 20 views

A moving coil instrument has a resistance of 10 W and gives full scale deflection when carrying a current of 50 mA. To measure current upto 100 A, we will have to connect • 10 W resistance in series • 10 W resistance in parallel • 10/1999 W resistance in series • 10/1999 W resistance in parallel

asked May 13, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 26 views

A moving coil of meter has 100 turns, and a length and depth of 10mm and 20mm respectively. It is positioned in a uniform radial flux density of 200 mT. The coil carrier current capacity is 50 mA. The torque on the coil is

asked Apr 29, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 10 views

 In dynamometer type of wattmeter, which of the coil is split up into two parts?

asked May 29, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 26 views

An iron cored inductance coil can be modelled, over a normal operating range of networks ,as A) non-Linear bilateral element B) linear bilateral element C) linear time varying element D) non-linear time invariant element

asked May 24, 2018 in Electrical Engineering by Shimroz123
1 answer 10 views

Two sinusoidal signals of the same frequency are displayed on a dual-trace oscilloscope. One complete cycle of each signal covers 6 cm of the horizontal scale and the starting point of the horizontal scale and the starting point of the two signals are separated by 0.5 cm. The phase difference between the two signals in degrees is  (a) 30 (b) 45 (c) 60 (d) 90

asked May 15, 2018 in Digital Instrumentation by Shimroz123
0 answers 22 views

The distance between two coil sides which are connected to the same commutator segment is called as  (1) winding pitch (2) back pitch (3) front pitch (4) full pitch

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
1 answer 13 views

A bulb in a staircase has two switches, one switch being at the ground floor and the other one at the first floor. The bulb can be turned ON and also can be turned OFF by any one of the switches irrespective of the state of the other switch. The logic of switching of the bulb resembles  (A) and AND gate (B) an OR gate (C) an XOR gate (D) a NAND gate

asked May 18, 2018 in Digital Electronics by Shimroz123
1 answer 21 views

The main purpose of permanent magnet motors are (A) to avoid the need for field supply (B) to provide high flux density (C) to provide control over flux level (D) to facilitate kW rating

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
1 answer 33 views

A 150 V moving iron voltmeter of accuracy class 1.0 reads 75 V when used in a circuit under a standard conditions. The maximum possible percentage error in the reading is:

asked Mar 28, 2018 in Electrical Measurements and Instrumentation by Shimroz123
0 answers 10 views

Moving coil instruments have which one of the following scales ? (a) Logarithmic scale (b) Uniform scale (c) Non-uniform scale (d) Squared scale 

asked May 26, 2018 in Physics by Shimroz123
1 answer 24 views

A permanent magnet stepper motor with 8 poles in stator and 6 poles in rotor will have a step angle of (a) 7.5° (b) 15° (c) 30° (d) 60°

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
2 answers 114 views

Advantages and Disadvantages of Permanent Magnet Brushless DC (PMBLDC) Motor

asked Aug 9, 2017 in Electronics Engineering by Zeeshan
0 answers 50 views

A single phase transmission line and a telephone line are both symmetrically strung one below the other, in horizontal configurations, on a common tower, The shortest and longest distances between the phase and telephone conductors are 2.5 m and 3 m respectively. The voltage (volt/km) induced in the telephone circuit, due to 50 Hz current of 100 amps in the power circuit is (A) 4.81 (B) 3.56 (C) 2.29 (D) 1.27

asked May 25, 2018 in Power system by Shimroz123
1 answer 21 views

Two copper conductors have equal length. The cross-sectional area of one conductor is four times that of the other. If the conductor having smaller cross-sectional area has a resistance of 40 ohms the resistance of other conductor will be?

asked Mar 25, 2018 in Basic concepts by Shimroz123
0 answers 19 views

The moving iron voltmeter indicates (a) the same value for dc and ac voltages. (b) lower values for ac voltage than for corresponding dc voltage. (c) higher value for ac voltage than for corresponding dc voltage. (d) none of these. 

asked May 25, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 26 views

Horizontally mounted moving iron instruments use   (a) Eddy current damping (b) Electromagnetic damping (c) Fluid friction damping (d) Air friction damping

asked May 13, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 58 views

An unshielded moving iron voltmeter is used to measure the voltage in an AC circuit. The stray DC magnetic field having a component along the axis will be  (1) unaffected (2) decreased (3) increased (4) either decreased or increased depending on the direction of the DC field

asked Apr 29, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 195 views
1 answer 24 views

Two sinusoidal signals having the same amplitude and frequency are applied to the X and Y inputs of a CRO. The observed Lissajous figure is straight line. The phase shift between the two signals would be (1) Zero (2) 90 degrees (3) Either zero or 180 degrees (4) Either 90 degrees or 270 degrees  

asked May 28, 2018 in Electronics Engineering by Shimroz123
1 answer 7 views

What is permanent magnet and electromagnet?

asked Sep 4, 2018 by Shimroz123
0 answers 13 views

The moving system of an indicating type of electrical instrument is subjected to (a) a deflecting torque (b) a controlling torque (c) a damping torque (d) All of the above

asked May 26, 2018 in Electrical Measurements and Instrumentation by Shimroz123

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units
...