# The capacitance of a capacitor is not affected by

69 views
The capacitance of a capacitor is not affected by (a) Plate area (b) Plate separation (c) Nature of dielectric (d) Plate thickness

## Related questions

If a capacitance is charged by a square wave current source, then the voltage across the capacitor will be (a) Square wave (b) Step function (c) Triangular wave (d) Zero

The stability of the power system is not affected by  (1) generator reactance (2) line reactance (3) line losses (4) output torque

To a highly inductive circuit, a small capacitance is added in series. The angle between voltage and current will _____.

What happens to current flow in a capacitive circuit when the DC voltage across the capacitor is approximately equal to the source voltage?

The sag of a transmission line is least affected by (A) Self weight of the conductor. (B) Temperature of the surrounding air. (C) Current through the conductor. (D) Ice deposited on the conductor.

Under constant load conditions, the speed of a d.c. motor is affected by?

If the filter capacitance is increased, the ripple will (a) remain same (b) increase (c) decrease (d) be zero

A coil with large distributed capacitance has _____.

In a parallel plate capacitor of capacitance Co, the electric field is E. If a dielectric slab with dielectric constant = 7 is introduced to fill capacitor completely, the electric field will become (a) 7E (b) E/7 (c) E/3.5 (d) E. Co

What is the capacitance when a capacitor passes a current of 31.43 mA when supplied with 40 V AC with a frequency of 1000 Hz? A) 0.125 F B) 0.125 μF C) 1257.2 μF D) None of these

The capacitor connected in series with the line is used to  A) enhance power factor B) enhance power system capability C) decrease the losses D) decrease the power transfer

Capacitance grading of cable implies A) grading according to capacitance of cables per kilometer length B) cables using single dielectric in different concentrations C) use of dielectrics of different permeabilities D) capacitance required to be introduced at different length to counter the effect of inductance

A capacitor of capacitance 50 micro farads is charged to a potential difference of 200 Volts. Find out energy stored in the condenser?

Which of the following can be used to measure the capacitance of a capacitor? A) Rheostat B) Schering bridge C) Wheatstone bridge D) None of these

With the help of which bridge are the capacitance and dielectric loss of a capacitor generally measured ?

Reduction in the value of capacitance of a capacitor -start motor, results in reduced: (A) noise (B) speed (C) starting torque (D) armature reaction

The capacitance of the capacitor is directly proportional to the

What happens to the capacitance if mica is inserted between the plates of an air capacitor? A) The capacitance increases B) The capacitance decreases C) The capacitance remains the same D) The capacitance becomes zero

The reactance offered by a capacitor to an alternating current of frequency 50 Hz is 10 ohm. If frequency is increased to 100 Hz, the reactance will be (a) 2.5 ohm (b) 5.0 ohm (c) 20.0 ohm (d) 40.0 ohm

The reactance offered by a capacitor to alternating current of frequency 50 Hz is 20 Q. If frequency is increased to 100 Hz, reactance becomes_____ohms.

Tool life is most affected by : (A) cutting speed (B) tool geometry (C) feed and depth (D) microstructure of material being cut

A choke coil having resistance RΩ and of inductance L Henry is shunted by a capacitor of C farads. The dynamic impedance of the resonant circuit would be:  (A) R/LC (B) C/RL (C) L/RC (D) 1/RLC

The operation of the relay which is most affected due to arc resistance is A) Mho relay B) Reactance relay C) Impedance relay D) All are equally affected

The lock range of PLL is not governed by  A) Low pass filter B) VCO C) Amplifier D) Phase detector

Dielectric loss in a capacitor is best measured by (A) Wien Bridge (B) Schering Bridge (C) Anderson Bridge (D) Heaviside-Campbell Equal Ratio Bridge

A capacitor-start single phase induction motor is switched on to supply with its capacitor replaced by an inductor of equivalent reactance value. It will?

Power factor of an inductive circuit is usually improved by connecting capacitor to it in?

Capacitance is the ability of a body to store an__________.  (A) electrical charge (B) electric current (C) voltage (D) All of the above

Timing resistor of a monostable using 555 is 100 kOhm. The timing capacitance (in nF) required for pulsewidth of 100mS is about  A) 100 B) 300 C) 600 D) 900

Which of following parameter passing mechanism is supported by C++, but not by C,  (1) call by value (2) call by reference (3) call by value-result (4) All of these

Which flag does not change by the execution of the instruction DCR B in 8085 microprocessor ?  (a) Parity (b) Carry (c) Zero (d) Sign

A certain common-emitter amplifier has a voltage gain of 100. If the emitter bypass capacitor is removed.  a. The circuit will become unstable b. The voltage gain will decrease  c. The voltage gain will increase d. The circuit will become stable

If the voltage applied across a capacitor is triangular in waveform, the waveform of the current is (a) Triangular (b) Rectangular (c) Sinusoidal (d) Trapezoidal

At an industrial sub-station with a 4 MW load, a capacitor of 2 MVAR is installed to maintain the load power factor at 0.97 lagging. If the capacitor goes out of service, the load power factor becomes (A) 0.85 (B) 1.00 (C) 0.80 lag (D) 0.90 lag

For a single phase capacitor start induction motor, which of the following statements is valid?  A) The capacitor is used for power factor improvement B) The direction of rotation can be changed by reversing the main winding terminals C) The direction of rotation cannot be changed D) The direction of rotation can be changed by interchanging the supply terminals

For a parallel plate capacitor which is being charged out of the following the incorrect statement is   (A) Energy stored in the capacitor does not enter it through the connecting wire through the space around the wires and plates of capacitor.   (B) Rate at which energy flows into this volume is equal ... poynting vector points everywhere radially outward of the volume between plates.   (D) The poynting vector points everywhere radially in to the volume between the plates.

The purpose of connecting a capacitor in fluorescent tube circuit is • To increase switching on time • To decrease switching off time • To increase power factor • To decrease power consumption

Plate separation of a parallel plate air capacitor is reduced keeping the voltage constant. The energy stored in the capacitor shall • Increase • Decrease • Remain constant • Remain zero

An inductor of Q factor 10 is connected in series with a capacitor having a Q factor of 100. The overall Q factor of the circuit is :  (A) 100/11 (B) 11/100 (C) 110 (D) 1000

A 100 pF capacitor has a maximum charging current of 150 μA.What is the slew rate ? (A) 1.5 V/μs (B) 1.05 V/μs (C) 0.15mV/s (D) 10.5 mV/s