In a full wave rectifier with input frequency of 50 Hz, the frequency of the output is:

Question

1 Answer

Related questions

1 answer

The input frequency is 50 Hz. The ripple frequency in a 12 phase full wave rectifier is

asked Apr 23, 2018 by anonymous1 | 17 views

1 answer

Explain Center-tapped full wave rectifier with the help of circuit diagram and draw input output waveforms.

asked Jul 10 by anonymous1 | 19 views

1 answer

Explain full wave bridged rectifier with the help of circuit diagram and input output waveform.

asked Sep 5, 2018 by anonymous1 | 22 views

1 answer

The input frequency of a bridge rectifier is 50 its output frequency will be

asked May 13, 2018 by anonymous1 | 21 views

1 answer

In a half-wave rectifier, if an a.c supply is 60 Hz. Then what is the a.c ripple at output?

asked Apr 26, 2018 by anonymous1 | 19 views

1 answer

The ripple voltage in the output of a single phase half wave rectifier with 10 V rectified dc

asked May 13, 2018 by anonymous1 | 14 views

1 answer

In a 3-phase half-wave rectifier, if per phase input is 200 V, then the average output voltage is

asked May 13, 2018 by anonymous1 | 20 views

1 answer

In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary

asked May 28, 2018 by anonymous1 | 17 views

1 answer

A 400 V, 15 kW, 4-pole, 50 Hz, Y-connected induction motor has full load slip of 4%. The output torque of the

asked May 17, 2018 by anonymous1 | 17 views

1 answer

A sine wave has a frequency of 50 Hz. Its angular frequency is _______ radian/second.

asked Mar 24, 2018 by anonymous1 | 84 views

1 answer

Rectification efficiency of a full wave rectifier without filter is nearly equals to:

asked Apr 9, 2018 by anonymous1 | 48 views

1 answer

The stator of a 415V, 50 Hz, 4-pole slip ring Induction Motor is excited by rated frequency with slip rings open

asked Jun 17, 2018 by anonymous1 | 23 views

1 answer

In a full wave rectifier the negative point in a circuit is

asked May 17, 2018 by anonymous1 | 10 views

1 answer

Draw the circuit diagram of bridge rectifier with π filter. Draw its input and output waveform.

asked Jul 10 by anonymous1 | 27 views

1 answer

In a three phase half wave rectifier feeding resistive load, if the input source is a three phase 4 wire system

asked May 22, 2018 by anonymous1 | 18 views

1 answer

The corona loss in a 50 Hz system is 0.25 kW/ph/km. At a frequency of 60 Hz, the corona loss

asked May 13, 2018 by anonymous1 | 36 views

0 answers

When The dc converter in figure shown has a resistance load of R = 10 Ω and the input voltage is Vs 220 V the converter switch remains on, its voltage drop is Vo -2 V. The chopping frequency is fI K sW Vs If the duty cycle is 50%, determine: (a) the average output voltage V (b) the RMS output voltage Vo (c) the converter efficiency (d) the effective input resistance of the converter

asked Apr 26 by Hussein | 122 views

0 answers

A 50 Hz, 3—phase induction motor has a full load speed of 1440 rpm. The number of poles of the motor is: ...

asked Apr 9, 2018 by anonymous1 | 20 views

0 answers

The power input to the rotor of a 400V, 50 Hz 6 pole three phase induction motor is 20kW. The slip is 3%...

asked Apr 14, 2018 by anonymous1 | 23 views

1 answer

Determine the output frequency for a frequency division circuit that contains 12 flip–flops with an input

asked May 28, 2018 by anonymous1 | 31 views

0 answers

The output clock frequency for a frequency division circuit having 11 flipflops with an input clock frequency ..

asked Apr 14, 2018 by anonymous1 | 17 views

2 answers

The equation of 50 Hz current sine wave having r.m.s. value of 60 A is?

asked Mar 25, 2018 by anonymous1 | 248 views

0 answers

A three phase diode bridge rectifier is fed from a 400 V rms, 50 Hz, three phase a.c. source. For the purely

asked May 25, 2018 by anonymous1 | 26 views

1 answer

An accelerometer has input range of 0 to 10g, natural frequency 30 Hz and mass 0.001 kg. The range of the

asked Apr 26, 2018 by anonymous1 | 16 views

0 answers

Output of an op-amp is a square wave of 4 V peak to peak with a rise time of 5 microsecond and fall time...

asked Apr 9, 2018 by anonymous1 | 20 views

1 answer

An AC supply of 230 V is applied to half wave rectifier circuit. A transformer turns ratio is 20 : 1. Find i) Output DC voltage (ii) Peak Inverse Voltage (PIV)

asked Jul 10 by anonymous1 | 16 views

1 answer

The transformer utilization factor of full wave bridge rectifier is

asked May 17, 2018 by anonymous1 | 6 views

1 answer

The reactance offered by a capacitor to an alternating current of frequency 50 Hz is 10 ohm. If frequency is

asked May 25, 2018 by anonymous1 | 52 views

1 answer

The reactance offered by a capacitor to alternating current of frequency 50 Hz is 20 Q....

asked Mar 24, 2018 by anonymous1 | 27 views

1 answer

The threshold effect in demodulators is a The rapid fall of output SNR when the input SNR falls below

asked Jun 15, 2018 by anonymous1 | 13 views

1 answer

In a three phase controlled bridge rectifier with an increase of overlap angles the output dc voltage

asked May 23, 2018 by anonymous1 | 15 views

0 answers

A single phase 230 V/ 150 V , 1 kVA, 50 Hz transformer is supplied by 230 V AC supply. Find the full load primary and secondary current.

asked Sep 1, 2018 by Quiz | 26 views

1 answer

A 400 V, 50 Hz three-phase induction motor rotates at 1440 rpm on full -load. The motor is wound for

asked Apr 29, 2018 by anonymous1 | 33 views

1 answer

The synchronous speed for the seventh space harmonic mmf wave of a 3-phase, 8-pole, 50 Hz induction

asked May 17, 2018 by anonymous1 | 25 views

1 answer

When a sine wave has a frequency of 100 Hz in 12 s it goes through?

asked May 15, 2018 by anonymous1 | 22 views

0 answers

The total output offset voltage for a noninverting amplifier with input resistance 1 kOhm , feedback...

asked Apr 5, 2018 by anonymous1 | 23 views

0 answers

A single phase, half-wave, controlled rectifier has 400 sin (314 t) as the input voltage and R as the load...

asked Apr 10, 2018 by anonymous1 | 60 views

1 answer

If the input to a differentiating circuit is a saw-tooth wave, then output will be …………….. wave:

asked Jun 4, 2018 by anonymous1 | 22 views

1 answer

When the initial slope of input sine wave is greater than the slew rate of an OPAMP, the output:

asked May 29, 2018 by anonymous1 | 28 views

1 answer

A single-phase, 230 V, 50 Hz ac mains fed step down transformer (4:1) is supplying power to a half-wave

asked May 18, 2018 by anonymous1 | 9 views

1 answer

A single phase transformer is designed to operate from 50 Hz, 1100 V supply and to have an output voltage

asked May 25, 2018 by anonymous1 | 14 views

1 answer

lf slip of an induction machine is 0.02 and the stator supply frequency is 50 Hz, what will be the frequency...

asked Apr 9, 2018 by anonymous1 | 29 views

0 answers

The order of the sub-harmonic during SSR for 50 Hz normal frequency is?

asked Mar 27, 2018 by anonymous1 | 19 views

0 answers

A balanced Delta connected load supplied with 440 V 50 Hz three phase AC supply has R=10 Ohm and L=0.6 mH in is each arm. Calculate line and phase current, active power.

asked Aug 12, 2018 by Quiz | 41 views

1 answer

An amplifier without feedback has a voltage gain of 50, input resistance 1kΩ and output resistance of 2.5kΩ.

asked May 29, 2018 by anonymous1 | 28 views

0 answers

For a two port network, with output shorted, V1=25V, I1=1 A,I2=2A. With input open circuited,...

asked Apr 9, 2018 by anonymous1 | 19 views

1 answer

A single-phase full-bridge diode rectifier delivers a load current of 10A, which is ripple free.

asked May 13, 2018 by anonymous1 | 14 views

1 answer

An AC supply of 230 V is applied to a half-wave rectifier circuit through a transformer having primary to

asked Jun 18, 2018 by anonymous1 | 43 views

1 answer

What is full wave rectifier?

asked Sep 18, 2017 by Quiz | 12 views

1 answer

In computer system Scanner is _________device. A. Input B. Output C. Both D. None

asked Apr 12, 2018 by anonymous1 | 19 views

anonymous1 · Answer 1 · 2018-05-29T16:49:29+0000

In a full wave rectifier with input frequency of 50 Hz, the frequency of the output is: 100 Hz

In a full wave rectifier with input frequency of 50 Hz, the frequency of the output is:

Please log in or register to add a comment.

Please log in or register to answer this question.

1 Answer

Please log in or register to add a comment.

Related questions