Can you help by answering this question?

The term backlash is associated with?

33 views
in Physics by
If an atom loses one or more electrons, it becomes _____.

2 Answers

0 votes
by

If an atom loses one or more electrons, it becomes electrically positive

0 votes
by
It   becomes   positively  charged    atom.

Related questions

1 answer 25 views

What is the flow of electrons from one atom to another called?

asked Mar 14, 2018 in Electrical Engineering by Quiz
1 answer 7 views

It becomes more difficult to remove?

asked Mar 25, 2018 in Basic concepts by Shimroz123
1 answer 16 views

Which have more free electrons: conductors or insulators? 

asked Jul 1 by Zeeshan
0 answers 30 views

A cable has an insulation of relative permittivity 2. If the insulation is replaced by one of relative permittivity 4, then capacitance of the cable (a) is doubled (b) is halved (c) remains unchanged (d) is reduced 

asked May 25, 2018 in Physics by Shimroz123
1 answer 8 views

A neutral atom with an atomic number of five has electrons equal to: A. 1 B. 5 C. none D. depends on the type of atom

asked Apr 12, 2018 in Electrical Engineering by Shimroz123
1 answer 17 views

In any atom the potential energy of an orbiting electron is   (A) always positive (B) always negative (C) sometime positive, sometime negative (D) numerically less then its kinetic energy.

asked May 16, 2018 in Physics by Shimroz123
1 answer 60 views

To read or write a complete word from / to the memory in 8086 microprocessor and if it is located at an even address, the number of Read or Write cycles required is

asked May 23, 2018 in Microprocessors and Microcontrollers by Shimroz123
0 answers 9 views

If a ferromagnetic material is heated upto Curie temperature, it becomes (a) Permanent magnet (b) Anti-ferromagnetic material (c) Diamagnetic material (d) Paramagnetic material 

asked May 25, 2018 in Electrical Engineering by Shimroz123
1 answer 7 views

 For a NAND gate, when one or more inputs are low then the output will be A) Low B) High C) Alternately high and low D) High or low depending on relative magnitude of inputs 

asked Jun 17, 2018 in Digital Electronics by Shimroz123
0 answers 20 views

Which of the following is a group of one or more attributes that uniquely identifies a row?  (1) Key (2) Tuple (3) Determinant (4) Relation

asked Apr 10, 2018 in Computer Engineering by Shimroz123
2 answers 27 views

A network which contains one or more than one source of e.m.f. is known as?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 7 views

The probability of a photon ionizing an atom or molecule is maximum when (hv-eVi) is as small as: a. 0.5 b. 1.5 c. 3.5 d. 10 

asked Sep 1, 2018 by Shimroz123
3 answers 34 views

A radioactive isotope has a half-life of 10 days. If today there are 125 g of it left, what was its original weight 40 days earlier  (a) 600 g (b) 1000 g (c) 1250 g (d) 2000 g 

asked Apr 9, 2018 in Physics by Shimroz123
1 answer 23 views

At very high temperatures, extrinsic semiconductor becomes intrinsic semiconductor because (A) Of drive in diffusion of dopants & carriers. (B) Band to band transition dominates impurity ionization. (C) Impurity ionization dominates band to band transition. (D) Band to band transition is balanced by impurity ionisation.

asked Apr 28, 2018 in Physics by Shimroz123
1 answer 18 views

The number of electrons in the outer most orbit of carbon atom is?

asked Mar 25, 2018 in Basic concepts by Shimroz123
0 answers 11 views

What is the movement of electrons from atom to atom is called?

asked Mar 14, 2018 in Electrical Engineering by Quiz
0 answers 36 views

An ideal DC generator is one that has _____ voltage regulation (a) low (b) high (c) zero (d) positive

asked Apr 9, 2018 in Electrical Engineering by Shimroz123
1 answer 9 views

In which material, valence electrons are tightly bounded to their parent atoms ? (a) Conductor (b) Semiconductor (c) Insulator (d) Magnetic 

asked May 26, 2018 in Physics by Shimroz123
1 answer 12 views

Form the hot metal surface electrons escape because   (A) of change of state from metal to gas due to heat. (B) of change of state from gas to metal (C) the energy supplied is greater than the work function (D) the energy is greater than Fermi level

asked May 17, 2018 in Physics by Shimroz123
1 answer 17 views

 If the range of an analog transducer is 0 to 10 V, then for a resolution of 5 mV, the bits of ADC will be _____.

asked May 29, 2018 in Transducers and sensors by Shimroz123
0 answers 67 views

If one of the control springs of PMMC ammeter is broken when it is connected in a circuit, the meter will read  A) Half the correct value of current B) Twice the correct value of current C) An indefinite figure D) Zero

asked Apr 9, 2018 in Electrical Engineering by Shimroz123
1 answer 12 views

For an antenna to be frequency-independent, it should expand or contract in proportion to the  (a) gain (b) directivity (c) wavelength (d) impedance

asked May 15, 2018 in Electronics communication by Zeeshan
1 answer 41 views

In a galvanometer, the deflection becomes one half when the galvanometer is shunted by a 20 ohm resistor. The galvanometer resistance is 

asked May 22, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 82 views

A drawn wire of resistance 5 Ω is further drawn so that its diameter becomes one-fifth of the original. What is its resistance with volume remaining the same ? (a) 25 Ω (b) 125 Ω (c) 625 Ω (d) 3125 Ω

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
1 answer 11 views
1 answer 37 views

If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes?

asked Mar 25, 2018 in Basic concepts by Shimroz123
0 answers 18 views

Which is more temperature stable, a carbon-composition or a metal-film resistor? 

asked Jul 2 by Shimroz123
1 answer 24 views

Which relay is more sensitive ? 1 VA or 2 VA ? (A) 1 VA (B) 2 VA (C) Both are equally sensitive (D) Both are insensitive

asked May 12, 2018 in Switchgear And Protection by Shimroz123
0 answers 23 views

The fact that the same operation may apply to two or more classes is called what?  (1) Inheritance (2) Polymorphism (3) Encapsulation (4) Multiple classification 

asked Apr 10, 2018 in Computer Engineering by Shimroz123
0 answers 18 views

Which of the following test is carried out to ensure the sufficient strength of insulation between two or more conductors to avoid leakage between them ?   (a) Testing of insulation resistance between wiring and earth (b) Testing of insulation resistance between conductors (c) Testing of polarity of single phase switch (d) Testing of earth continuity path 

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
1 answer 28 views

Which motor have more efficiency, synchronous motor or induction motor?

asked Mar 18, 2018 in Synchronous machine by Shimroz123
0 answers 18 views

Is more power dissipated in series or parallel?

asked Mar 10, 2018 in High voltage engineering by Quiz
1 answer 24 views

Two series resistors are connected to an ac source. If there are 7.5 V rms across one resistor and 4.2 V rms across the other, the peak source voltage is? A.16.54 V B.1.65 V C.10.60 V D.5.93 V

asked May 15, 2018 in Basic concepts by Shimroz123
1 answer 40 views

In an induction motor if the flux density is reduced to one-half, of its normal value then the torque will  (1) reduce to one-half (2) reduce to one-fourth (3) remain unchanged (4) increase four times

asked May 1, 2018 in Electrical Machine by Shimroz123
1 answer 21 views

An 800 kV transmission line has a maximum power transfer capacity of P. If it is operated at 400 kV with the series reactance unchanged, the new maximum power transfer capacity is approximately (A) P (B) 2P (C) P / 2 (D) P / 4

asked May 25, 2018 in Power system by Shimroz123
1 answer 15 views

An unsaturated dc shunt motor runs at its rated speed when rated voltage is applied to it. If the supply voltage to the motor is reduced by 25%, the speed of the motor  (a) Increases by 25% (b) Remains the same (c) Decreases by 25% (d) Decrease only slightly by an amount less than 25% 

asked May 13, 2018 in Power Electronics by Shimroz123
0 answers 40 views

If an energy meter disc makes 10 revolutions in 100 seconds when a load of 450W is connected to it, the meter constant in revolutions per kWh is  A) 1000 B) 500 C) 1600 D) 800

asked Apr 9, 2018 in Electrical Engineering by Shimroz123
1 answer 10 views

If an induction machine is run at above synchronous speed, it acts as

asked Mar 27, 2018 in Power system by Shimroz123
0 answers 10 views

Moving coil instruments have which one of the following scales ? (a) Logarithmic scale (b) Uniform scale (c) Non-uniform scale (d) Squared scale 

asked May 26, 2018 in Physics by Shimroz123
3 answers 62 views

The open loop control system is one in which _____.

asked May 29, 2018 in Control System by Shimroz123
1 answer 104 views

The 8086 fetches instruction one after another from _____ of memory.   (a) Code segment (b) IP (c) ES (d) SS

asked May 13, 2018 in Electrical Engineering by Shimroz123
1 answer 95 views

"In any network containing more than one sources of e.m.f. the current in any branch is the algebraic sum of a number of individual fictitious currents (the number being equal to the number of sources of e.m.f.), each of which is due to separate action of each source of e.m.f., taken in order ... sources of e.m.f. are replaced by conductors, the resistances of which are equal to the internal resistances of the respective sources". The above statement is associated with?

asked Mar 25, 2018 in Network Analysis by Shimroz123

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments loss measure operation connected signal low applications effect single-phase network inductance temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units
...