# The comfort conditions in air conditioning are :

8 views
The comfort conditions in air conditioning are : (A) 22 ºC dry bulb temperature and 60% relative humidity (B) 25 ºC dry bulb temperature and 100% relative humidity (C) 20º C dry bulb temperature and 75% relative humidity (D) 15º C bulb temperature and 80% relative humidity

The comfort conditions in air conditioning are : 22 ºC dry bulb temperature and 60% relative humidity

## Related questions

1 Ton (unit of air conditioning load) in terms of kW is   (a) 3.5 kW (b) 4.7 kW (c) 12 kW (d) 10.5 kW

Explain why filters are used in signal conditioning.

Air is normally dehumidified by : (A) injecting water (B) passing steam (C) heating (D) cooling

Two metallic blocks having masses in the ratio 2:3 are made to slide down a frictionless inclined plane starting from rest position. When the blocks reach the bottom of the inclined plane, they will have their kinetic energies in the ratio : (A) 2:3 (B) 3:5 (C) 3:2 (D) 7:4

List the different techniques used for signal conditioning in DAS. Explain in brief Any one signal conditioning technique.

When the initial conditions of a system are specified to be zero it implies that the system is?

The efficiency of a centrifugal pump is maximum when its blades are : (A) straight (B) bent forward (C) bent backward (D) bent forward first and then backward

The cold chisels are made by 1. Drawing 2. Rolling 3. Forging 4. Piercing

State and explain different signal conditioning techniques used in DAS.

Describe logarithmic conversion signal conditioning in DAS.

Explain the concept of initial and final conditions in switching for L and C.

For a waveform to be expressed in Fourier series, which of the following conditions must be satisfied? I. Maxwell’s conditions, II. Drichlet conditions, III. Sampling Theorem A) I only B) II only C) II and III only D) I, II and III

Which of the following plants will take least time in starting from cold conditions to full-load operation? A) Nuclear power plant B) Steam power plant C) Hydro-electric power plant D) Gas turbine plant

If the number of conditions in a decision table is n, the maximum number of rules (columns) possible is  A) n B) 2n C) 2n D) log2n

Structural sections such as rails, angles, I-beams are made by 1. Hot rolling 2. Hot drawing 3. Hot piercing 4. Hot extrusion

State the nature of protection provided for following types of faults; 1) Over voltage 2) Under voltage 3) High air pressure in air circuit 4) Low air pressure in air circuit

In air-core cable the surge voltage travels approximately at the speed of light and a cable of 100m length gives a delay of a. 0.666μsec b. 0.333μsec c. 1.555μsec d. 1μsec

In inventory control theory, the economic order quantity is : (A) average level of inventory (B) optimum lot size (C) capacity of a warehouse (D) lost size corresponding to break-even analysis

In value engineering, the term value refers to : (A) manufacturing cost of the product (B) selling price of the product (C) total cost of the product (D) utility of the product

The usual ratio of forward and return stroke in shaper is : (A) 2:1 (B) 1:2 (C) 2:3 (D) 3:2

In a clock mechanism, the gear train used to connect minute hand to hour hand, is : (A) Epicyclic gear train (B) Reverted gear train (C) Compound gear train (D) Simple gear train

Which of the following medium is employed for extinction of arc in air circuit breaker ? (a) Water  (b) Oil (c) Air  (d) SF6

The effect of increasing the length of air gap in an induction motor is to increase the (a) power factor (b) speed (c) magnetising current (d) air gap flux

The equipment installed in power plants to reduce air pollution due to smoke is (A) Induced draft fans (B) De -super heaters (C) Electrostatic precipitators (D) Re -heaters

The true statement for wave propagation in rectangular wave guides filled with air is: a. The phase velocity is equal to velocity of light in air b. The phase velocity is always more than the velocity of light in air c. The phase velocity is always less than the velocity of light in air d. The phase velocity is un-defined.

In case of four pole, lap wound machine if the air gap under each pole is the same, then what will be the result?  (A) There will be reduced eddy currents (B) There will be reduced hysteresis loss (C) Current in each path will not be the same (D) It will result in higher terminal voltage

Explain fuel system and air intake system in diesel electric power plant.

A fluid in equilibrium cannot sustain : (A) tensile stress (B) compressive stress (C) shear stress (D) bending stress

In axial flow fans and turbines, fluid enters and leaves as follows : (A) radially, axially (B) axially, radially (C) axially, axially (D) radially, radially

Binding material used in cemented carbide tools is : (A) Nickel (B) Cobalt (C) Chromium (D) Silicon

In die casting, machining allowance is 1. Small 2. Large 3. Very large 4. Not provided

Speed of light in air is:  A) 4000km/s B) 300000000m/s C) 400km/s D) 3000000 m/s

An air gap is usually inserted in magnetic circuits to?

List the conditions for parallel operation of three phase transformer.

Under which of the following conditions is a DC motor provided with compensating winding used?  1. Wide range of speed control above normal  2. Wide range of steady load variation with no speed control  3. Wide range of rapid variation in load.   Select the correct answer using the codes given below:   (a) 1, 2 and 3 (b) 2 and 3 (c) 1 and 2 (d) 1 and 3

The power factor of an induction motor under no load conditions will be close to (A) 0.2 lagging (B) 0.2 leading (C) 0.5 lagging (D) Unity

A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the

A Hurwitz polynomial D(s) must satisfy two conditions. One is the polynomial is real when s is real. What is the other condition ?