14 views
in Digital Electronics by
The current mode logic (CML) is same as A) LSI B) CMOS C) TTL D) ECL

1 Answer

0 votes
by

The current mode logic (CML) is same as ECL

Related questions

1 answer 14 views

Read the following statements: i. Gate is a combinational logic. ii. JK Flip-flop in toggle mode is not combinational logic. iii. MSJK Flip-flop suffers from race-around. iv. Counters are sequential circuits. Which choice is correct? (A) i, ii (B) i, ii, iv (C) ii, iii, iv (D) i, ii, iii

asked May 24, 2018 in Digital Electronics by Shimroz123
1 answer 18 views

The complete set of only those Logic Gates designated as Universal Gates is  (A) NOT, OR and AND Gates (B) XNOR, NOR and NAND Gates (C) NOR and NAND Gates (D) XOR, NOR and NAND Gates

asked May 18, 2018 in Digital Electronics by Shimroz123
1 answer 41 views

Which one of the following logic circuit has the highest speed as compared to the currently available logic circuits? A) Resistance-transistor logic B) Emitter-coupled logic C) Integrated-injection logic D) Diode-transistor logic 

asked Jun 17, 2018 in Digital Electronics by Shimroz123
1 answer 22 views
1 answer 22 views

Which of the following quantity maintains the same direction whether a D.C. machine runs as a generator or as a motor a. Induced e.m.f. b. Armature Current c. Field Current d. Supply Current  

asked Sep 1, 2018 by Shimroz123
1 answer 22 views

The output Y of a 2-bit comparator is logic 1 whenever the 2-bit input A is greater than the 2-bit input B. The number of combinations for which the output is logic 1, is  (A) 4 (B) 6 (C) 8 (D) 10

asked May 18, 2018 in Digital Electronics by Shimroz123
1 answer 12 views

What is not true in the context of “Don’t Care Condition” in digital logic ? (A) It corresponds to combination of logic variables whose value is not defined (B) It can be assumed to be 0 or 1 (C) It can be assumed to be 1 only (D) It helps in simplification of logic function

asked May 12, 2018 in Digital Electronics by Shimroz123
1 answer 8 views

The following logic families have their propagation delay. Arrange them from lowest propagation delay to highest propagation delay. 1. TTL (Standard) 2. ECL 3. Low power CMOS 4. DTL (A) 2, 1, 4 and 3 (B) 2, 4, 1 and 3 (C) 4, 2, 3 and 1 (D) 1, 2, 3 and 4

asked May 24, 2018 in Digital Electronics by Shimroz123
1 answer 13 views

Which of the following circuits come under the class of sequential logic circuits ?   P. Full adder   Q. Full subtractor   R. Half adder   S. JK flip   T. Counter   Select the correct answer from the codes given below: (a) P and Q (b) Q and R (c) R and S (d) S and T

asked May 13, 2018 in Digital Electronics by Shimroz123
1 answer 17 views

Which of the following gates can be used to realize all possible combinational logic functions?  (i) OR gate (ii) NOR gate (iii) Exclusive OR gate (iv) NAND gate (v) AND gate  (A) (iii), (iv) and (v)  (B) (i), (iii) and (iv)  (C) (ii) and (iv)  (D) (i) and (v)

asked Apr 30, 2018 in Digital Electronics by Shimroz123
1 answer 10 views

Among the logic families, the family which can be used at very high frequency greater than 100 MHz in a 4 bit synchronous counter is

asked Mar 29, 2018 in Digital Electronics by Shimroz123
1 answer 28 views

Eighteen thousand watts is the same as? A.18 mW B.18 MW C.18 kW D.18 μW

asked May 15, 2018 in Basic concepts by Shimroz123
1 answer 37 views

Potier reactance of an alternator is almost the same as   (a) Field winding reactance (b) Total armature reactance (c) Leakage reactance of field winding (d) Armature leakage reactance

asked May 13, 2018 in Electrical Engineering by Shimroz123
0 answers 16 views

Multiplicity is the same as what concept for an ERD?  (1) Relationship (2) Entity (3) Attribute (4) Cardinality 

asked Apr 10, 2018 in Computer Engineering by Shimroz123
0 answers 22 views

The distance between two coil sides which are connected to the same commutator segment is called as  (1) winding pitch (2) back pitch (3) front pitch (4) full pitch

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
1 answer 10 views
1 answer 15 views

The circuit whose properties are same in either direction is known as?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 46 views

In MOSFET, the polarity of the inversion layers is the same as that of?

asked Mar 19, 2018 in MOSFET by Shimroz123
1 answer 9 views

 When A = 0., B = 0, C = 1 then in two input logic gate we get gate  (A) XOR gate (B) AND gate (C) NAND gate (D) NOR gate

asked May 17, 2018 in Digital Electronics by Shimroz123
1 answer 8 views

Logic state 0 in positive logic corresponds to   1. zero voltage 2. positive voltage 3.higher voltage level 4. lower voltage level 

asked May 13, 2018 in Digital Electronics by Shimroz123
0 answers 40 views

When a resistor R is connected to a current source, it consumes a power of 18 W. When the same R is connected to a voltage source having the same magnitude as the current source, the power absorbed by R is 4.5 W. The magnitude of the current source and the value of R are  (A) √18A and 1Ω (B) 3A and 2Ω (C) 1A and 18Ω (D) 6A and 0.5Ω 

asked Apr 5, 2018 in Electrical Engineering by Shimroz123
1 answer 17 views

In the 8421 BCD code the decimal number 125 is written as   (A) 1111101 (B) 0001 0010 0101 (C) 7D (D) None of the bove

asked May 17, 2018 in Digital Electronics by Shimroz123
1 answer 28 views

One newton meter is same as?

asked Mar 25, 2018 in Basic concepts by Shimroz123
0 answers 69 views
1 answer 16 views

A servo motor works on the same basic principle as that of a : - a) two phase induction motor b) single phase induction motor c) three phase induction motor d) synchronous motor

asked Apr 14, 2018 in Instrumentation and control by Shimroz123
1 answer 29 views

The effective resistance of a conductor will be the same as ohmic resistance when : -  a) current is in true sine wave form b) voltage is low c) power factor is unity d) current is uniformly distributed in the conductor cross-section

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
1 answer 4 views

Name the effect of electric current observed in electroplating. Explain the same.

asked Jul 5 by Shimroz123
1 answer 43 views

Two parallel conductors are separated by a distance, d carrying a current, I in the same direction. The magnetic field along a line running parallel to the conductors and midway between them is (A) zero (B) proportional to I (C) proportional to d (D) proportional to the permeability of the medium. 

asked Jun 4, 2018 in Electrical Engineering by Shimroz123
1 answer 16 views

In a series parallel circuit, any two resistances in the same current path must be in?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 10 views

Registers in which data is entered or taken out in serial form are referred as   (A) left shift register (B) right shift register (C) shift registers (D) none of the above

asked May 17, 2018 in Digital Electronics by Shimroz123
1 answer 8 views

Hexadecimal number system is used as a s hand language for representing  1. decimal number 2. binary number 3.octal number 4. all the above 

asked May 13, 2018 in Digital Electronics by Shimroz123
1 answer 22 views
0 answers 34 views

 Can we create a digital circuit that has as inputs the  3- bit digital words [2: 0] A, [2: 0] B and [2: 0] C and its output is  equal to      |C-A-B| . The circuit of the binary full adder is known.

asked Aug 11, 2018 in Digital Electronics by vasilishmty97
1 answer 9 views

After firing as SCR, the gating pulse is removed. The current in the SCR will  1. remain the same 2. immediately fall to zero 3. rise up 4. None 

asked May 13, 2018 in Power Electronics by Shimroz123
0 answers 22 views

The power supply whose output voltage varies with variation in input voltage or output load current is known as   (a) Regulated Power Supply (b) Unregulated Power Supply (c) Uninterruptible Power Supply (d) Switched Mode Power Supply 

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
1 answer 11 views
1 answer 11 views

A certain SRAM has CS=0, WE=0 and OE=1. In which the following mode, this SRAM is operating: a) Read b) Write c) Stand By d) None of the above

asked May 23, 2018 in Computer Engineering by Shimroz123
1 answer 18 views

A rectangular waveguide is 5.1 cm by 2.4 cm (inside dimension). The cut off frequency of the dominant mode is

asked May 23, 2018 in Electrical Engineering by Shimroz123

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units

8,450 questions

7,047 answers

132 comments

3,085 users

...