# An inductor is connected in series with SCR to protect it from

16 views
in Inductor
An inductor is connected in series with SCR to protect it from A) Excessive high voltage B) Excessive high dv/dt C) Excessive high di/dt D) Excessive large forward current

An inductor is connected in series with SCR to protect it from Excessive high di/dt

## Related questions

An inductor of Q factor 10 is connected in series with a capacitor having a Q factor of 100. The overall Q factor of the circuit is :  (A) 100/11 (B) 11/100 (C) 110 (D) 1000

A circuit breaker is designed to protect an electrical circuit from damage caused by :  (A) Over load (B) Short circuit (C) Over current (D) All of the above

We connected a 35V dc supply to a resistance of 600 Ohm in series with an unknown resistance R.A. voltmeter having a resistance of 1.2 kOhm is connected across 600 Ohm resistance and read 5v. The value of resistance R will be

To protect the power transformer (Y-Y with neutral grounded) against fault, what type of connection do the CTs have ?

Explain the characteristics of inductor to be considered while designing it. What is the effect of over current and increase in temperature on inductor.

In a 3-phase converter circuit during commutation when one SCR in one phase is turned on to turn-off an SCR in another phase, results in (A) voltage notching (B) harmonic distortion (C) voltage sag (D) voltage swell

SCR is more utilized as compared to Triac because it is

Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero

IDMT relays are used to protect the transformer against :  (A) Internal short -circuits (B) Open circuits (C) External short circuits (D) Oil leakage

A 40 W bulb is connected in series with a room heater. If now 40 W bulb is replaced by 100 W bulb, the heater output will?

What is the difference between a coil and an inductor?

An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when A) ZL = R B) ZL = jXS C) ZL = R-jXS D) ZL = R+jXS

In a 230 V, 50 Hz single-phase SCR bridge converter operating at a firing delay angle, α and with large R-L load, the input source current is (A) sinusoidal current (B) constant dc current (C) continuous rectangular pulses (D) alternating rectangular pulses

What is back EMF in inductor?

An SCR without any external connections is considered as (A) two diodes in series (B) three diodes in series (C) two n-p-n transistors in series (D) two p-n-p transistors in series

What is the difference between a thyristor and an SCR?

Two resistors are said to be connected in series when?

Cells are connected in series in order to?

What are the types of power losses in inductor?

How do you test an SCR?

What is holding current and latching current in SCR? Draw the gate characteristics of an SCR and explain the characteristics. What are the different signals which can be used for turning on SCR by gate control? compare them.

What is the total resistance if 5 resistors of 20 Ω each are connected in series? A) 100 Ω B) 4 Ω C) 20 Ω D) None of these

Why inductor current lags inductor voltage ?

Explain design constraint of filter inductor design.

Explain the iterative inductor design procedure. Show the design procedure flowchart.

A capacitor-start single phase induction motor is switched on to supply with its capacitor replaced by an inductor of equivalent reactance value. It will?

Two 100W, 200V lamps are connected in series across a 200V supply. The total power consumed by each lamp will be in Watts

Two resistances Rl and Ri are connected in series across the voltage source where Rl>Ri. The largest drop will be across?

In an ac series RLC circuit, the voltage across R and L is 20 V; voltage across L and C is 9 V and voltage across RLC is 15 V. What is the voltage across C?

Why SCR is called as thyristor?

Is a SCR a thyristor?

What is the use of SCR?

When a pure inductor is connected in series with a lamp circuit, effect is: -  a) Dimmer b) Brighter c) Same d) Fused

A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the

Series capacitive compensation in EHV transmission line is used to

In a series R-C circuit, with the increase in frequency, current (A) Reduces (B) Increases (C) Does not change (D) Becomes zero