# As per Shannon’s channel capacity theorem, if samples are transmitted in ‘T’ seconds over a noisy channel

38 views
As per Shannon’s channel capacity theorem, if samples are transmitted in ‘T’ seconds over a noisy channel which is bandlimited to ‘B’ Hz. The number of samples ‘n’ is given by (symbols/notations carry their usual meaning) A) B/T B) T/B C) 2BT D) BT/2

As per Shannon’s channel capacity theorem, if samples are transmitted in ‘T’ seconds over a noisy channel which is bandlimited to ‘B’ Hz. The number of samples ‘n’ is given by (symbols/notations carry their usual meaning) A) B/T B) T/B C) 2BT D) BT/2

## Related questions

What is the channel capacity of a noisy channel with conditional probability of error p = 1/2? A) 0 B) 1 C) Infinity D) 2

If it takes a transmitted signal 1m sec to go up to the target and come back after reflection, how far is the transmitter from the target? A) 150 Km B) 150 m C) 15 Km D) 1500 m

The superposition theorem requires as many circuits to be solved as there are?

What is channel length modulation in MOSFET?

The transit time of the current carriers through the channel of a JFET decides it's?

How electricity is transmitted and distributed?

How the electricity is transmitted?

Breaking capacity of a circuit breaker is usually expressed in terms of  (1) Ampere (2) Volts (3) MW (4) MVA

Norton’s theorem states that a complex network connected to a load can be replaced with an equivalent impedance (A) in series with a current source (B) in parallel with a voltage source (C) in series with a voltage source (D) in parallel with a current source

How many characters per sec (7 bits + 1 parity) can be transmitted over a 2400 bps line if the transfer is synchronous (1 start bit and 1 stop bit)?  A) 300 B) 240 C) 250 D) 275

The threshold voltage of an n- channel enhancement mode MOSFET is 0.5V when the device is biased at a gate voltage of 3V. Pinch off would be occurs at a drain voltage of (A) 1.5V (B) 2.5V (C) 3.5V (D) 4.5V

The analog signal given below is sampled by 600 samples per second for m(t) = 3 sin 500 pt + 2 sin 700 pt then folding frequency is: (1) 500 Hz (2) 700 Hz (3) 300 Hz (4) 1400 Hz

While calculating Rth in Thevenin's theorem and Norton equivalent?

In Thevenin's theorem, to find Z?

Can you apply Thevenin's theorem in an AC circuit?

Can we apply Norton's theorem in an AC circuit?

Power station having Load factor = 70%, capacity factor = 50%, used factor = 60%, maximum demand = 20MW then annual energy production is  (1) 122.8 GWh (2) 198.55 GWh (3) 128.2 GWh (4) 188.82 GWh

Which of the following statements is incorrect ? (A) Superposition theorem is useful for Linear and Non-linear circuit analysis when several sources are present in the circuit. (B) Thevenin's equivalent network consists of one voltage source in series with an impedance. (C) Norton's equivalent network consists of ... . (D) When both the load and source impedances are purely resistive, maximum power transfer is achieved under the condition : Load Resistance = Source Resistance

Application of Norton's theorem to a circuit yields?

Maximum Power Transfer Theorem 1

Write the steps for finding the current through an element by Thevenin’s theorem.

State Thevenin’s Theorem.

State Superposition Theorem.

State superposition theorem applied to D.C. circuits.

State maximum power transfer theorem for DC circuit.

Millman's theorem yields equivalent  (1) Impedance or Resistance (3) Voltage source (2) Current source (4) Voltage or Current source

Millman's theorem yields?

The superposition theorem is applicable to?

The concept on which Superposition theorem is based is?

Superposition theorem can be applied only to circuits having?

The superposition theorem is based on the concept of ?

Why superposition theorem is not valid for power?

Can we apply the superposition theorem to AC circuit?

The bandwidth and S/N of a communication system are 3MHz and 30dB respectively. The channel capacity (in Mbps) is around  A) 30 B) 300 C) 0.3 D) None of these

If 3000 kW power is to be transmitted over a distance of 30 km, the desirable transmission voltage will be.  (A) 11 kV (B) 33 kV (C) 66 kV (D) 132 kV

The channel capacity under the Gaussian noise environment for a discrete memoryless channel with a bandwidth of 4MHz and SNR of 31 is.  a. 20 Mbps b. 4 Mbps c. 8 kbps d. 4 kbps

For AC networks, as per maximum power transfer theorem, for maximum power transfer, the source impedance should be equal to: A) twice the load impedance B) complex conjugate of load impedance C) twice the complex conjugate of load impedance D) none of these

If an energy meter disc makes 10 revolutions in 100 seconds when a load of 450W is connected to it, the meter constant in revolutions per kWh is  A) 1000 B) 500 C) 1600 D) 800