Can you help by answering this question?

The slowest ADC among the following is :

35 views
in Electronics Engineering by
TWT is basically a(n) A) Amplifier B) An oscillator C) Wideband amplifier D) Tuned amplifier 

1 Answer

0 votes
by

TWT is basically a(n) Wideband amplifier 

Related questions

1 answer 18 views

A pony motor is basically a?

asked Mar 18, 2018 in Synchronous machine by Shimroz123
1 answer 13 views

If a signal x(n)=x(–n), then it is called ____ signal. (1) Odd (2) Energy (3) Power (4) Even

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
0 answers 17 views

One of the necessary and sufficient condition for a network function N(s)=p(s)/q(s) to be a transfer function is that  A) The coefficients of the polynomial p(s) and q(s) must be real and those for q(s) must be positive B) Coefficients of p(s) and q(s) must be real and positive C) Coefficients of p(s) must be positive and real but coefficients of q(s) can be negative also D) Degree of p(s) and q(s) may differ by either zero or one only

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
1 answer 8 views

Each flip-flop in a 4-bit ripple counter introduces a maximum delay of 40 n sec. The maximum clock frequency is (a) 2.65 MHz (b) 6.25 MHz (c) 5.26 MHz (d) 6.52 MHz 

asked May 26, 2018 in Electronics Engineering by Shimroz123
0 answers 46 views

The bandwidth and S/N of a communication system are 3MHz and 30dB respectively. The channel capacity (in Mbps) is around  A) 30 B) 300 C) 0.3 D) None of these

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
0 answers 31 views
asked Nov 11, 2018 by Ganesh
1 answer 11 views

A capacitor start, capacitor run single phase induction motor is basically a : -  a) ac series motor b) dc series motor c) 2 phase induction motor d) 3 phase induction motor

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
0 answers 17 views

A megger is basically a/an   (a) Moving iron type instrument (b) Moving coil type instrument (c) Hot wire instrument (d) Electrolytic instrument

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
0 answers 11 views

AC servo-motor is basically a   (a) Capacitor motor (b) Two phase motor (c) Three phase motor (d) Universal motor  

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
1 answer 6 views
1 answer 16 views

A.C. servomotor is basically a ?

asked Mar 27, 2018 in Control System by Shimroz123
0 answers 12 views

 For identical total transmitted power, the ratio of S/N for wide band FM to S/N of DSB-AM (with ma=1) is : ( Given fm = 15 KHz & frequency. deviation =+/- 75 KHz) a. 112.5 b. 300 c. 75 d. 450

asked Apr 12, 2018 in Electronics Engineering by Shimroz123
1 answer 11 views

P-N junction is  A) a rectifier B) an amplifier C) an oscillator  D) a coupler

asked Apr 9, 2018 in Electronics Engineering by Shimroz123
0 answers 63 views

When Aluminium is deposited directly upon N type semiconductor, the diode formed has the characteristic  A) Forward current due to minority carriers B) Small delay time from on to off C) Large storage time D) Higher break down voltage

asked Apr 5, 2018 in Electronics Engineering by Shimroz123
1 answer 8 views

n-type semiconductor can be made by adding ____ to intrinsic semiconductor (A) Boron (B) Arsenic (C) Carbon (D) Germanium

asked May 12, 2018 in Electronics Engineering by Shimroz123
0 answers 20 views

The following statements are made for FETs 1. In n -channel depletion mode MOS in the active region, the control voltage VGS is negative. 2. NMOS in depletion mode is cut off for VGS=O 3. NMOS in enhance mode is cut off for VGS=O 4. There is no path between source and drain in the enhancement mode Of these, the true statements are : a. 1 and 2 only b. 1 and 3 only c. 3 and 4 only d. 1, 3 and 4 only

asked Apr 12, 2018 in Electronics Engineering by Shimroz123
1 answer 9 views

At Service provider end IMEI number of MS is basically stored in:  a. HLR b. VLR c. AUC d. EIR

asked May 17, 2018 in Telecommunication Engineering by anonymous
0 answers 17 views

In the load flow analysis, a Jacobian is a matrix of size n × n with (A) constant elements (B) upper triangular constant elements (C) first partial derivative elements (D) second partial derivative elements 

asked Jun 4, 2018 in Power system by Shimroz123
1 answer 14 views

The region consisting of holes and electrons near the p-n junction of a diode is (A) diffusion region (B) neutral zone (C) recombination region (D) depletion region 

asked Jun 4, 2018 in Diode by Shimroz123
0 answers 21 views

If diameter of each conductor of a transmission line is ‘d’, then the diameter of n-layer stranded conductor will be (a) (2n – 1) d (b) (2n + 1) d (c) (3n – 1) d (d) (3n + 1) d 

asked May 26, 2018 in Electric Power Transmission by Shimroz123
0 answers 6 views

In a network, if the number of holes is n and number of elements is e, then the number of independent mesh equations required to solve the network is (a) e – n + 1 (b) e + n + 1 (c) e + n – 1 (d) e – n – 1

asked May 25, 2018 in Node and mesh analysis by Shimroz123
1 answer 12 views

Barrier potential in a P-N junction is caused by   (A) thermally generated electrons and holes (B) diffusion of majority carriers across the junction (C) migration of minority carriers across the junction (D) flow of drift current.

asked May 17, 2018 in Diode by Shimroz123
1 answer 21 views

A material that does not allow current under normal conditions is a(n)? A.insulator B.conductor C.semiconductor D.valence

asked May 15, 2018 in Basic concepts by Shimroz123
1 answer 8 views

A 4 bit counter is used to count from 0,1,2...n. Value of “n” is

asked May 14, 2018 in Digital Electronics by Shimroz123
1 answer 12 views

When a P - N junction is forward biased  1.only electrons in N-region are injected into P-region 2.only holes in P-region are injected into N-region 3.majority carriers in each region are injected into the other region 4.minority current is reduced to zero 

asked May 13, 2018 in Semiconductor by Shimroz123
1 answer 14 views

The potential barrier at a P - N junction is due to  1. Majority carriers 2. Minority carriers 3. Both majority and minority carriers 4. Fixed donor and acceptor ions 

asked May 13, 2018 in Electrical Engineering by Shimroz123
1 answer 19 views

 If the number of branches in a network is 'B', the number of nodes is 'N' and the number of dependent loops is 'L', then the number of independent node equations will be  (a) N+L–1 (b) B–1 (c) B–N (d) N–1 

asked May 13, 2018 in Network Analysis by Shimroz123
1 answer 14 views

In a n-channel MOSFET, an inversion layer is  (A) accumulation of electrons near the surface of the substrate under the gate  (B) accumulation of electrons near the drain  (C) accumulation of electrons near the surface  (D) accumulation of hole in the substrate

asked May 12, 2018 in MOSFET by Shimroz123
1 answer 17 views

In a P-N diode, assume that P-side is lightly doped and N-side is heavily doped. Based on this information, which of the following statement is true ? (A) Depletion region is more extended in P-side than N-side (B) Depletion region is more extended in N-side than P-side (C) Depletion region would be equal on both sides (D) Not enough information provided to give answer

asked May 12, 2018 in Semiconductor by Shimroz123
1 answer 21 views

Torque developed by a three-phase, 400V, induction motor is 100 N -m. If the applied voltage is reduced to 200-V, the d'veloped torque will be

asked Apr 29, 2018 in Electrical Machine by Shimroz123
1 answer 17 views

The number of independent loops for a network with n nodes and b branches is

asked Apr 29, 2018 in Network Analysis by Shimroz123
1 answer 24 views

A binary tree T has n leaf nodes. The number of nodes of degree 2 in T is  A) log2n B) n-1 C) n D) 2n

asked Apr 11, 2018 in Computer Engineering by Shimroz123
1 answer 10 views

If the number of conditions in a decision table is n, the maximum number of rules (columns) possible is  A) n B) 2n C) 2n D) log2n

asked Apr 11, 2018 in Computer Engineering by Shimroz123
0 answers 18 views

A tuple is a(n):  (1) Column of a table. (2) two dimensional table. (3) row of a table. (4) key of a table.

asked Apr 10, 2018 in Computer Engineering by Shimroz123
0 answers 14 views

If a variable can take only integer values from 0 to n, where n is a constant integer, then variable can be represented as a bit-field whose width is the integral part of (assume base 2)  (1) log(n) +1 (2) log(n + 1) + 1 (3) log(n – 1) + 1 (4) none of these

asked Apr 10, 2018 in Computer Engineering by Shimroz123
0 answers 18 views

Which among the following is the equation for the number of independent loops for a network with n nodes and b branches?  (A) n-1 (B) b+n-1 (C) b-n+1 (D) b-n

asked Apr 5, 2018 in Electrical Engineering by Shimroz123
1 answer 31 views

Boosters are basically: -  a) inductors b) capacitors c) transformers d) synchronous motors

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
0 answers 9 views

Programmable Logical controllers are the devices that were invented basically to replace   (a) Switches (b) Circuit Breakers (c) Relays (d) None of the above

asked Apr 10, 2018 in Electrical Engineering by Shimroz123
1 answer 11 views

Explain the forward bias characteristics of a P-N Junction diode. 

asked Sep 4, 2018 by Shimroz123
2 answers 49 views

 A DC Motor develops a torque of 150 N-m. A 10 percent reduction in the field flux causes a 50 percent increase in armature current. The new value of torque is: A) 102.5 N-m B) 202.5 N-m C) 172.5 N-m D) 232.5 N-m

asked Jun 4, 2018 in DC motor by Shimroz123
0 answers 11 views

The voltage profile of a n-bus power system can be improved by controlling the (A) load angles (B) active power flows (C) reactive power flows (D) complex power flows 

asked Jun 4, 2018 in Power system by Shimroz123
0 answers 12 views

A silicon p-n junction at a temperature of 20 °C has a reverse saturation current of 10 pA. The reverse saturation current at 40 °C will approximately be (a) 30 pA (b) 40 pA (c) 50 pA (d) 60 pA

asked May 25, 2018 in Physics by Shimroz123
1 answer 6 views

The number of p-n junctions in a thyristor are  A)1 B) 2 C) 3 D) 4

asked May 20, 2018 in Power Electronics by Shimroz123
1 answer 13 views

With n nodes and b branches a network will have   (A) (b+n) links (B) b - n +1 links (C) b -n-1 links (D) b + n + 1 links 

asked May 16, 2018 in Network Analysis by Shimroz123

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units
...