# Write the relation between phase and line current, phase and line voltage for Star connection.

50 views
Write the relation between phase and line current, phase and line voltage for Star connection.

In  a star connection, line current equals  quberoot  of  phase  current    and   line  voltage  equals  phase  voltage.

Line voltage is equal to root three times of phase voltage and line and phase currents are equal in star connection

## Related questions

What is line voltage and phase voltage? Draw balanced three phase star connected system. Show all the voltages and currents.

Compare star and Delta Connection.

For a balanced three phase star connected load for which line voltage is 230V and per phase resistance and reactance is 6 Ohm and 8 Ohm respectively. Calculate: 1) phase voltage 2) line current 3) power factor 4) total power absorbed

What is the difference between line and phase current?

What is the difference between line and phase voltage?

What is difference between Star and Delta Connection?

What is the voltage in 3 phase line?

If an unsymmetrical line to ground fault occurs at the secondary terminals of a delta/star, ungrounded transformer, then  (A) zero sequence currents are present on both sides of the transformer  (B) zero sequence currents are absent on both sides of the transformer  (C) zero sequence currents are present on the secondary side but not on the primary side  (D) zero sequence currents are present on the primary side but not on the secondary side

A 3-phase voltage source inverter operates in 180° conduction mode with a star connected resistive load. If input dc voltage is 100 V, then the peak to peak output line voltage is :

What is the difference between a line voltage and low voltage control system?

What is a three phase connection?

Which of the following connection of transformers will give highest value of secondary voltage ? (A) Delta primary delta secondary (B) Delta primary star secondary (C) Star primary star secondary (D) Star primary delta secondary

Define α & β and derive the relation between (α) &) (β) of transistor.

Draw the waveform of three phase AC supply voltage.

For 11kV line the inductance per km per phase will be of the order of:  (A) 1 H (B) 0.1 H (C) 1 mH (D) 0.1 mH

Draw the phasor diagram for Star connected balanced system.

Draw the Delta connected three phase system showing all the voltages and currents. Write the power equation.

Define: 1) voltage ratio, 2) current ratio, 3) transformation ratio of transformer.

The line current in a balanced delta system is 30 A. The load current is (A) 30√3 A (B) 30/√3 A (C) 10 A (D) 30/√2 A

A single core cable is designed to work for a single phase system with a peak voltage of 220 kV. The maximum permissible stress in the dielectric is not to exceed 20 kV/mm. For economical size, the overall core diameter of the cable is (A) 28.2 mm (B) 26.4 mm (C) 24.4 mm (D) 22.0 mm

Is the power line voltage available in our homes a dc or an ac voltage?

Explain the principle of ON-OFF control and phase control of AC voltage controller with suitable circuit and waveforms.

Which of the following is the least expensive protection for over current in low voltage system?  (A) Rewireable fuse (B) Isolator (C) Oil Circuit breaker (D) Air break circuit breaker

A zener voltage regulator has load requirements of 12 V and 2 A. The zener diode minimum current requirement is 0.2 A. The minimum voltage at input is 24 V. What is the required value of series resistance with source? A) 5.45 Ω B) 6 Ω C) 7.2 Ω D) 6.38 Ω

The internal resistances of an ideal current source, and an ideal voltage source are, respectively, (A) 0, ∞ (B) ∞, ∞ (C) ∞, 0 (D) 0,0

A network is said to be under resonance when the voltage and the current at the network input terminals are (A) in phase (B) out of phase (C) in phase quadrature (D) in phase, and have equal magnitudes

The product of apparent power and cosine of the phase angle between circuit voltage and current is?

The phase difference between voltage and current wave through a circuit element is given as 30°. The essential condition is that?

The power consumed in a circuit element will be least when the phase difference between the current and voltage is?

Explain lagging quantity and leading quantity, explain this concept with voltage and current waveform

Step-down transformer converts high voltage and low current into:  (A) How voltage and high current (B) High voltage and low current (C) Low voltage and high current (D) None of the above

The armature current on symmetrical 3 phase short circuit of a synchronous machine (salient pole)  (A) has q -axis current only (B) has d -axis current only (C) has both d and q axis currents (D) cannot be divided between q and d axis currents

In an alternator at lagging power factor the generated voltage per phase as compared to that at unity power factor?

Why the read of 3 phase voltage is 440?

Which of the following theorems enables a number of voltage (or current) source to be combined directly into a single voltage (or current) source. (1) compensation theorem (2) reciprocity theorem (3) superposition theorem (4) Millman's theorem

Electrical shock happens for voltage/current?

Which of the following 3-phase connection of a transformer causes interference with the neighbouring communication lines:  (A) Delta-Star (B) Star-Delta (C) Delta-Delta (D) Star-Star

Why inductor current lags inductor voltage ?

A current controlled voltage source is equivalent to :  (A) series voltage feed -back amplifier (B) shunt current feed -back amplifier (C) shunt voltage feed -back amplifier (D) series current feed -back amplifier

A network that consists of at least a voltage source or current source is called A) Active network B) Ideal network C) Sourced network D) Outsourced network

Why does increase in current mean a decrease in voltage?