Ask a Question
Why INDIA has 50hz and USA has 60hz frequency cycle of current?
Because USA is cold country then india
to add a comment.
← Prev Question
Next Question →
to answer this question.
Because India uses 220-230volt
In USA there they uses 110volt
to add a comment.
A3-phase, 5.5kW, 440V, 50Hz, cylindrical rotor S.M has synchronous reactance of (0+j2) Ω/phase
Is 50hz or 60hz better?
When The dc converter in figure shown has a resistance load of R = 10 Ω and the input voltage is Vs 220 V the converter switch remains on, its voltage drop is Vo -2 V. The chopping frequency is fI K sW Vs If the duty cycle is 50%, determine: (a) the average output voltage V (b) the RMS output voltage Vo (c) the converter efficiency (d) the effective input resistance of the converter
An instantaneous value of an alternating voltage having 50hz frequency and max value of 100v at 0.01sec is
Derive the relationship between Synchronous speed (Ns) and frequency (f) of alternator.
A 6-pole, 50Hz, 3-φ induction motor is running at 950 r.p.m. and has Cu loss of 5kW. The rotor input is
An 8-pole, 50Hz, three-phase induction motor is running at 705rpm and has a rotor copper loss of 5kW.
A pulse waveform has a high time of 8 ms and a pulse width of 32 ms. The duty - cycle is equal to:
why is it that when the frequency of a voltage in an inductor increases current decreases?
Frequency range of FM broadcasting in India is ...
A 400kW, 3 -phase, 440V, 50Hz induction motor has a speed of 950 rpm on full load. The machine has 6 poles. ...
Two sinusoidal signals of the same frequency are displayed on a dual-trace oscilloscope. One complete cycle
What is the clock cycle time for a system that uses a clock with frequency of 150 kHz?
Why field current has low values when compared to armature current
Define: 1) frequency, 2) cycle, 3) time period, 4) amplitude
Ripple in output current of a step-down chopper feeding RLE load is maximum, when duty cycle is equal to:
A material has conductivity of 10–2 mho/m and relative permittivity of 4. The frequency at which the
A series R-L-C Circuit has a resonant frequency of 1000 Hz. If the values of R, L and C are
What is the frequency of an alternator which has 2 poles and makes 3600 revolutions per minute?
An accelerometer has input range of 0 to 10g, natural frequency 30 Hz and mass 0.001 kg. The range of the
A system has 14 poles and 2 zeros in its open -loop transfer function. The slope of its highest frequency ...
A series RLC circuit has a resonant frequency of 1 KHz and a quality factor Q = 100. If each of the R,L and C...
A Lissajous pattern on an oscilloscope has 5 horizontal tangencies and 2 vertical tangencies. The frequency of...
The eddy current loss in a dc generator is 400 W at 40 Hz frequency of reversal and constant flux density.
Explain construction and working of D.C. servomotor.
Draw and explain working of universal motor. Give two applications of universal motor.
Why there is decrease in supply voltage with increase in drain current in voltage controlled current source circuit using op amp and mosfet?
A silicone diode has a voltage drop of 1.5v and forward d.c current of 150mA. It has a reverse current of 1.2uA and a reverse voltage of 12v. Determine the forward resistance and reverse resistance
A zener voltage regulator has load requirements of 12 V and 2 A. The zener diode minimum current
An ammeter has a current change of 0—5A and its internal resistance is 0.2 ohm. In order to Change the range
DC ammeter has a resistance of 0.1 Ω and its current range is 0-100 A. If the range is to be extended to...
if voltage is 230 Volts , frequency is 50 Hz and current is 1 ampere then what will be the resistance?
Draw and explain star delta starter for 3 phase induction motor
Compare squirrel cage induction motor and slip ring induction motor any four points.
relation between inductor and capacitor
A linear network has a current input 4cos(ω t + 20º)A and a voltage output 10 cos(ωt +110º) V. Determine the associated impedance.
A balanced Delta connected load supplied with 440 V 50 Hz three phase AC supply has R=10 Ohm and L=0.6 mH in is each arm. Calculate line and phase current, active power.
Why the cutoff frequency is taken for 3db?
Why inductance increases with frequency?
why mosfet is used for high frequency?
Will there be infinite energy when we connect electric motor and electric generator to a cycle?
Difference between open and closed cycle gas turbine.
A pulse radar has a pulse repetition frequency (PRF) of 3 KHz. If the radar is emitting at 10 GHz, what is the
A high-pass filter has a resistance R = 2 kΩ The lowest input frequency to be passed is 7.5 kHz. The value of
The loop transfer of a system is G(s) H(s) = 5/(s+1) (2s+1)(3s+1) which has the phase crossover frequency
When a sine wave has a frequency of 100 Hz in 12 s it goes through?
A tuned circuit has a Q of 100 at its resonant frequency of 500 kHz. Its bandwidth is _____kHz.
An OP amp has a slew rate of 1V/µs. At a signal frequency of 0.1 MHz, the maximum undistorted sine wave ...
On chip oscillator of 8051 has a nominal frequency (in MHz) of...
A minimum-phase system with no zeros has a phase-angle of – 270° at gain crossover frequency. The system is_____.