Welcome to electrical and electronics engineering discussion website, Please login or register to continue.

Welcome to electrical and electronics engineering Q&A site...

Join our WhatsApp group

Please log in or register to answer this question.

1 Answer

0 votes
by

Improvement of transient stability using SVC

image

•The static VAR compensator (SVC) is a shunt connected FACTS device.

•SVC have two modes one is inductive mode and second is capacitive mode.

•SVC generates reactive power when the system voltage is low and maintain the power called capacitive mode.

•SVC absorbs reactive power when the system voltage is high and maintain the power called inductive mode.

•SVC are use for regulating transmission voltage and for improving power quality of industrial load.

•SVC is made from one or more banks of switched or fixed capacitor or reactor and thyristor controlled valve.

•SVC is a automatic impedance matching device.

•SVC is connected in parallel with transmission line.

•SVC have no rotating part except internal switchgear.

•SVC is installed at the line ends or at the midpoint transmission system.

•SVC is similar to asynchronous condenser but with no rotating parts.

•The susceptance of SVC is controlled by thyristor valve.

•SVC is use to bring the power factor closer to unity.

•SVC gives instantaneous response to changes in the system.

•Static VAR Compensator is more reliable than dynamic compensation scheme like synchronous condenser.

•SVC is also use for improving transient stability and dampen power swings  and reduce system losses of the system.

•Power system have three states one is steady state second is dynamic state and third is transient state.

•Transient stability is the ability of system to maintain in synchronism when subjected to disturbance.

•Disturbances like sudden change in load or switching or any fault. Since shunt compensation increase the transmittable power.

•Transient stability improvement can be estimated using equal area criterion.

Amazon Shopping

Welcome to Q&A site for electrical and electronics engineering discussion for diploma, B.E./B.Tech, M.E./M.Tech, & PhD study.
If you have a new question please ask in English.
If you want to help this community answer these questions.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase factor resistance load synchronous ac energy induction generator electric frequency series use speed between capacitor meter line electrical type mosfet control transmission difference magnetic plant high single instrument bjt source advantages function diode machine unit winding torque amplifier define supply thyristor motors arduino field shunt relay armature electricity maximum time problem parallel transformers types coil diagram state flow value material on three starting direction method emf operating theorem digital microprocessor test instruments efficiency ratio loss measure operation connected low applications wave effect and single-phase working losses different network wattmeter temperature measuring constant signal controlled breaker device full compare drive wire materials machines inductance switch flux resistivity disadvantages logic converter transistor gain protection scr angle force core measurement number free principle rc generators law negative bridge friction open pole conductor conservation steam iron loop resistors hysteresis short computer lines secondary station battery rectifier inverter linear relays nuclear regulation design using analog work rotor electronics gate forces diesel damping rlc connection factors capacitors minimum insulation basic moving running reactance systems circuits air fault range direct main stability quality starter igbt eddy ideal ammeter rl 3-phase plants arc induced thermal error fuzzy biasing dielectric pressure balanced errors rotation characteristics feedback measured electronic start alternator off back curve over solar three-phase tariff locomotive peak bias zener capacitance commutator surge rating universal potentiometer superposition permanent mechanical copper self transducer capacity electrons memory adc excitation inductive explain fuse pure harmonics application internal pmmc average reaction welding resonance traction breakers designed electromagnetic si generation brushes density switching shaded rate impedance distribution transfer methods star oscillator reluctance semiconductor inductor 8085 weston dynamometer insulating strength installation permeability definition fuel heating earth units neutral rms rated engineering conductors coefficient controller usually reverse excited change body components form made response terminals
...