37 views
in Electrical Engineering by
what are the uses of current transformer ?

Your answer

Thanks for your contribution. Feel free to answer this question. Please avoid short answer. Your answer is most welcome. Be genuine.

Upload image or document:

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
Are you a robot ? (Y = Yes / N = No)
To avoid this verification in future, please log in or register.

1 Answer

0 votes
by

Uses of current transformer are as follows :

A current transformer is use to measure Alternating current.

A current transformer is used in meters.

A current transformer is used in ammeters.

Current transformer is use with compensator.

Current transformer is use in power factor meters.

Current transformer is use in watthour meters.

Current transformer is use with relay.

Current transformer is use with circuit breaker.

Current transformer is use for overcurrent fault protection.

Related questions

1 answer 56 views
2 answers 48 views

The core of a transformer (medium size) uses to provide high flux densities (a) diamagnetic (c) ferromagnetic core (b) paramagnetic (d) none of these

asked Apr 14, 2018 in Electrical Engineering by Shimroz123
1 answer 17 views

What are the uses of Thermistors ?

asked Jul 2 by Shimroz123
1 answer 42 views

what are the uses of MOSFET ?

asked Aug 13, 2017 in Electronics Engineering by Zeeshan
1 answer 38 views

what are the types of cooling systems in transformer?

asked Nov 30, 2017 in Electrical Engineering by Quiz
1 answer 130 views

what are the types of transformer ?

asked Aug 6, 2017 in Electrical Engineering by Zeeshan
0 answers 18 views

What is the clock cycle time for a system that uses a clock with frequency of 150 kHz?  (A) 55 µ sec (B) 5.5 µ sec (C) 202 sec (D) 6.6 µ sec 

asked Apr 5, 2018 in Electrical Engineering by Shimroz123
1 answer 293 views

Computation of branch current uses: A. Kirchhoff's voltage and current laws B. Thevenin's theorem and Ohm's law C. Kirchhoff's current law and Ohm's law D. Superposition theorem and Thevenin's theorem

asked Apr 12, 2018 in Electrical Engineering by Shimroz123
1 answer 28 views

Two light bulbs are connected in series across a 120 V battery. Bulb 1 uses 40 W of power and Bulb 2 uses 20 W of power. If bulb 1 alone is connected to the 120 V source, then it will consume (A) 90 W (B) 80 W (C) 60 W (D) 180 W

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
1 answer 27 views

What is the line current of a circuit when the current transformer of 1000 : 5 rating measures 4 amp? (A) 5000 amp (B) 1000 amp (C) 400 amp (D) 800 amp 

asked Apr 23, 2018 in Instrumentation and control by Shimroz123
2 answers 73 views

 The no-load current drawn by transformer is usually what per cent of the full-load current ?

asked Mar 27, 2018 in Transformer by Shimroz123
1 answer 36 views

what is UPS and what are its uses?

asked Aug 8, 2017 in Power quality by Zeeshan
1 answer 28 views

What are the design constraints of transformer design?

asked Feb 17, 2018 in Unit 3 by Quiz
1 answer 21 views

a single phase full wave midpoint thyristor converter uses a 230/200V transformer with centre tap on the secondary side. The P.I.V per thyristor is   (A) 100V (B)141.4V (C)200V (D)282.8V

asked May 17, 2018 in Power electronics converters by Shimroz123
1 answer 22 views

The kVA rating of Three-phase transformer with Voltage = 200V and Current = 100A will be :  (A) 34.64 kVA (B) 75 kVA (C) 20 kVA (D) None of the above

asked May 8, 2018 in Electrical Engineering by Shimroz123
1 answer 10 views

Eddy current losses in transformer cores can be reduced by the use of  1. Solid cores  2. Laminated cores  3. Ferrites  Select the correct answer using the codes given below : (a) 2 and 3 only (b). 1 and 2 only (c) 1 and 3 only (d) 1, 2 and 3

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
1 answer 19 views

The kVA rating required for a transformer that must handle a maximum load current of 8 A with a secondary voltage of 2 kV will be: A. 4 kVA B. 0.25 kVA C. 16 kVA D. 8 kVA

asked Apr 12, 2018 in Electrical Engineering by Shimroz123
0 answers 13 views

In case of a power transformer, the no load current in terms of rated current is (1) 10-20% (2) 15-30% (3) 2-6% (4) 30-50% 

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
0 answers 21 views

A large transformer operating at no load draws an exciting current Io of 5A, when the primary is connected to a 120 V, 60 Hz source. From a wattmeter test, it is known that iron losses are equal to 180 W. Calculate the reactive power absorbed by the core.  (A) 600 var (B) 572 var (C) 180 var (D) 360 var 

asked Apr 5, 2018 in Electrical Engineering by Shimroz123
1 answer 11 views

Twelve volts are applied across a resistor. A current of 3 mA is measured. What is the value of the resistor? A.4 ohms B.400 ohms C.4 kohms D.4.4 ohms

asked May 15, 2018 in Basic concepts by Shimroz123
0 answers 18 views
1 answer 42 views

At full -load of a transformer, the iron loss and copper loss are 3000 W and 4000 W respectively. Then total loss at maximum efficiency is :  (A) 7000 W (B) 6000 W (C) 8000 W (D) 4000 W

asked Apr 30, 2018 in Electrical Engineering by Shimroz123
1 answer 13 views

What will happen if the primary of a transformer is connected to D.C. supply?  (A) Transformer will operate with low efficiency (B) Transformer will operate with high efficiency (C) No effect (D) Transformer may start to smoke and burn 

asked May 8, 2018 in Electrical Engineering by Shimroz123
1 answer 7 views

What is the moving part of a linear variable differential transformer?  a) Primary c) Secondary b) Diaphragm d) Core

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
1 answer 54 views

What is the basic principle of operation of a transformer?  (A) Self-induction (B) Mutual-induction (C) Static-induction (D) Dynamic-induction 

asked Apr 5, 2018 in Electrical Engineering by Shimroz123
1 answer 13 views

In a three-phase system, when the loads are perfectly balanced, the value of neutral current is equal to: A. Zero B. One-third of the maximum value C. Two -third of the maximum value D. The maximum value

asked Apr 12, 2018 in Electrical Engineering by Shimroz123
0 answers 13 views

If the load current and flux of a DC motor are held constant, and voltage applied across its armature is increased by 10%, its speed will:  (A) Decrease by 10%. (B) Remain unchanged. (C) Increase by 10%. (D) Increase by 20%. 

asked Apr 5, 2018 in Electrical Engineering by Shimroz123
1 answer 24 views

A transformer at 25 Hz develops 20 W hysteresis loss and 50 W eddy current loss. If the applied voltage and frequency are doubled, the new core losses are (A) 140 W (B) 180 W (C) 240 W (D) 480 W

asked Apr 28, 2018 in Electrical Engineering by Shimroz123
1 answer 20 views

The ratio error in current transformer is due to:  (1) Power factor of primary. (2) Wattless component of the current in the primary (3) Exciting current (4) Leakage flux

asked Apr 9, 2018 in Electrical Engineering by Shimroz123
1 answer 15 views

What is the capacitance when a capacitor passes a current of 31.43 mA when supplied with 40 V AC with a frequency of 1000 Hz? A) 0.125 F B) 0.125 μF C) 1257.2 μF D) None of these

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 11 views

A 100 pF capacitor has a maximum charging current of 150 μA.What is the slew rate ? (A) 1.5 V/μs (B) 1.05 V/μs (C) 0.15mV/s (D) 10.5 mV/s

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
1 answer 15 views

The current in a 200 mH coil increases from 2 to 5 A in 0.1 Second. What is rate of change of current? A. 30 A/s B. 20 A/s C. 10 A/s D. none of these

asked Apr 12, 2018 in Electrical Engineering by Shimroz123
1 answer 6 views

What is the value of Inductance of a coil that induces 20 V when the current through the coil changes from 12 to 20 A in 2 seconds? A. 2 H B. 3 H C. 4 H D. 5 H 

asked Apr 12, 2018 in Electrical Engineering by Shimroz123
0 answers 48 views

A 200 V, 50 Hz inductive circuit takes a current of 10 A at 30 degree lagging pf, what is the inductive reactance of the circuit?  (A) 17.8 Ω (B) 100 Ω (C) 178 Ω (D) 10 Ω 

asked Apr 5, 2018 in Electrical Engineering by Shimroz123
0 answers 19 views

What is the nature of supply current in parallel RC circuit with reference to the voltage?  (A) In phase (B) Lags by 90 degree (C) Leads by 90 degree (D) Compensates and becomes zero 

asked Apr 5, 2018 in Electrical Engineering by Shimroz123
0 answers 29 views

What does the maximum Surge current rating of an SCR specify?  (A) Repetitive current with sine wave. (B) Non-repetitive current with rectangular wave. (C) Non-repetitive current with sine wave. (D) Repetitive current with rectangular wave. 

asked Apr 5, 2018 in Electrical Engineering by Shimroz123
1 answer 10 views

What happens when you reverse the direction of the current in an electromagnet?

asked Mar 14, 2018 in Electrical Engineering by Quiz
2 answers 29 views

What is the direction of an AC current?

asked Mar 14, 2018 in Electrical Engineering by Quiz
0 answers 20 views

What is the direction of the induced current?

asked Mar 14, 2018 in Electrical Engineering by Quiz
1 answer 22 views

What is the direction of flow of current?

asked Mar 14, 2018 in Electrical Engineering by Quiz
1 answer 24 views

What is the direction of the conventional current flow?

asked Mar 14, 2018 in Electrical Engineering by Quiz
1 answer 59 views

What is the direction of flow of electric current in an electric circuit?

asked Mar 14, 2018 in Electrical Engineering by Quiz
2 answers 53 views

Velocity of current and motion of current is same or different??

asked Dec 28, 2017 in Electrical Engineering by Marzuk
1 answer 50 views

Laminations in the transformer core are provided to avoid (a) continuous air gap (c) to reduce exiting current (b) to reduce the weight (d) to reduce copper losses

asked Apr 14, 2018 in Electrical Engineering by Shimroz123

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units

8,450 questions

7,047 answers

133 comments

3,086 users

...