# What is the frequency response of a circuit?

60 views
What is the frequency response of a circuit?

## Related questions

What is the best frequency response?

What do you mean by frequency response of an amplifier?

State the need of multistage amplifier. Draw frequency response of R-C coupled amplifier.

A series R-L-C Circuit has a resonant frequency of 1000 Hz. If the values of R, L and C are doubled, the new resonant frequency is

In a series R-C circuit, with the increase in frequency, current (A) Reduces (B) Increases (C) Does not change (D) Becomes zero

In a series RLC high Q circuit, the current peaks at a frequency  (1) equal to the resonant frequency (2) greater than the resonant frequency (3) less than the resonant frequency (4) equal to half the resonant frequency

In a series L-C circuit at the resonant frequency the?

In R-L-C series resonant circuit magnitude of resonance frequency can be changed by changing the value of?

What is the time response of a system whose poles lie on the right hand side of s-plane? A) Exponentially increasing B) Exponentially decreasing C) Sinusoidal oscillations D) Step response

What is the impulse response of the system?

The damping factor of a particular system is unity, the system response will be

What is meant by 3db frequency?

What is DC analysis of a circuit?

A second order system shows 100% overshoot in its unit step response. It can be categorized as (A) underdamped system. (B) overdamped system. (C) Critically damped system. (D) undamped system.

Why the cutoff frequency is taken for 3db?

What is the analog circuit?

A pulse radar has a pulse repetition frequency (PRF) of 3 KHz. If the radar is emitting at 10 GHz, what is the maximum unambiguous range for this radar? A) 5 Km B) 5 m C) 50 Km D) 15 m

What does it mean to analyze a circuit?

The clock frequency of an 8085 microprocessor based system is 3 MHz. What should be the minimum pulse width of the INTR signal so that it is recognized successfully? A) 5.6 µs B) 5.7 µs C) 5.8 µs D) 5.9 µs

What is the frequency range of VHF electromagnetic waves? A) 30-300 kHz B) 30-3000 kHz C) 30-300 MHz D) 30-3000 MHz

What is the frequency of an alternator which has 2 poles and makes 3600 revolutions per minute? A) 3600 HZ B) 60 Hz C) 120 Hz D) None of these

What happens to the voltage in the secondary when the frequency of the supply in the primary is decreased? A) It increases B) It decreases C) It remains the same D) Cannot say unless the actual percentage increase in the frequency is known

The speed of a three-phase induction motor is controlled by variable voltage variable frequency control (i.e. keeping V/f constant). As the frequency is reduced, the slip at maximum torque  (1) Decreases (2) Increases (3) Remains constant (4) None of the above

In a pure capacitive circuit if the supply frequency is reduced to 1/2, the current will?

In a pure inductive circuit if the supply frequency is reduced to 1/2, the current will?

What would happen if a power transformer designed for operation on 50 Hz (frequency) were connected to a 500 Hz (frequency) source of the same voltage:  (A) Eddy Current and Hysteresis losses will be excessive  (B) Current will be too much high  (C) Transformer may start to smoke and burn  (D) No effect

A 4 GHz carrier is amplitude modulated by a low-pass signal of maximum cut off frequency 1 MHz. lf this signal is to be ideally sampled, the minimum sampling frequency should be nearly

For a frequency of 200 Hz, the time period will be?

In a 741 Op-Amp, there is 20 dB/decade fall-off starting at a relatively low frequency. This is due to the (A) applied load (B) internal compensation (C) impedance of the source (D) power dissipation in the chip

Consider a circuit with three parallel branches connected across a DC supply. What is the ratio of the branch currents I1 : I2 : I3 if the branch resistances are in the ratio of 2 : 3 : 4 respectively? A) 2 : 3 : 4 B) 6 : 4 : 3 C) 4 : 3 : 2 D) None of these

What is the use of a thyristor in a circuit?

What is the role of a capacitor in a circuit?

What is the maximum number of circuit breakers in a panel?

What is the purpose of a capacitor in an AC circuit?

The time period of third harmonic of power supply frequency, in milliseconds, is (A) 20 (B) 3.33 (C) 6.66 (D) 60

Two waves have frequency of 500 Hz. One is set at its maximum value whereas the other at zero. The phase angle between them will be

The frequency of an alternating current is?

Two waves of the same frequency have opposite phase when the phase angle between them is?

Is the speed of alternator is directly proportional to frequency?

Operating frequency of power MOSFET is higher than that of power BJT. Justify the statement.

What is the RMS voltage in a series RL circuit, if the voltage across R and L is 256 V and 192 V respectively? A) 320 V B) 448 V C) 64 V D) None of these

For measurement of radio frequency ac signals __________ type meter is used