# Why ACSR conductor is used for overhead lines?

142 views

Why ACSR conductor is used for overhead lines?

–1 vote
It has high tensile strength

## Related questions

A minimum clearance of 6.3 m to ground is required for overhead lines when operating voltages are :  (A) less than 66 kV (B) lie between 66 kV and 110 kV (C) more than 165 kV (D) lie between 110 kV and 165 kV

A 3 layer, total diameter of an ACSR conductor is 5 cm. Find the diameter of each strand?

What is the full form of ACSR?

Why underground service connections are service connections are costly than overhead service connection

Is Aluminium a good conductor of electricity?

The function of steel wire in ACSR conductors is (A) To take care of surges. (B) To reduce corona. (C) To reduce inductance. (D) To provide additional mechanical strength

what is ACSR ?

Define magnetic lines of force. Show the magnetic lines of force for bar type magnet.

Define service connection and state types connection and state types of overhead service connection

lf a travelling-wave travelling along a loss-less overhead line does not result in any reflection after it has reached the far end, then the far end of the line is

The purpose of guard ring in transmission lines is to  (1) reduce the earth capacitance of the lowest unit. (2) increase the earth capacitance of the lowest unit. (3) reduce the transmission lines losses. (4) reduce the reactance of the line

Which of the following is the name given to the lines of electric force which move so that its beginning traces a closed curve on a positive surface and its end traces a corresponding closed curve on the negative surface? A) Tube of surface B) Tube of lines C) Tube of force D) Tube of electricity

What is a safe distance from power lines?

Why DC motor is used for traction?

Define magnetic lines of force. Also draw and show magnetic lines of force of a bar type magnet.

In which of the following transmission lines, the value of the Shunt admittance should be approximated to zero ? (A) A 66 kV 35 km long line (B) A 132 kV 200 km long line (C) A 220 kV 300 km long line (D) A 400 kV 500 km long line

In tuned power lines, on load :  (A) the receiving end voltage is numerically equal to the sending end voltage  (B) the receiving end current is numerically equal to the sending end current  (C) there is no voltage drop  (D) all the above

Corona loss in transmission lines can be reduced by (A) using small diameter conductors (B) using bundled conductors (C) using less spacing between conductors (D) increasing the transmission line voltage

If a 5-bus test system contains 6 transmission lines and one transformer, how many non-zero elements are there in the system Y-bus ? (A) 25 (B) 12 (C) 11 (D) 19

How many volts are in the power lines?

Which is the best conductor: silver, carbon, or iron?

In a metal conductor, what is a free electron?

lf the wire which is vertical to this page has electron flow downwards the conductor will have

When electric current passes through a metallic conductor, its temperature rises. This is due to?

The insulation on a current carrying conductor is provided?

Heat in a conductor is produced on the passage of electric current due to?

If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes?

The resistance of a few meters of wire conductor in closed electrical circuit is?

Current velocity through a copper conductor is

what is conductor ?

How does the resistance of a conductor compare to that of an insulator?

The thickness of insulation provided on the conductor depends on?

The resistance of a conductor varies inversely as?

Why common emitter configuration is commonly used?

Why shunt capacitor is used?

Why capacitor bank is used?

Why fuzzy logic is used?

Which of the following device is used for coupling microwave energy?  A) Resonator B) Waveguide C) Loop D) Antenna

Taskbar is used for (A) Navigation program (B) Switching between program (C) Start a program (D) All of above

A relay used for protection of motors against overload is :  (A) Impedance relay (B) Electromagnetic attraction type (C) Thermal relay (D) Buchholz's relay

Earthing switch is used for?  (A) Measuring of safety voltage (B) Protection of equipment from ground faults (C) Discharging residual energies (D) All of the above

As per Electricity Act, ____________means any line which is used for carrying electricity for any purpose.  (A) Electric line (B) Transmission line (C) All of the above (D) None of the above