# What makes an electromagnet stronger than a solenoid?

12 views
What makes an electromagnet stronger than a solenoid?

## Related questions

What are three ways you can increase the strength of an electromagnet?

What happens when you reverse the direction of the current in an electromagnet?

What is permanent magnet and electromagnet?

State any two applications of electromagnet.

What is the frequency of an alternator which has 2 poles and makes 3600 revolutions per minute? A) 3600 HZ B) 60 Hz C) 120 Hz D) None of these

What is the energy stored in the magnetic field at a solenoid of 40 cm long and 4 cm diameter wound with 100 turns of wire carrying a current at 20A?  (A) 0.705 Joule (B) 0.789 Joule (C) 0.587 Joule (D) 0.658 Joule

If an energy meter disc makes 10 revolutions in 100 seconds when a load of 450W is connected to it, the meter constant in revolutions per kWh is  A) 1000 B) 500 C) 1600 D) 800

An energy meter has a constant of 600 rev/kWh. If the meter makes 10 revolutions in 20 s, what is the load in kW?  (A) 0.75 kW (B) 1.5 kW (C) 3 kW (D) 6 kW

What is the power factor when a single phase watt meter operating on 200 V and 5 A for 5 hours makes 2016 revolutions and the meter constant in revolution is 420? A) 0.04 B) 1.04 C) 0.96 D) None of these

An open-loop system is better than a closed-loop system in terms of   (a) Accuracy (b) Stability (c) Noise reduction (d) Sensitivity

A ferrite core has less eddy current loss than an iron core because?

Composition is a stronger form of which of the following?  (1) Aggregation (2) Encapsulation (3) Inheritance (4) All of the above.

What is solenoid valve ? Explain its working with the help of diagram.

One single-phase energy meter operating on 230 V and 5 A for 5 hours makes 1940 revolutions. Meter constant is 400 rev/kWh. The power factor of the load is

A meter whose constant is 600 revolutions/kWh makes 5 revolutions in 20 seconds. Calculate the load in kW. (1) 0.5 kW (2) 1 kW (3) 1.5 kW (4) 2 kW

A centre zero ammeters connected in the rotor circuit of a 6-pole 50 Hz induction motor makes 30 oscillations in one minute. The rotor speed is

For applications requiring speed ratio other than 2 : 1, the speed control of an induction motor can be effected by varying the number of stator poles employing  (1) multiple stator winding (2) pole amplitude modulation technique (3) consequent pole technique (4) Any of these

An FET is a better chopper than a BJT because it has (A) lower offset voltage (B) higher series ON resistance (C) lower input current (D) higher input impedance

Which of the following applies to a class rather than an object?  (1) Query (2) Scope (3) Update (4) Constructor

The inductance of a long solenoid of length 1000 mm wound uniformly with 3000 turns on a cylindrical paper tube of 60 mm diameter is  (A) 3.2 µH (B) 3.2 mH (C) 32.0 mH (D) 3.2 H

A power system is subjected to a fault which makes the zero sequence component of current equal to zero. The nature of fault current is: A) Double line to ground fault B) Line to line fault C) Line to ground fault D) Three-phase to ground fault

The disc of a single phase Induction-type energy meter makes 60 revolutions in 6 minutes. Meter Constant is 1200 rev/kWh. Power consumption in the load is (A) 1.2 kW (B) 1 kW (C) 600 W (D) 500 W

In river crossing, hilly terrain, modern HV lines have span more than (a) 50 m (c) 500 m (b) 100 m (d) 800 m

If a forward voltage (less than forward breakover voltage) is suddenly applied across anode and cathode of a thyristor, it may result into   (a) Damage to the thyristor (b) Premature triggering of the thyristor because of high dV/dt (c) Reduced holding current of the thyristor (d) All of the above

Which type of timing violation will occur, If a digital IC is operated at clock frequency which is higher than its specified maximum clock frequency?  A) Hold violation B) Setup Violation C) Propagation delay D) All of above

When the initial slope of input sine wave is greater than the slew rate of an OPAMP, the output: (1) Has no offset (2) Approaches to triangular waveshape (3) Is pure sinusoidal (4) Is square wave

A 50Ω transmission line is terminated in an impedance of 20-j50. What will be the reflection coefficient? A) 0.69 B) 1.69 C) 6.9 D) 16.9

What happens to the reluctance of a magnetic circuit, when an air gap is introduced to the core cross section ? (A) Decreases (B) Increases (C) Remain same (D) None of the above

What is the purpose of providing a fuse in an electric circuit?  (A) To safe guard the installation against heavy current (B) To reduce the current flowing in the circuit (C) To reduce the power consumption (D) To improve power factor

What is the difference between an anode and a cathode?

What is the difference between a coil and an inductor?

Draw the symbol and state the applications of : 1) Push button switch 2) Selector switch 3) Solenoid valve 4) Limit switch

Write one application of each: i) Permanent Magnet ii) Electromagnet

Auto-transformer makes effective saving on copper and copper losses, when its transformation ratio is?

The leakage current must not be more than ____________ of maximum supply current

Branch circuit must not feed more than __________ points

Digital modulation can withstand channel noise and distortion better than analog schemes (a) as long as the channel noise is within limits (b) for any noise (c) for thermal noise only (d) statement is not true

Materials having electrical conductivity much less than most of the metals but much greater than that of typical insulators, are known as A. Thermistors B. Varistors C. Semi-conductors D. Variable resistors.

In 3-phase induction motors, speeds higher than synchronous speed can be had by  (1) line voltage control (2) rotor slip power control (3) rotor resistance control [4) frequency control

In terms of cost, overhead transmission line is better than underground transmission line in the field of   (a) Insulation (b) Right of way (c) Visibility (d) None of these