# What will happen if you increase the current in the motor?

47 views
What will happen if you increase the current in the motor?

Increasing current means increasing frequency of the motor because current is directly proportional to rotations of the motor rotor

## Related questions

1 answer 106 views

Why does increase in current mean a decrease in voltage?

1 answer 18 views
1 answer 27 views

How can we increase the induced current?

1 answer 20 views
1 answer 178 views
0 answers 18 views

What are three ways you can increase the strength of an electromagnet?

1 answer 28 views
1 answer 36 views

A 200 V dc shunt motor is running at 1000 rpm and drawing a current of 10 A. Its armature winding resistance is 2 Ohm. It. is braked by plugging. The resistance to be connected in series with armature to restrict armature current to 10 A, is

1 answer 16 views
1 answer 46 views
1 answer 41 views

In an induction motor if the flux density is reduced to one-half, of its normal value then the torque will  (1) reduce to one-half (2) reduce to one-fourth (3) remain unchanged (4) increase four times

1 answer 22 views
1 answer 145 views

what will happen when excitation of an unloaded salient pole synchronous motor suddenly gets disconnected?

1 answer 26 views

For given applied voltage, with the increase in frequency of the applied voltage?

1 answer 16 views
1 answer 540 views

Reduction in core losses and increase in permeability are obtained with transformer employing?

1 answer 15 views

Why does induction motor have high starting current?

1 answer 30 views
1 answer 10 views

What happens when you reverse the direction of the current in an electromagnet?

1 answer 16 views
1 answer 20 views

A change of 4% in the supply voltage to an induction motor will produce a change of approximately

1 answer 21 views
1 answer 18 views
1 answer 22 views
1 answer 14 views

In a series R-C circuit, with the increase in frequency, current (A) Reduces (B) Increases (C) Does not change (D) Becomes zero

1 answer 17 views
1 answer 78 views

If the base current of a BJT is 250 µA and emitter current is 15 mA, then the common base current gain will be A) 0.98 B) 0.41 C) 59 D) 55

1 answer 40 views

If the % reactance upto the fault point is 20%, then the short circuit current will be

1 answer 14 views

If the fault current is 2000 A, the relay setting is 50% and CT ratio is 400:5, the plug setting multiplier will be

1 answer 11 views

If the current in the armature of do series motor is reduced to 5%, the torque of the motor will become: (1) 50% of the previous value (2) 25% of the previous value (3) 150% of the previous value (4) 125% of the previous value

1 answer 14 views
0 answers 32 views

What will happen if a voltmeter is connected like an ammeter in series of the load ? (a) The meter will burn out. (b) The measurement will be too high. (c) The same current will flow as would have been with ammeter in circuit. (d) There will be almost no current in the circuit.

2 answers 34 views
1 answer 33 views
1 answer 221 views
1 answer 29 views
1 answer 21 views

Torque developed by a three-phase, 400V, induction motor is 100 N -m. If the applied voltage is reduced to 200-V, the d'veloped torque will be

1 answer 21 views
1 answer 13 views
1 answer 17 views
1 answer 15 views
1 answer 26 views
1 answer 26 views
1 answer 20 views
1 answer 18 views

If we change the excitation of synchronous machine will it affect on motor speed?

1 answer 28 views

If the load of the normally excited synchronous motor is increased the power factor will?

1 answer 22 views

If the field of synchronous motor is under excited, power factor will be?

1 answer 15 views

In parallel RLC resonance circuit at resonance the current will be  (1) Minimum (2) Maximum (3) Zero (4) Infinite

1 answer 160 views
1 answer 11 views