33 views
in Electronics Engineering by
Which capacitor is used for high frequency?

Related questions

1 answer 55 views

Which of the following thyristors can be used for high frequency of operation? A) TRIAC B) DIAC C) SCR D) GTO 

asked Jun 18, 2018 in Thyristor by Shimroz123
0 answers 17 views

Why shunt capacitor is used?

asked Mar 15, 2018 in Electronics Engineering by Quiz
0 answers 82 views

Why capacitor bank is used?

asked Mar 15, 2018 in Electronics Engineering by Quiz
1 answer 103 views

Which of the following can be used to measure the capacitance of a capacitor? A) Rheostat B) Schering bridge C) Wheatstone bridge D) None of these

asked Apr 29, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 19 views

Which rotor is use for high speed in turbo alternators?

asked Mar 18, 2018 in Alternator by Shimroz123
0 answers 27 views

Which side of a capacitor is negative?

asked Mar 15, 2018 in Electronics Engineering by Quiz
1 answer 50 views

Which of the following device is used for coupling microwave energy?  A) Resonator B) Waveguide C) Loop D) Antenna

asked Jun 18, 2018 in Electronics Engineering by Shimroz123
1 answer 53 views
1 answer 25 views

The reactance offered by a capacitor to alternating current of frequency 50 Hz is 20 Q. If frequency is increased to 100 Hz, reactance becomes_____ohms.

asked Mar 24, 2018 in Electrical Engineering by Shimroz123
1 answer 13 views

Which of the following oscillators is used for generation of high frequency signal ? (a) RC phase shift oscillator (b) Blocking oscillator (c) Wein bridge oscillator (d) L-C oscillator 

asked May 26, 2018 in Electronics Engineering by Shimroz123
2 answers 147 views

Why high voltage is used in power transmission?

asked Mar 10, 2018 in High voltage engineering by Quiz
1 answer 72 views

The number of cycles in which a high speed circuit breaker can complete its operation is  (A) 3 to 8 (B) 10 to 18 (C) 20 to 30 (D) 40 to 50

asked May 8, 2018 in Switchgear And Protection by Shimroz123
1 answer 21 views

In a series RLC high Q circuit, the current peaks at a frequency  (1) equal to the resonant frequency (2) greater than the resonant frequency (3) less than the resonant frequency (4) equal to half the resonant frequency

asked Apr 29, 2018 in Network Analysis by Shimroz123
0 answers 21 views

Which energy is stored in capacitor?

asked Mar 10, 2018 in Analog electronics circuits by Quiz
0 answers 18 views

What is the role of a capacitor in a circuit?

asked Mar 15, 2018 in Electronics Engineering by Quiz
0 answers 21 views

What is the basic use of capacitor?

asked Mar 15, 2018 in Electronics Engineering by Quiz
0 answers 17 views

What is the basic function of a capacitor?

asked Mar 15, 2018 in Electronics Engineering by Quiz
0 answers 21 views

What is the direction of flow when charging a capacitor?

asked Mar 15, 2018 in Electronics Engineering by Quiz
0 answers 57 views

What is the symbol of a capacitor?

asked Mar 15, 2018 in Electronics Engineering by Quiz
0 answers 58 views

How do you know when a capacitor is bad?

asked Mar 15, 2018 in Electronics Engineering by Quiz
1 answer 23 views

For a DC circuit capacitor is

asked May 8, 2018 in Electrical Engineering by Shimroz123
1 answer 36 views

Which of the following circuit breakers has high reliability & minimum maintenance?  (A) Bulk oil type CB (B) Air blast CB (C) Vacuum CB (D) Sulphur hexafluoride CB 

asked May 8, 2018 in Switchgear And Protection by Shimroz123
1 answer 30 views

Which type of ADC gives high resolution?

asked May 4, 2018 in Digital Instrumentation by Shimroz123
1 answer 34 views

What is the frequency of an alternator which has 2 poles and makes 3600 revolutions per minute? A) 3600 HZ B) 60 Hz C) 120 Hz D) None of these

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 25 views

The device which allows reverse power flow and withstands highest switch frequency is (A) GTO (B) MOSFET (C) IGBT (D) Inverter grade SCR

asked Apr 28, 2018 in Power Electronics by Shimroz123
1 answer 21 views

Name two methods for measurement of low, medium and high resistance. Give one advantage and one limitation of V- I method.

asked Sep 6, 2018 by Shimroz123
1 answer 29 views

For high efficiency of transfer of power, internal resistance of the source should be?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 21 views

Wire-wound resistors are unsuitable for use at high frequencies because they?

asked Mar 25, 2018 in Electrical Engineering by Shimroz123
1 answer 343 views

What is the frequency range of VHF electromagnetic waves? A) 30-300 kHz B) 30-3000 kHz C) 30-300 MHz D) 30-3000 MHz

asked Jun 18, 2018 in Electronics Engineering by Shimroz123
1 answer 31 views

A 4 GHz carrier is amplitude modulated by a low-pass signal of maximum cut off frequency 1 MHz. lf this signal is to be ideally sampled, the minimum sampling frequency should be nearly

asked Apr 26, 2018 in Electronics Engineering by Shimroz123
1 answer 31 views

In a 741 Op-Amp, there is 20 dB/decade fall-off starting at a relatively low frequency. This is due to the (A) applied load (B) internal compensation (C) impedance of the source (D) power dissipation in the chip

asked Apr 26, 2018 in Electronics Engineering by Shimroz123
1 answer 8 views

As per Electricity Act, ____________means any line which is used for carrying electricity for any purpose.  (A) Electric line (B) Transmission line (C) All of the above (D) None of the above

asked May 8, 2018 in Electrical Engineering by Shimroz123
1 answer 21 views

Which of the following is used for thermoelectric cooling? A) Peltier effect B) Seebeck effect C) Both A and B D) None of these

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 22 views

Phantom loading for testing of energy meter is used (A) to isolate the current and potential circuits (B) to increase power loss during testing (C) for meters having low current ratings (D) to test meters having a large current rating for which loads may not be available

asked Apr 28, 2018 in Electronics Engineering by Shimroz123
1 answer 11 views

A Hartley Oscillator is used for generating (A) very low frequency Oscillation (B) radio-frequency Oscillation (C) microwave Oscillation (D) audio-frequency Oscillation

asked Apr 26, 2018 in Electronics Engineering by Shimroz123
0 answers 23 views

What are the characteristics of a capacitor?

asked Mar 15, 2018 in Electronics Engineering by Quiz
0 answers 11 views

How do you discharge a capacitor in a microwave?

asked Mar 15, 2018 in Electronics Engineering by Quiz
1 answer 46 views

How do you charge a capacitor with a battery?

asked Mar 15, 2018 in Electronics Engineering by Quiz
0 answers 27 views

How do I discharge a capacitor?

asked Mar 15, 2018 in Electronics Engineering by Quiz

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units
...