# Which winding in a transformer has more number of turns ?

18 views

High voltage winding in a transformer has more number of turns.

## Related questions

Increasing the number of turns of wire on the secondary of a transformer will  (A) Decrease the secondary current (B) Increase the primary current (C) Have no effect on the secondary current (D) Increase the secondary current

A certain transformer has 200 turns in the primary winding, 50 turns in the secondary winding and 120 volts applied to the primary. What is the voltage across the secondary?  (A) 30 Volts (B) 480 Volts (C) 120 Volts (D) 60 Volts

lt the length, number of turns and area of a coil are  doubled, the inductance of the coil

If a transformer is switched on to a voltage more than the rated voltage?

In a given transformer for a given applied voltage, losses which remain constant irrespective of load changes are?

Turns ratio

A single-phase transformer has a turns ratio of 1 :2 and is connected to a purely resistive load as shown in the figure. The magnetizing current drawn is 1A, and the secondary current is 1A. Ifcore losses and leakage reactances are neglected, the primary current is  A)1.41A B)2A C) 2.24A D)3A

A certain transformer has 400 turns in the primary winding and 2,000 turns in the secondary winding. The turns ratio is? A.0.2 B.0.4 C.5 D.25

If a transformer has 50 turns in the primary winding and 10 turns in the secondary winding, what is the reflective resistance if the secondary load resistance is 250 ohms? A.250 ohms B.25 ohms C.6,250 ohms D.62,500 ohms

In a step-down transformer, there is a change of 15 A in the load current. This results in change of supply current of?

The path of magnetic flux in a transformer should have?

The changes in the volume of transformer cooling oil due to the variation of atmospheric temperature during day and night is taken care of by which part of the transformer?

Part of the transformer which is most subject to damage from overheating is?

In a transformer the resistance between its primary and secondary should be?

If a transformer is continuously operated the maximum temperature rise will occur in?

The hum in a transformer is mainly attributed to?