Can you help by answering this question?

What is the analog circuit?

22 views
in Switchgear And Protection by

Your answer

Thanks for your contribution. Feel free to answer this question. Please avoid short answer. Your answer is most welcome. Be genuine.

Upload image or document:

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
Are you a robot ? (Y = Yes / N = No)
To avoid this verification in future, please log in or register.

1 Answer

0 votes
by

In a circuit breaker the basic problem is to transmit large power.

Related questions

1 answer 73 views

The number of cycles in which a high speed circuit breaker can complete its operation is  (A) 3 to 8 (B) 10 to 18 (C) 20 to 30 (D) 40 to 50

asked May 8, 2018 in Switchgear And Protection by Shimroz123
1 answer 26 views

A circuit breaker is designed to protect an electrical circuit from damage caused by :  (A) Over load (B) Short circuit (C) Over current (D) All of the above

asked May 8, 2018 in Switchgear And Protection by Shimroz123
1 answer 22 views

ln a minimum oil circuit breaker the oil is used

asked Apr 26, 2018 in Switchgear And Protection by Shimroz123
1 answer 21 views

The arc temperature in Oil Circuit Breaker may reach up to_______.  (A) 5,000° K (B) 8,000° K (C) 10,000° K (D) None of the above

asked May 8, 2018 in Switchgear And Protection by Shimroz123
1 answer 34 views

The Minimum Oil Circuit Breaker (MOCB) is named because of :  (A) Reduced requirement of oil (B) Reduced requirement of air (C) All of the above (D) None of the above

asked May 8, 2018 in Switchgear And Protection by Shimroz123
1 answer 25 views

For selecting a circuit breaker, ______ should be determined.  (A) initial current that flows on occurrence of a short circuit only (B) transient current that flows at the time of circuit interruption only (C) resonant frequency only (D) (A) and (B) 

asked Apr 30, 2018 in Switchgear And Protection by Shimroz123
1 answer 25 views

what is SF6 circuit breaker?

asked Dec 4, 2017 in Switchgear And Protection by Quiz
1 answer 14 views

The arc voltage in a circuit breaker is :

asked Apr 29, 2018 in Utilization of electrical energy by Shimroz123
1 answer 28 views

Which of the following is used in a circuit breaker as the medium in which the arc forms? A) Insulating gas B) Insulating oil C) Vacuum D) All the above

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 31 views

Breaking capacity of a circuit breaker is usually expressed in terms of  (1) Ampere (2) Volts (3) MW (4) MVA

asked Apr 30, 2018 in Electrical Engineering by Shimroz123
1 answer 668 views

basic gate drive circuit of GTO

asked Nov 14, 2017 in Power Electronics by Quiz
1 answer 86 views

State function of starter and ELCB. (Earth Leakage Circuit Breaker)

asked Sep 18, 2018 in Industry Electrical Systems-I by Shimroz123
0 answers 17 views

What is the basic function of a capacitor?

asked Mar 15, 2018 in Electronics Engineering by Quiz
0 answers 42 views

Explain the basic dual slope ADC technique used in digital multimeters with its diagram and measurement cycle.

asked Mar 2, 2018 in Digital Instrumentation by Quiz
0 answers 39 views

Explain the basic operation of an oscilloscope with necessary diagram for each section in detail.

asked Mar 2, 2018 in Digital Instrumentation by Quiz
0 answers 22 views

What is the basic use of capacitor?

asked Mar 15, 2018 in Electronics Engineering by Quiz
0 answers 13 views

What is basic insulation level?

asked Mar 10, 2018 in High voltage engineering by Quiz
0 answers 25 views

What are the four basic welding positions?

asked Mar 11, 2018 in Utilization of electrical energy by Quiz
0 answers 30 views

What are the basic laws of physics?

asked Mar 11, 2018 in Physics by Quiz
1 answer 24 views

Describe the basic SHA operation with the help of its four mode specifications.

asked Mar 2, 2018 in Digital Instrumentation by Quiz
1 answer 24 views

The power flow problem mathematical model for a linear transmission network (A) is non-linear (B) is linear (C) considers time variation of generation (D) does not consider tap-changing transformers

asked Apr 28, 2018 in Power system by Shimroz123
1 answer 15 views

Electrical quantities (symbol and basic unit)

asked Jun 29 by Shimroz123
1 answer 15 views

Basic SI units

asked May 16 by Shimroz123
6 answers 109 views

1.Determine the permeability of magnetic material by plotting its BH curve 2. Measure voltage, current and power in 1-phase circuit with resistive load. 3. Measure voltage, current and power in R-L series circuit. 4.Determine the transformation ratio (K) of 1-phase transformer. 5.Connect single phase transformer and measure input and output quantities. 6.Make Star and Delta connection in induction motor starters and measure the line and phase values.

asked Aug 28, 2018 in Basic electrical and electronics engineering by Zeeshan
1 answer 15 views
1 answer 135 views

In a pure capacitive circuit if the supply frequency is reduced to 1/2, the current will?

asked Mar 25, 2018 in Electrical Engineering by Shimroz123
1 answer 47 views

In a pure inductive circuit if the supply frequency is reduced to 1/2, the current will?

asked Mar 25, 2018 in Electrical Engineering by Shimroz123
1 answer 17 views

Time constant of a circuit is the time in seconds taken after the application of voltage to each?

asked Mar 25, 2018 in Electrical Engineering by Shimroz123
1 answer 21 views

In which fault the maximum short circuit current occurs?

asked Mar 19, 2018 in Switchgear And Protection by Shimroz123
1 answer 19 views

Series and parallel capacitor problem

asked May 21 by Shimroz123
1 answer 13 views

Problem on capacitor

asked May 21 by Shimroz123
1 answer 10 views

Problem on temperature coefficient of resistance 3

asked May 20 by Shimroz123
1 answer 10 views

Problem on temperature coefficient of resistance 2

asked May 20 by Shimroz123
1 answer 13 views

Problem on temperature coefficient of resistance 1

asked May 19 by Shimroz123
1 answer 8 views

Problem on resistance and resistivity 13

asked May 19 by Shimroz123
1 answer 7 views

Problem on resistance and resistivity 12

asked May 19 by Shimroz123

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units

8,471 questions

7,069 answers

134 comments

3,088 users

...