# Starting winding of a single phase motor of a refrigerator is disconnected from the circuit by means of a?

22 views

Starting winding of a single phase motor of a refrigerator is disconnected from the circuit by means of a magnetic relay.

## Related questions

The running winding of a single phase motor on testing with meggar is found to be ground. Most probable location of the ground will be?

How is a three phase cage induction motor self starting?

explain the working of single phase induction motor.

A capacitor-start single phase induction motor is switched on to supply with its capacitor replaced by an inductor of equivalent reactance value. It will?

How does a single phase induction motor work?

Single Phase Induction Motor

What is the slip (as a percentage) when a 6 pole single phase induction motor operating on 220 V and 60 Hz is rotating at speed of 1140 rpm? A) 60% B) 5% C) 10% D) None of these

Describe the gate circuit for a single phase full converter.

An unexcited single phase synchronous motor is ?

Explain power in single phase AC circuit.

what will happen when excitation of an unloaded salient pole synchronous motor suddenly gets disconnected?

In a double squirrel cage induction motor, good starting torque is produced as (A) Large current flows through the outer high resistance winding. (B) Large current flows through the inner high resistance winding. (C) Small current flows through the outer high resistance winding. (D) Large current flows through the inner low resistance winding.

What are the five types of single phase motors used in the industry?

A 200 V dc shunt motor is running at 1000 rpm and drawing a current of 10 A. Its armature winding resistance is 2 Ohm. It. is braked by plugging. The resistance to be connected in series with armature to restrict armature current to 10 A, is

Is induction motor is self starting?

A switch tail ring counter is made by using a single D-FF. The resulting circuit is (A) T-FF (B) D-FF (C) SR-FF (D) JK-FF

A synchronous motor can be made self starting by providing?

A single core cable is designed to work for a single phase system with a peak voltage of 220 kV. The maximum permissible stress in the dielectric is not to exceed 20 kV/mm. For economical size, the overall core diameter of the cable is (A) 28.2 mm (B) 26.4 mm (C) 24.4 mm (D) 22.0 mm

The disc of a single phase Induction-type energy meter makes 60 revolutions in 6 minutes. Meter Constant is 1200 rev/kWh. Power consumption in the load is (A) 1.2 kW (B) 1 kW (C) 600 W (D) 500 W

The potential coil of a single phase dynamometer wattmeter has 4840 Ohm resistance. Voltage across the load is 220 V. With the potential coil connected on the load side, the meter indicates 100 W. Approximate percentage error due to wattmeter connection is (A) 11% (B) 9% (C) 1.1% (D) 3%

Damper winding in a synchronous motor

In synchronous motor, does the winding losses vary with load?

What is the power factor when a single phase watt meter operating on 200 V and 5 A for 5 hours makes 2016 revolutions and the meter constant in revolution is 420? A) 0.04 B) 1.04 C) 0.96 D) None of these