# After the starting winding of a single phase induction motor is disconnected from supply, it continues to run only on?

32 views

After the starting winding of a single phase induction motor is disconnected from supply, it continues to run only on running winding.

Here we not disconnect whole IM we only disconnect auxiliary winding and thus it start works only on main winding.
by
Reason is kinetic energy

## Related questions

A capacitor-start single phase induction motor is switched on to supply with its capacitor replaced by an inductor of equivalent reactance value. It will?

What is the slip (as a percentage) when a 6 pole single phase induction motor operating on 220 V and 60 Hz is rotating at speed of 1140 rpm? A) 60% B) 5% C) 10% D) None of these

explain the working of single phase induction motor.

How does a single phase induction motor work?

Single Phase Induction Motor

The running winding of a single phase motor on testing with meggar is found to be ground. Most probable location of the ground will be?

A change of 4% in the supply voltage to an induction motor will produce a change of approximately

How is a three phase cage induction motor self starting?

The slip of 400 V, three phase, 4 -pole induction motor when rotating at 1440 rpm is

speed control methods of three phase induction motor?

What is mean by plugging in three phase induction motor?

Split phase induction motor

In a single-phase induction motor when the rotor is stationary and voltage is applied to the stator, then (A) the flux is constant (B) the flux first decreases and then increases in the same direction (C) the flux increases and decreases in the opposite direction with the same magnitude (D) current flows through the rotor

An unexcited single phase synchronous motor is ?

how can we reverse the direction of rotation of three phase induction motor ?

A 400 V, 50 Hz three-phase induction motor rotates at 1440 rpm on full -load. The motor is wound for

In a three-phase supply floating neutral is undesirable because it way give rise to?

Torque developed by a three-phase, 400V, induction motor is 100 N -m. If the applied voltage is reduced to 200-V, the d'veloped torque will be

The disc of a single phase Induction-type energy meter makes 60 revolutions in 6 minutes. Meter Constant is 1200 rev/kWh. Power consumption in the load is (A) 1.2 kW (B) 1 kW (C) 600 W (D) 500 W

In a double squirrel cage induction motor, good starting torque is produced as (A) Large current flows through the outer high resistance winding. (B) Large current flows through the inner high resistance winding. (C) Small current flows through the outer high resistance winding. (D) Large current flows through the inner low resistance winding.

what will happen when excitation of an unloaded salient pole synchronous motor suddenly gets disconnected?

The speed of a three-phase induction motor is controlled by variable voltage variable frequency control (i.e. keeping V/f constant). As the frequency is reduced, the slip at maximum torque  (1) Decreases (2) Increases (3) Remains constant (4) None of the above

In a single-phase induction motor, the operating direction is determined by the ________ A) Rotor B) Stator C) Starting circuit D) None of these

What is the power factor when a single phase watt meter operating on 200 V and 5 A for 5 hours makes 2016 revolutions and the meter constant in revolution is 420? A) 0.04 B) 1.04 C) 0.96 D) None of these

Is induction motor is self starting?

A single core cable is designed to work for a single phase system with a peak voltage of 220 kV. The maximum permissible stress in the dielectric is not to exceed 20 kV/mm. For economical size, the overall core diameter of the cable is (A) 28.2 mm (B) 26.4 mm (C) 24.4 mm (D) 22.0 mm

An 8-pole, 50Hz, three-phase induction motor is running at 705rpm and has a rotor copper loss of 5kW. Its rotor input is (A) 5.06 kW (B) 0.3 kW (C) 100 kW (D) 83.33 kW

In a split-phase induction motor, the resistance/reactance ratios of windings are such that (A) current in the auxiliary winding leads the current in the main winding (B) current in the auxiliary winding lags the current in the main winding (C) both windings develop the same starting torque (D) both windings develop high starting current

A 3-phase, 4-pole, 50Hz induction motor runs at a speed of 1440 rpm. The rotating field produced by the rotor rotates at a speed of ________ rpm with respect to stator field. (A) 1500 (B) 0 (C) 1440 (D) 60