111 views
in Electrical Measurements and Instrumentation by

1 Answer

0 votes
by

Meggar is an instrument which measures the insulation resistance of an electric circuit relative to earth and one another.

Related questions

1 answer 16 views

Name the method used to measure following resistances:- (i) Low resistance (ii) Medium resistance (iii) Insulation resistance (iv) Earth resistance.

asked Sep 6, 2018 by Shimroz123
1 answer 17 views

A PMMC instrument has FSD of 100 μA and a coil resistance of 1 kΩ. To convert the instrument into an ammeter with full scale deflection of 100 mA, the required shunt resistance is (A) 1 Ω (B) 1.001 Ω (C) 0.5 Ω (D) 10 Ω

asked Apr 28, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 20 views

kWh meter is the electric meter that measures the amount of electrical _________ in kWh that was consumed in the house.  (A) Energy (B) Current (C) Voltage (D) None of the above

asked May 8, 2018 in Electrical Engineering by Shimroz123
1 answer 26 views

When measuring insulation resistance of cables using d.c. source, the galvanometer used should be initially short circuited because  (A) Cables have a low value of capacitance which draws a high value of charging current (B) Cables have a low value of initial resistance (C) Cables have a high value of capacitance which draws a high value of charging current (D) Cables have a low value of capacitance and initial resistance

asked Apr 28, 2018 in Electrical Measurements and Instrumentation by Shimroz123
1 answer 18 views

An instrument which detects electric current is known as?

asked Mar 25, 2018 in Basic concepts by Shimroz123
0 answers 18 views

What is an insulation resistance test?

asked Mar 10, 2018 in High voltage engineering by Quiz
1 answer 10 views

Write any two factors on which earth resistance depends.

asked Sep 6, 2018 by Shimroz123
1 answer 59 views

If the insulation resistance of a cable of length 10 km is 1 mega ohm, its insulation resistance for 50 km length will be

asked May 8, 2018 in Electric Power Transmission by Shimroz123
1 answer 86 views

State function of starter and ELCB. (Earth Leakage Circuit Breaker)

asked Sep 18, 2018 in Industry Electrical Systems-I by Shimroz123
0 answers 25 views

What is the lowest acceptable insulation resistance for a cable?

asked Mar 10, 2018 in High voltage engineering by Quiz
1 answer 13 views

Identify the correct combination of respective Electric arc welding and Electric resistance welding methods :  (A) Butt welding and Seam welding  (B) Hydrogen shielding and Projection welding  (C) Seam welding and Coated electrode welding  (D) Coated electrode welding and Hydrogen shielding

asked Apr 30, 2018 in Utilization of electrical energy by Shimroz123
1 answer 59 views

What is the direction of flow of electric current in an electric circuit?

asked Mar 14, 2018 in Electrical Engineering by Quiz
0 answers 9 views

List three important characteristics of an electric circuit.

asked Jun 29 by Shimroz123
3 answers 31 views

Compare electric and magnetic circuit.

asked Aug 8, 2018 by Quiz
1 answer 26 views

Draw a typical electric circuit including ammeter and voltmeter.

asked Aug 8, 2018 by Quiz
1 answer 27 views

The resistance of a few meters of wire conductor in closed electrical circuit is?

asked Mar 25, 2018 in Basic concepts by Shimroz123
1 answer 19 views

Electric current passing through the circuit produces?

asked Mar 25, 2018 in Basic concepts by Shimroz123
1 answer 14 views

A Pyrheliometer is an instrument to measure :  (A) temperature of solar photovoltaic cell  (B) intensity of direct solar radiation at normal incidence  (C) intensity of indirect solar radiation  (D) efficiency of a solar photovoltaic cell

asked Apr 29, 2018 in Electrical Measurements and Instrumentation by Shimroz123
0 answers 27 views

A star circuit has element of resistance R/2. The equivalent delta elements will be?

asked Mar 25, 2018 in Network Analysis by Shimroz123
1 answer 32 views

An electric motor in which both stator field and rotor rotates with same speed is called?

asked Mar 18, 2018 in Synchronous machine by Shimroz123
1 answer 73 views

I am a new student of electrical and electronic engineering, and facing some problems on sign related, kvl as well as mesh current analysis. By getting solution of these problems, I may get rid of these problems. For figure 4, please just write the seven mesh equations only, solution is not needed.

asked Jul 28, 2018 by foysal shadhin
1 answer 19 views

A lightening arrester connected between the line and earth in a power system  (1) protects the terminal equipment against travelling surges (2) protects the transmission line against direct lightening strokes (3) suppresses high frequency oscillations in the line (4) reflects back the travelling wave approaching it

asked Apr 29, 2018 in Switchgear And Protection by Shimroz123
1 answer 25 views

An _____________is a network of electrical components used to supply, transfer and use electric power:  (A) Electric power system (B) Electric power (C) All of the above (D) None of the above

asked May 8, 2018 in Power system by Shimroz123
2 answers 19 views

State various effects of electric current and explain any one.

asked Sep 4, 2018 by Shimroz123
2 answers 3 views

State working principle of earth tester.

asked Sep 6, 2018 by Shimroz123
0 answers 25 views
1 answer 14 views

A d.c. source has an open circuit voltage of 30 V and an internal resistance of 1.5 Ohm. A resistive load is connected to the source. Maximum power dissipated in the load is (A) 300 W (B) 150 W (C) 45 W (D) 20 W

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
1 answer 14 views

Which of the following is the name given to the lines of electric force which move so that its beginning traces a closed curve on a positive surface and its end traces a corresponding closed curve on the negative surface? A) Tube of surface B) Tube of lines C) Tube of force D) Tube of electricity

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 24 views

The ability of materials to become polarized under an applied electric field is called _______ A) Ferroelectricity B) Paraelectricity C) Polectricity D) None of these

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 33 views

In a 3-phase converter circuit during commutation when one SCR in one phase is turned on to turn-off an SCR in another phase, results in (A) voltage notching (B) harmonic distortion (C) voltage sag (D) voltage swell

asked Apr 28, 2018 in Electronics Engineering by Shimroz123
0 answers 30 views

A cable has an insulation of relative permittivity 2. If the insulation is replaced by one of relative permittivity 4, then capacitance of the cable (a) is doubled (b) is halved (c) remains unchanged (d) is reduced 

asked May 25, 2018 in Physics by Shimroz123
1 answer 15 views

The thickness of insulation provided on the conductor depends on?

asked Mar 25, 2018 in Basic concepts by Shimroz123
1 answer 65 views

The largest change of input quantity for which there is no output of instrument is called ______ A) Dead time B) Dead input C) Dead output D) Dead zone

asked Apr 29, 2018 in Electrical Engineering by Shimroz123
1 answer 18 views

The insulation on a current carrying conductor is provided?

asked Mar 25, 2018 in Basic concepts by Shimroz123
0 answers 20 views

What is double or reinforced insulation?

asked Mar 10, 2018 in High voltage engineering by Quiz
0 answers 13 views

What is basic insulation level?

asked Mar 10, 2018 in High voltage engineering by Quiz
1 answer 26 views

In a PMMC instrument, the damping provided is :  (A) air damping (C) eddy current damping (B) fluid damping (D) magnetic damping using a magnet

asked Apr 29, 2018 in Electrical Measurements and Instrumentation by Shimroz123

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units
...