# Murray loop test can be used for location of?

20 views

Murray loop test can be used for location of both the ground fault and the short-circuit fault.

## Related questions

If the area of hysteresis loop of a material is large, the hysteresis loss in this material will be?

Define- (i) Node (ii) Loop for a DC circuit

What are the disadvantages of Open loop control system?

Explain the hysteresis loop of a magnetic material with neat diagram.

The number of loop equations required to completely analysing a network comprising of 8 independent branches and 6 nodes including the reference node shall be A) 3 B) 2 C) 4 D) 5

What will happen to the gain margin if the gain of the open loop system is doubled? A) Doubled B) Becomes half C) Is not affected D) Becomes one-fourth

If the gain of the open loop system is doubled, the gain margin  (1) Is not affected (2) Gets doubled (3) Becomes half (4) Becomes one -forth

What are some examples of a closed loop system?

What is an example of an open loop system?

What are the advantages of open loop control system?

During open circuit test of a transformer?

Explain how sinusoidal AC voltage is generated by using simple one loop generator.

Which waves are demodulated by Costas loop? A) VSB B) SSB C) MSK D) DSBSC

What is the difference between a mesh and a loop?

what is open loop and close loop control system?

Slip test is performed to determine :  (A) Slip in an induction motor  (B) Xd and Xq in a salient pole alternator  (C) Synchronous impedance in an alternator  (D) Positive and negative sequence impedances of an alternator

If a 5-bus test system contains 6 transmission lines and one transformer, how many non-zero elements are there in the system Y-bus ? (A) 25 (B) 12 (C) 11 (D) 19

An open-circuit test on a transformer is conducted primarily to measure?

A no-load test is performed on a transformer to determine?

Sumpner's test is conducted on transformer to determine?

How do you test a capacitor with a multimeter?

How do we test a diode?

How do you test a triac?

How do you test an SCR?

Why high voltage test is done?

What is an insulation resistance test?

What is a high voltage test?

Which of the following instruments can be used for measurement of very high value resistances such as insulation resistance in industries? A) Wheatstone bridge B) Megger C) Ohm-meter D) Resistive potentiometer

Varley loop tests are preferred over Murray loop tests because  (1) Valley loop test can locate open circuit fault (2) Varley loop test gives higher accuracy (3) in Varley loop test provision is made for the measurement of total loop resistance instead of obtaining it from the relation R = pl/a (4) Valley loop test can locate the earth fault

Which of the following can be used to measure the capacitance of a capacitor? A) Rheostat B) Schering bridge C) Wheatstone bridge D) None of these

Which of the following instruments can be used to measure AC current only? (a) Permanent Magnet Type ammeter(b) Induction type ammeter (c) Moving iron voltmeter(d) Moving iron ammeter

A VTVM can be used to measure (a) dc voltage only (b) ac voltage only (c) both (a) and (b) (d) None of the above

After drawing the Root-Locus, the closed-loop poles corresponding to a specified value of gain K can be determined from which of the following criterion ? (A) Magnitude criterion alone (B) Angle criterion alone (C) Both Magnitude and Angle criteria (D) Angle of departure and angle of arrival.