Can you help by answering this question?

Q- meter is based on characteristics of

18 views
in Electric Traction by

1 Answer

0 votes
by

In case of steam engines the steam pressure is 10 to 15 kgf/cm2.

Related questions

1 answer 23 views

With a neat diagram, explain back pressure steam turbine co-generation system.

asked Sep 23, 2018 in Energy Conservation And Audit by Shimroz123
1 answer 10 views

State the different types of engines in diesel power plant.

asked Sep 7, 2018 by Shimroz123
1 answer 13 views

Auto reclosing is used in case of

asked May 3, 2018 in Switchgear And Protection by Shimroz123
1 answer 13 views

In the case of direct current?

asked Mar 25, 2018 in Basic concepts by Shimroz123
1 answer 4 views

Write the functions of re-heater in steam plant.

asked Sep 7, 2018 by Shimroz123
1 answer 23 views

While keeping the excitation constant, if the steam supply of an alternator running in parallel with another identical alternator is increased, then (A) It would over-run the other alternator (B) Its rotor will fall back in phase with respect to the other machine (C) Its portion of share in load will increase (D) Its power factor would be decreased.

asked Apr 28, 2018 in Electrical Machine by Shimroz123
1 answer 25 views

If a suspended body is struck at the center of percussion, then the pressure on die axis passing through the point of suspension will be?

asked Mar 22, 2018 in Engineering Mechanics by Shimroz123
0 answers 57 views

What is the working principle of pressure transmitter?

asked Mar 11, 2018 in Transducers and sensors by Quiz
1 answer 13 views

The rankine cycle efficiency of steam power plant is  (1) 60-80% (3) 30-45% (2) 45-80% (4) 20-30%

asked Apr 29, 2018 in Electric Power Generation by Shimroz123
2 answers 7 views

List the four different units of pressure.

asked Sep 8, 2018 by Shimroz123
1 answer 10 views

The pressure and velocity at the throat of a Venturi tube, measuring the flow of a liquid, are related to the upstream pressure and velocity, respectively, as follows: (A) Pressure is lower but velocity is higher (B) Pressure is higher but velocity is lower (C) Both pressure and velocity are lower (D) Pressure and velocity are identical

asked Apr 26, 2018 in Electronics Engineering by Shimroz123
1 answer 9 views

Distinguish between fire tube and water tube boilers in steam power plant.

asked Sep 7, 2018 by Shimroz123
1 answer 17 views

In steam turbine terminology, diaphragm refers to  (1) separating wall between rotors carrying nozzles (2) the ring of guide blades between rotors (3) a partition between low and high pressure sides (4) the flange connecting the turbine exit to the condenser

asked Apr 29, 2018 in Electric Power Generation by Shimroz123
1 answer 36 views

A piezo-electric type pressure sensor has a sensitivity of 1 mV/kPa and a bandwidth of 300 Hz to 300 kHz. For a constant (dc) pressure of 100 kPa, the steady state output of the sensor in millivolt is (A) 0 (B) 2 (C) 4 (D) 6

asked Apr 26, 2018 in Electronics Engineering by Shimroz123
1 answer 7 views

Electric pressure is also called?

asked Mar 25, 2018 in Basic concepts by Shimroz123
1 answer 40 views

With neat diagram explain the following terms: (i) Steam turbine co-generation system (ii) Gas turbine co-generation system

asked Sep 22, 2018 in Energy Conservation And Audit by Shimroz123
1 answer 2 views

What are the steam prime movers?

asked Sep 7, 2018 by Shimroz123
1 answer 4 views

List four electric pressure transducer.

asked Sep 8, 2018 by Shimroz123
1 answer 30 views

 Overall thermal efficiency of a steam power station in India is in the range: A) 18-24 percent B) 30-40 percent C) 44-62 percent D) 68-79 percent

asked Jun 17, 2018 in Electric Power Generation by Shimroz123
1 answer 22 views

The steam input in to a turbogenerator connected to infinite bus is increased. Which of the events will take place? (a) The generator will feed more leading KVAR to bus bar and power angle will not change (b) The generator will feed more real power to bus bar and power angle will increase (c) The generator will feed more power to bus bar and power angle will decrease (d) The generator will feed more lagging KVAR to bus bar and power angle will not change

asked Apr 25, 2018 in Electrical Engineering by Shimroz123
1 answer 75 views

What is the value of susceptibility in case of vacuum? A) 1 B) 0.5 C) ∞ D) 0 

asked Jun 18, 2018 in Electrical Engineering by Shimroz123
1 answer 10 views

Which of the following statements is not valid in case of conductors in electrostatic fields? A) The static electric field intensity inside a conductor is zero B) The static electric field intensity at the surface of a conductor is everywhere directed normal to the surface C) The conductor surface is an equivalent potential surface D) None of the above

asked Jun 17, 2018 in Electrical Engineering by Shimroz123
1 answer 48 views

 In case of semi-conductors, the ratio of conduction current to displacement current is: A) more than 200 and less than 1000 B) less than 100 but greater than 1/100 C) less than 1/100 D) more than 1000

asked Jun 4, 2018 in Semiconductor by Shimroz123
1 answer 164 views

 The load-flow solution is always assured in case of: A) Newton-Raphson method B) Gauss-Seidel method C) Fast Decoupled method D) None of these methods guarantee

asked Jun 4, 2018 in Numerical methods and programming by Shimroz123
0 answers 33 views

In case of load flow analysis one of the system buses is taken as swing bus (a) as reference bus (b) to compensate the system losses (c) both (a) and (b) (d) to reduce the system losses 

asked May 25, 2018 in Power system by Shimroz123
1 answer 16 views

Out of the followings, which one is correct in case of a circuit breaker? (1) Making capacity = 2.55 X braking capacity (2) Braking capacity = 2.55 X making capacity (3) Making capacity = 1.8 X braking capacity (4) Braking capacity = 1.8 X making capacity

asked May 22, 2018 in Circuit breaker by Shimroz123
1 answer 8 views

In case of split phase motor, the phase shift between currents in the two windings is around  A) 30° B) 70° C) 90° D) 120°

asked May 17, 2018 in Electrical Machine by Shimroz123
1 answer 13 views

In a transformer, low voltage winding is placed near the core in case of concentric windings so as to  1. Reduce the leakage flux 2. Reduce the insulation requirement 3. Reduce the risk of voltage shock in case of insulation breakdown 4. Reduce the core loss   From these, the correct answer is (a) 1, 2, 3 (b) 2, 3, 4 (c) 1, 2, 3, 4 (d) 2, 3

asked May 13, 2018 in Transformer by Shimroz123
1 answer 13 views

In case of a 3-phase short-circuit fault in a system, the power fed into the system is   (a) Mostly reactive (b) Reactive only (c) Mostly active (d) Active and Reactive both equal 

asked May 13, 2018 in Electrical Engineering by Shimroz123
1 answer 14 views

Zero-sequence current is used for relaying purpose only in the case of   (a) Phase over current relay (b) Phase impedance relay (c) Ground over current relay (d) Ground impedance relay

asked May 13, 2018 in Switchgear And Protection by Shimroz123
1 answer 70 views

In case the height of transmission tower is increased, which of the following parameter is likely to change?  (A) Resistance (B) Inductance (C) Capacitance (D) None of the above

asked May 8, 2018 in Electric Power Transmission by Shimroz123
0 answers 17 views

In case of open circuited transmission lines the reflection coefficient is given by (A) 1 (B) -1 (C) 0.5 (D) 0

asked Apr 14, 2018 in Electrical Engineering by Shimroz123
0 answers 13 views

In case of a power transformer, the no load current in terms of rated current is (1) 10-20% (2) 15-30% (3) 2-6% (4) 30-50% 

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
0 answers 9 views

The staring torque in case of centrifugal pumps is generally (1) Less than running torque (2) Same as running torque (3) Slightly more than running torque (4) Double the running torque 

asked Apr 11, 2018 in Electrical Engineering by Shimroz123
0 answers 17 views

The goodness of an algorithm is most often expressed in terms of its  (1) Best Case complexity (2) Average Case complexity (3) Worst Case complexity (4) Random case complexity

asked Apr 10, 2018 in Computer Engineering by Shimroz123

Welcome to electronics2electrical.com here you can ask questions related to electrical, electronics, mechanical, telecommunication, instrumentation, computer, mathematics, physics etc.
Be respectful to all the members. Do not copy and paste the answers from other websites which have copyright content. While asking question give full details about it.

Categories

Most popular tags

power motor dc circuit transformer voltage current used system phase resistance factor synchronous load ac energy induction electric generator series frequency between speed capacitor use electrical meter line difference control type mosfet transmission magnetic plant high single instrument bjt unit source advantages function diode and machine winding field define torque parallel amplifier supply shunt thyristor motors electricity arduino maximum time relay armature problem value on transformers types coil diagram state flow ratio material three formula starting direction theorem method emf operating efficiency digital wave microprocessor test instruments inductance loss measure operation connected signal low applications effect single-phase network temperature working constant losses different law wattmeter measuring compare controlled breaker drive device logic rc full switch flux wire resistivity disadvantages free of materials machines angle force converter conductor transistor gain open protection scr core measurement number bridge principle generators reactance circuits negative the friction iron loop short pole battery conservation steam resistors hysteresis computer using analog lines secondary station gate a rectifier inverter linear induced relays nuclear capacitance basic characteristics design direct work rotor electronics ammeter forces diesel damping rlc connection factors capacitors minimum insulation moving regulation running self systems air fault range main stability quality starter igbt eddy alternator ideal rl average 3-phase plants arc thermal error fuzzy biasing dielectric pressure balanced superposition errors copper rotation feedback impedance measured electronic electrons charge inductive transfer explain start off back curve over solar is three-phase tariff locomotive peak bias zener engineering commutator surge conductors rating universal potentiometer density permanent mechanical transducer capacity memory adc excitation two fuse pure harmonics application semiconductor inductor internal pmmc reaction welding resonance traction permeability breakers rms designed electromagnetic si generation brushes switching capacitive shaded rate 1 distribution resistor methods delta star oscillator reluctance simplification algebra 8085 boolean weston dynamometer insulating strength installation definition fuel heating earth units

8,450 questions

7,047 answers

132 comments

3,084 users

...