# For given maximum axle load tractive efforts of AC. locomotive will be?

25 views

For given maximum axle load tractive efforts of AC. locomotive will be more than that of D.C. locomotive.

## Related questions

Explain series switching control of AC load. Single phase resistance load - Integral half cycle control Phase control - Resistance load

For a transformer, operating at constant load current, maximum efficiency will occur at?

The load duration curve for unity load factor will be of  (1) Rectangular shape (2) Triangular shape (3) L -shape (4) I -shape

In a given transformer for a given applied voltage, losses which remain constant irrespective of load changes are?

The maximum constant load torque under which a synchronous motor will pull into synchronism at rated rotor supply voltage and frequency is known as?

The synchronous motor will develop maximum power when the load angle is?

A single-phase voltage source square -wave inverter feeds pure inductive load. The waveform of the load current will be

How does electric locomotive work?

Is a train a locomotive?

What is locomotive force?

The SCR would be turned OFF by voltage reversal of applied anode-cathode ac supply frequency of A) 10 kHz B) 10 Hz C) 5 kHz D) 5 Hz

If the load of the normally excited synchronous motor is increased the power factor will?

A parallel AC. circuit in resonance will?

Total instantaneous power supplied by a 3-phase ac supply to a balanced R-L load is

Power station having Load factor = 70%, capacity factor = 50%, used factor = 60%, maximum demand = 20MW then annual energy production is  (1) 122.8 GWh (2) 198.55 GWh (3) 128.2 GWh (4) 188.82 GWh

The maximum load that a power transformer can carry is limited by its?

For measurement of radio frequency ac signals __________ type meter is used

Explain the pulse width modulation technique for control of AC output voltage.

A balanced Delta connected load supplied with 440 V 50 Hz three phase AC supply has R=10 Ohm and L=0.6 mH in is each arm. Calculate line and phase current, active power.

The efficiency of two identical transformers under load conditions can be determined by?

What is the symbol for AC power?

Why dc series motor should not be started at no load?

What is the need of polarity marking in polyphase AC circuits?

UNIT 1 fundamentals of AC rotating machine Contents 1.1 Introduction 1.2 Advantages 1.3 Parts of AC machines 1.4 Synchronous speed 1.5 AC winding 1.6 Winding factor (Coil pitch and distributed winding) 1.7 Distribution factor 1.8 EMF equation of alternator or generator 1.9 Numericals 1.10 Harmonic 1.11 Slot harmonics 1.12 Harmonics minimization

Draw the waveform of three phase AC supply voltage.

An AC supply of 230 V is applied to a half-wave rectifier circuit through a transformer having primary to secondary turn’s ratio 12:1. The peak inverse voltage is A) 8.62 V B) 12 V C) 19.17 V D) 27.11 V

The main advantage of AC over DC is:  (A) Conversion flexibility from one voltage level to other (B) AC can be easily converted into DC by using a rectifier (C) AC is easy to maintain & can be easily distributed at long distances (D) All of the above

The ac bypassing of RF by CF in a common emitter configuration :  (A) increases ac signal across emitter -base junction (B) decreases ac signal across emitter -base junction (C) decreases voltage amplification (D) stabilizes the Q -point

Which of the following motors can run on both AC and DC? A) Universal motor B) Dual wattage motor C) Flexible motor D) All the above

The direction of rotation of an inverter fed 3-phase ac motor is reversed by (A) a mechanical reversing switch (B) reversing the input dc link voltage (C) operating the inverter as a rectifier (D) changing the sequence of switching

In an AC. circuit, a low value of kVAR compared with kW indicates?

What are the parts of AC motor?

What is the principle of AC motor?